Chief PAC-500 - Manual
Chief PAC-500 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Instructions; IMPORTANT WARNINGS AND CAUTIONS!; corresponding instructions.; DIMENSIONS
- Page 3 – TOOLS REQUIRED FOR INSTALLATION
- Page 4 – INSTALLATION AND ASSEMBLY; OPEN WALL; outside; FRAME HOUSING; Figure 3: Frame Housing
- Page 5 – INSTALL HOUSING; Figure 4: Install Housing
- Page 6 – Figure 6: Attach Upper Bracket; inner
- Page 7 – Figure 11: Install PNR Mount; INSTALL DISPLAY; See instructions that came with MWR/PWR/PNR
I N S T A L L A T I O N I N S T R U C T I O N S
CHIEF MANUFACTURING INC.
1-800-582-6480
952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA
8800-000058 Rev E
2007 Chief Manufacturing
06/07
BEFORE YOU BEGIN
LARGE FLAT PANEL IN WALL ENCLOSURE
Model: PAC-500
Specifications:
•
Designed for in-wall installation spanning a
minimum of 3 wood studs, 16" on center.
•
Accomodates MWR, PWR and PNR swing arm
mounts.
•
Cutouts provided for single gang electrical box
and grommet hole for audio/video cables.
•
Weight capacity of 200 lbs (90 kg).
NOTE: Shown with PNR mount installed; MWR/PWR
mount similar (mount not included).
WARNING:
It is the installer’s responsibility to make sure all components are properly assembled and installed
using the instructions provided. Failure to read, thoroughly understand, and follow all instructions can result in
serious personal injury, damage to equipment, or voiding of factory warranty.
•
If you have any questions about this these instructions or your specific installation, contact Chief Manufacturing
at 1-800-582-6480 or 952-894-6280.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Model: PAC-500 Installation Instructions 2 IMPORTANT WARNINGS AND CAUTIONS! WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow t...
Installation Instructions Model: PAC-500 3 TOOLS REQUIRED FOR INSTALLATION • Stud Sensor • Level • Saw • Tape Measure • Screwdriver (for wood screws) • 9/16" Wrench • 3/16" Hex Key (provided) • 4mm Hex Key (provided) • 4mm Hex Bit (provided) NOTE: Other tools may be required depending on you...
Model: PAC-500 Installation Instructions 4 INSTALLATION AND ASSEMBLY The following instructions are applicable to: • Three 2x4 studs, 16" on center; other installationsare possible with increased framing complexity. • MWR/PWR (single swing arm) and PNR (doubleswing arm) mounts. OPEN WALL 1. Dete...
