Chief JWDSK - Manuals - manualsarea.com

Page 2 - DISCLAIMER; Tighten Fastener

JWDSK Series Installation Instructions 2 DISCLAIMER Milestone AV Technologies, Inc., and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers ...

Page 3 - TOOLS REQUIRED FOR INSTALLATION AND PARTS; Kit

Installation Instructions JWDSK Series 3 TOOLS REQUIRED FOR INSTALLATION AND PARTS TOGGLER Ă x1 I/M (3/16") 1/2" (Ø13mm) F (4) C (4) (5/32") Interface Bracket Kit (Including Hardware) x 1 B (2) E (4) 3/16" G (1) A (1) D (4) (1/4"-20 x 1-3/4") (1/4") (1/4"-20 SNAP TOGG...

Page 4 - Site Requirements; Figure 1

JWDSK Series Installation Instructions 4 Site Requirements WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum requirements for installation of display mounts onto a steel stud structure. If the ...

Page 5 - MOUNT INSTALLATION; Figure 2

Installation Instructions JWDSK Series 5 MOUNT INSTALLATION After determining the site meets the installation requirements:1. Identify desired mounting location on wall. 2. Using a stud finder or similar method locate studs. 3. Align mounting holes in mount with studs making sure mounting holes are ...

Page 6 - Figure 5; Display Installation

JWDSK Series Installation Instructions 6 Figure 5 11. Place mount over anchors and align mounting holes in display mount with holes in anchors. (See Figure 6) 12. Place flat washer (E) onto Phillips pan head screws (D).13. Insert 1/4-20 x 1-3/4" Phillips pan head screw (D) with flat washer (E) t...

Page 7 - Figure 7; CABLE MANAGEMENT; Figure 9; ADJUSTMENTS; Swing Arm

Installation Instructions JWDSK Series 7 Figure 7 2. Align two screws in display back with upper teardrop mounting holes in mounting plate. 3. Place two screws in display back into upper teardrop mounting holes in display mounting plate and lower display until screws are seated in lower area of tear...

Page 8 - Adjust display Roll, Pitch, and YAW tension; Lower

JWDSK Series Installation Instructions 8 Adjust display Roll, Pitch, and YAW tension 1. Disconnect all wires and cable from the display. 2. Remove two Lower screws securing display to Centris cup. 3. Loosen two Upper screws securing display. 4. Lift display upward and away from mount. 5. Using a hex...

Page 12 - 008 Milestone AV Technologies; Europe; Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands; Asia Pacific

JWDSK Series Installation Instructions Chief Manufacturing, a division of Milestone AV Technologies, Inc. 8832-000220 RevC © 2008 Milestone AV Technologies www.chiefmfg.com 06/08 USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.691...