Page 2 - Contents
Contents 1 1. Safety and operating instructions ___________________________ 2 2. Installation and hook-up___________________________________ 5 3. Description of the controls _________________________________ 9 4. Operating instructions ___________________________________ 14 5. Cleaning and maintenan...
Page 3 - Safety instructions; Safety and operating instructions
Safety instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QU...
Page 4 - EUROPEAN; WEEE
Safety instructions 3 OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC...
Page 6 - Installation instructions; Water supply connection
Installation instructions 5 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source...
Page 7 - supplied with the
Installation instructions 6 CONNECTING TO THE WATER SUPPLY Connect the intake hose to a cold water supply with ¾” gas thread, inserting the filter A supplied with the dishwasher. Take care to screw the hose firmly into place with your hands and then complete by tightening about ¼ of a turn with plie...
Page 8 - Electrical connection and precautions; IN THE EVENT OF DAMAGE TO THE SUPPLY CORD; IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD:; QUALIFIED TECHNICIAN
Installation instructions 7 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SA...
Page 9 - User instructions; FOR GREAT BRITAIN ONLY:; THIS APPLIANCE MUST BE EARTHED.; Fuse replacement
User instructions 8 FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse ...
Page 10 - Description of the controls; SETTING THE WASHING PROGRAM AND SWITCHING ON
User instructions 9 3. Description of the controls 3.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switch-on, programming, switch-off etc. procedures are only possible when the door is open. 1 ON/OFF BUTTON Pressing this button energises the appliance. 2 SELECTED PROGRAM ...
Page 11 - PROGRAM; Only
User instructions 10 After using the table to identify the most appropriate washing program: • press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate; • keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illum...
Page 12 - Washing programs; Before starting a washing program make sure that:; PROGRAM DELAY
User instructions 11 3.2 Washing programs Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baskets have been correctly loaded. • The spray arms are able to rotate freely and without obstruction....
Page 13 - CANCELLING THE CURRENT PROGRAM; button for a few seconds; indicator lights; for programs; CHANGING THE PROGRAM; Always try to run the dishwasher fully loaded.
User instructions 12 CANCELLING THE CURRENT PROGRAM • To cancel the currently selected program, open the door and hold down the PROGRAM SELECTION (3) button for a few seconds until the indicator lights for programs 4 and 5 illuminate simultaneously (the word "end" is displayed on the window)...
Page 14 - END OF CYCLE
User instructions 13 If the door has to be opened while washing is in progress, the program will be interrupted. The relative light will keep flashing and a beeper will signal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the...
Page 15 - Operating instructions; Adjust the water softening system; Using the water softening system; 0 washing cycles; container can hold approximately
User instructions 14 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the ...
Page 17 - WATER HARDNESS TABLE; WATER HARDNESS; Using the rinse aid and detergent dispensers
User instructions 16 WATER HARDNESS TABLE WATER HARDNESS German Degrees (°dH) French Degrees (°dF) SETTING 0 - 4 0 - 7 Setting N. 1 NO SALT 5 - 15 8 - 25 Setting N. 1 16 - 23 26 - 40 Setting N. 2 24 - 31 41 - 60 Setting N. 3 32 - 47 61 - 80 Setting N. 4 48 - 58 81 - 100 Setting N. 5 Contact your loc...
Page 18 - ADDING THE RINSE AID; Rotate the container cap anticlockwise by 1⁄4 of a turn and remove it.; ADJUSTING THE RINSE AID DISPENSER SETTING
User instructions 17 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: • Open the ...
Page 19 - ADDING THE DETERGENT; . Add the detergent and close the cap
User instructions 18 ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P . Add the detergent and close the cap carefully. During the washing cycle, the dispenser will be opened automatically. • When a program with hot prewash is selected (see program table), extra de...
Page 20 - General warnings and recommendations
User instructions 19 • "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dishwasher is fitted with the "3/1 option button" on the "Controls description" page and then refer to the section which explains how to use this f...
Page 22 - Using the baskets; The dishwasher has a capacity of; LOWER BASKET; With fixed supports; LOADING THE LOWER BASKET
User instructions 21 4.4 Using the baskets The dishwasher has a capacity of 10 place-settings , including serving dishes. LOWER BASKET The lower basket receives the full force of the lower spray arm, and should therefore be used for the “toughest” items with a heavier degree of soiling. All types an...
Page 23 - The cutlery basket features an; Vertical
User instructions 22 CUTLERY BASKET The cutlery should be arranged in an orderly manner inside the basket, with the handles pointing downwards. Take care during loading to avoid injury from the knife blades. The basket is suitable for all types of cutlery, except those long enough to interfere with ...
Page 24 - LOADING THE UPPER BASKET
User instructions 23 LOADING THE UPPER BASKET Load plates facing forward; cups, bowls etc. must always be facing downwards. The left-hand side of the basket can be loaded with two layers of cups and glasses. On the right plates and saucers can be slotted verticalli into the forks. Loading examples: ...
Page 25 - Cleaning and maintenance; General warnings and recommendations; Avoid the use of acidic or abrasive detergents.
User instructions 24 5. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and...
Page 26 - CLEANING THE SPRAY ARM, TRAVELLING VERSION
User instructions 25 CLEANING THE SPRAY ARM, TRAVELLING VERSION To remove the TRAVELLING spray arm, take hold of it and raise it to release both the spray arm and the pipe from the tank, then detach the spray arm from the pipe. Wash both the pipe and the spray arm in running water, re-attach the spr...
Page 28 - If the dishes are not being cleaned properly, check that:
User instructions 27 If the dishes are not being cleaned properly, check that: • the correct amount of detergent has been added; • there is regenerating salt inside the special container; • the dishes are being loaded correctly; • the selected program is suitable for the dish types and their degree ...
Page 30 - FAULT; Light off
User instructions 29 FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only) The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and s...
Page 31 - TECHNICAL DATA; 0 Standard place settings; Water supply pressure; See rating plate
User instructions 30 TECHNICAL DATA Width 447 ÷ 449 mm Depth measured flush with the outer edge of the control panel 550 mm Height from 820 mm to 890 mm Capacity 10 Standard place settings Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) Electrical characteristics See rating pl...
Page 32 - a doprowadzaj cego wod lub; mm; MIN; in
19 570 0079 00 SX DX 3/4” min.10mm 3/4” 1/2” SW 32 MIN 40cm Cu ø10 Zet hem op één lijn met de bovenste rand van hetdurpaneel.Alinear respecto del borde superior del panel puerta.Alinhe com a borda superior do painel da porta. Allineare al bordo superiore del pannello porta.Align with the top edge of...
