Chauvet 86 - Manual

3. Setup 6 1/6/2010 10:35 AM 3. S ETUP AC Power This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage to which you are connecting it is within the range of accepted voltages. Always connect the fixture to a switched circuit. Never connect the fixture to ...

3. Setup 7 1/6/2010 10:35 AM Mounting Bracket Mounting Orientation The DIAMONDsplash ™ 86 may be mounted in any safe position, provided there is adequate room for ventilation. Rigging Be sure that the structure can support the weight of the fixture. Please see the “Technical Specifications” section ...

4. Operating Instructions 8 1/6/2010 10:35 AM 4. O PERATING I NSTRUCTIONS Configuring the Starting Address Each fixture requires a starting address from 1~512. A fixture requiring one or more channels for control begins to read the data on the channel indicated by the starting address. For example, ...

4. Operating Instructions 9 1/6/2010 10:35 AM Sound-Active This fixture has a sound-triggered mode. This is accessed via the DIP switches on the back of the fixture, and the sensitivity may be adjusted using the audio sensitivity adjustment knob. Please see the chart below for further explanation. M...

5. Appendix 10 1/6/2010 10:35 AM 5. A PPENDIX DMX Primer There are 512 channels in a DMX connection. Channels may be assigned in any manner. A fixture capable of receiving DMX will require one or a number of sequential channels. The user must assign a starting address on the fixture that indicates t...

5. Appendix 11 1/6/2010 10:35 AM Data Cabling To link fixtures together you must obtain data cables. You can purchase CHAUVET® certified DMX cables directly from a dealer/distributor or construct your own cable. If you choose to create your own cable please use data-grade cables that can carry a hig...

5. Appendix 12 1/6/2010 10:35 AM This drawing provides a general illustration of the DMX input/output panel of a lighting fixture. Universal DMX Controller Continue the link 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX output connector, you will need to use a 5-pin to 3-p...

5. Appendix 13 1/6/2010 10:35 AM Setting the Starting Address This DMX mode enables the use of a universal DMX controller device. Each fixture requires a start address from 1~512. A fixture requiring one or more channels for control begins to read the data on the channel indicated by the start addre...

5. Appendix 14 1/6/2010 10:35 AM Returns Procedure Returned merchandise must be sent prepaid and in the original packing; call tags will not be issued. Package must be clearly labeled with a Return Merchandize Authorization Number (RMA #). Products returned without the RMA # will be refused. Call CH...

Technical Specifications 15 1/6/2010 10:35 AM Technical Specifications WEIGHT & DIMENSIONS Length .......................................................................................................................... 4.9 in (124 mm) Width.........................................................