CDA WC430 - Manual

Softener Adjustment The efficiency of your dishwasher depends on the softness of the tap water. To ensure best efficiency, the dishwasher is equipped with a system that reduces the hardness in the mains water supply. The efficiency will increase when the system is correctly set. To find out the wate...

Rinse Aid To fill the rinse aid compartment 1. Open the rinse aid compartment by turning and removing the cap as shown in figure 4. 2. Fill the rinse aid compartment until the rinse aid indicator goes dark, as shown in figure 5 (where a indicates the compartment is empty, and “b” indicates the compa...

Technical Information Width 44.6 cm Depth 55 cm Height 82 cm Capacity 9 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V ~50 Hz Rated current input 10 A Total absorbed power 1950 W 8 WC430 Manual.indd 9 3/6/09 11:19:07

Programme Listing Programme names and temperatures Intensive 70 O wash Normal 55 O wash Economic 50 O wash Glass 45 O wash Rapid wash 40 O wash Prewash No heat Level of soil High Medium Medium Small Small NA Detergent amount A=Main B=Prewash A+B A+B A+B A A NA Programme duration (mins.) standard/ qu...

Care and Maintenance Before beginning any care or maintenance, you should always disconnect the appliance from the electricity supply, and also turn off the water supply. Door seals Wipe the dishwasher door seals regularly with a damp cloth to remove any residue. Filters You should clean the filters...

Failure Code and Troubleshooting Problem Possible cause The programme will not start Check the plug, fuse and circuit breakers of the mains supply The water tap is turned off The dishwasher door is not fully closed The water inlet filter or the machine filters are blocked Water remains inside the di...

Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 ...

Installation • Do not install this appliance if it is damaged in any way. Installing a damaged appliance may invalidate the warranty. • The water supply tap should be located in an adjacent cupboard so that it can be accessed after installation. • Ensure the appliance is level by adjusting the feet ...

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below. WC430 Manual.indd...