Chief CTA-111 - Manual
Chief CTA-111 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – IMPORTANT WARNINGS and CAUTIONS!; not follow the corresponding instructions.
- Page 3 – CONTENTS; Table 1. Shipping Contents; PARTS
- Page 4 – Figure 2. Install Stud Spanning Adapters; INSTRUCTIONS; Installing Top Stud Spanning Adapter to Wall; WARNING; five times
- Page 5 – Figure 3. Attach Chief Wall Arm to Bottom Stud; NOTE; before
- Page 6 – Locate front cover and four M4 x 8mm Phillips head cap; NOTES; Install the front cover using four M4 8mm Phillips head
I N S T A L L A T I O N I N S T R U C T I O N S
CHIEF MANUFACTURING INC.
8809-000024 (Rev. B)
1-800-582-6480
952-894-6280 FAX 952-894-6918
2007 Chief Manufacturing
8401 EAGLE CREEK PARKWAY, STE. 700
SAVAGE, MINNESOTA 55378 USA
03/07
CTA-111
Dual Stud Adapter
BEFORE YOU BEGIN
CAUTION: To prevent damage to your equipment, which could affect or void the Factory warranty,
thoroughly study all instructions and illustrations before you begin to install the CTA-111. Pay particular
attention to the Warnings and Cautions in this document.
If you have any questions about this installation, contact Chief Manufacturing at 1-800-582-6480 or 952-582-6480.
The CTA-111 Dual Stud Adapter provides a 16”-on-
center mounting solution for the following wall arm:
CTA-025 Single Stud Wall Arm
The CTA-111 has a maximum weight capacity of
300 lbs. (136.1 kg).
CTA-111 Dual Stud Adapter
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installation Instructions CTA-111 2 IMPORTANT WARNINGS and CAUTIONS! WARNING A WARNING alerts you to the possibility of serious injury or death if you do notfollow the instructions. CAUTION A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresp...
Installation Instructions CTA-111 3 CONTENTS INSPECT THE UNIT BEFORE INSTALLING ............. 3PARTS .......................................................................... 3TOOLS REQUIRED FOR INSTALLATION................. 4INSTRUCTIONS........................................................... 4...
Installation Instructions CTA-111 4 TOOLS REQUIRED FORINSTALLATION The tools required for installation are as follows: Electric drill and bit set Stud sensor (mechanical or electronic) ½” box-end wrench or ratchet with ½” socket 13mm box-end wrench or ratchet with 13mm socket Level NOTE: Other tools...
