Page 2 - Contents
Contents 1. Description of the controls________________________________ 16 2. Troubleshooting _______________________________________ 25 Thank you for choosing one of our products.You are advised to read this manual carefully; it contains all theinformation you need about the right conditions for th...
Page 3 - INSTALLATION INSTRUCTIONS: these are intended for the
Contents 1. Safety and operating instructions __________________________ 28 2. Installation and hook-up _________________________________ 31 3. Operating instructions ___________________________________ 35 4. Cleaning and maintenance _______________________________ 47 Thank you for choosing one of o...
Page 4 - Safety instructions; Safety and operating instructions; AND; WASHING; ANY OTHER USE SHALL BE CONSIDERED; THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
Safety instructions 28 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A Q...
Page 5 - THIS APPLIANCE IS MARKED ACCORDING TO THE; EUROPEAN DIRECTIVE; ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT; WEEE; THE SYMBOL
Safety instructions 29 THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( WEEE ). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMENT AND HUMAN HEALTH, WHICH C...
Page 6 - AQUASTOP MODELS; IN THE EVENT OF DAMAGE TO THE WATER INTAKE HOSE,; DO NOT ATTEMPT TO REPAIR THE; The manufacturer declines all responsibility; for damage to persons or property
Safety instructions 30 DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKE...
Page 7 - Installation instructions
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers.Position the appliance in the desired place of installation. The back orsides of the dishwasher may be placed up against walls or otherfurniture units. If the dishwasher is installed near a heat source, fit...
Page 8 - Water supply connection; Preventing the risk of clogging or damage:
Installation instructions 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supplycheck that the water is clear and free of impurities, to prevent damage tothe appliance. The dishwasher...
Page 9 - Electrical connection and precautions; DO NOT USE ADAPTORS OR SHUNT CONNECTIONS; IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD:; QUALIFIED TECHNICIAN
Installation instructions 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCHTHE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ONTHE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKETOUTLET MUST BE OF THE SAME TY...
Page 10 - WHEN CLEANING AND MAINTAINING THE APPLIANCE:; THIS APPLIANCE MUST BE EARTHED.; Fuse replacement; The fuse cover must be refitted when changing a fuse
Installation instructions WHEN CLEANING AND MAINTAINING THE APPLIANCE: BEFORE CARRYING OUT ANY WORK, ALWAYS UNPLUG THE APPLIANCEFROM THE ELECTRICAL SUPPLY OR SWITCH OFF THE ALL-POLEDISCONNECTION DEVICE. FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of thi...
Page 11 - User instructions; Operating instructions; Adjust the water softening system; Using the water softening system; 0 washing cycles; container can hold approximately
User instructions 3. Operating instructions Once the dishwasher has been correctly installed, prepare for use asfollows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 3.1 Using the water softening system The amount of scale contained in thewater...
Page 12 - Using the rinse aid and detergent dispensers; detergent; is on the left, and the; rinse aid dispenser
User instructions • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program . In this way, the excess saline solution will be immediately removed by...
Page 13 - ADDING THE RINSE AID; Rotate the container cap anticlockwise by 1⁄4 of a turn and remove it.; ADJUSTING THE RINSE AID DISPENSER SETTING; The amount of rinse aid must be
User instructions ADDING THE RINSE AID The rinse aid helps the dishes dry faster andprevents the formation of scale deposits andstaining; it is automatically added to the waterduring the final rinse cycle, from the containersituated on the inner side of the door. To add rinse aid: • Open the door. •...
Page 14 - ADDING THE DETERGENT; . Add the detergent and close the cap
User instructions ADDING THE DETERGENT To open the detergent dispenser cap, lightly pressthe button P . Add the detergent and close the cap carefully. During the washing cycle, the dispenser willbe opened automatically. • When a program with hot prewash is selected (see program table),extra detergen...
Page 15 - button; General warnings and recommendations; Before loading the dishes into the baskets it is necessary to:
User instructions 39 • "3/1" Products If you wish to use detergents which already contain salt and rinseaid, check whether your dishwasher is fitted with the " 3/1 option button " on the " Controls description " page and then refer to the section which explains how to use thi...
Page 16 - MAKE SURE that the items being washed are dishwasher-safe.
User instructions 40 WARNING! • Make sure that the dishes are securely in place so that they cannottip over or obstruct the rotation of the spray arms during thewashing cycle. • Do not place very small objects in the baskets as these could falland obstruct the spray arms or the wash pump. • Containe...
Page 17 - Using the baskets; The dishwasher has a capacity of; EN 50242 STANDARD LOADS FOR CERTIFICATION BODIES; LOWER BASKET; The
3.4 Using the baskets The dishwasher has a capacity of 12 place-settings , including serving dishes. EN 50242 STANDARD LOADS FOR CERTIFICATION BODIES LOWER BASKET UPPER BASKET UPPER BASKET ( models with cutlery racks ) The upper basket must be set in the low position. 41 User instructions
Page 18 - With fixed supports; LOADING THE LOWER BASKET; ⁄2 LOAD
LOWER BASKET The lower basket receives the full force of the lower spray arm, andshould therefore be used for the “toughest” items with a heavier degreeof soiling. All types and combinations of loads arepermitted, provided that the dishes, pots andpans are arranged with all the soiled surfacesexpose...
Page 19 - CUTLERY BASKET; The cutlery supports and central lid are in the bag of; making sure that the knife blades; models
CUTLERY BASKET The basket has removable top grids into which items of cutlery can beinserted to keep them properly spaced and allow water to pass betweenthem effectively. The cutlery supports and central lid are in the bag of The cutlery should be arranged in an orderly mannerinside the basket, with...
Page 20 - LOADING THE UPPER BASKET
LOADING THE UPPER BASKET Load plates facing forward; cups, bowls etc. must always be facingdownwards. The left-hand side of the basket can be loaded with twolayers of cups and glasses. The centre can be filled with plates and side-plates, fitted upright into the supports provided. Loading examples: ...
Page 21 - two positions
ADJUSTING THE UPPER BASKETVersion A: the upper basket can be adjusted in two positions , according to the user’s needs and according to the height of the dishesin the lower basket. Proceed as follows. • pull out the right-hand basket guide ; • remove the stop, first releasing it as shown in the diag...
Page 22 - the top basket can be set in; three different positions; on
Version C: the top basket can be set in three different positions on both sides. The rack must be level on both sides. To raise the basket lift it, pulling on the front edge (1) , to the first or second catch depending on the height required. To lower it, pull therelease lever (2) . This is also pos...
Page 23 - Cleaning and maintenance; General warnings and recommendations; lower
User instructions 4. Cleaning and maintenance Before carrying out any work, always disconnect the appliancefrom the electrical power supply. 4.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regularlyus...
Page 24 - CLEANING THE FILTER UNIT; It is advisable to periodically inspect the centre filter
User instructions 48 CLEANING THE FILTER UNIT x It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn them anticlockwise and lift upwards; x push the centre filter D from the underside to remove it from the micro-filter:...
Page 26 - 2 Standard place settings; Water supply pressure; See rating plate
If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special container; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost itseffectiveness (for example, through incorrect storage, with the boxleft open). If the dis...
Page 27 - Description of the controls; Pressing this button energises the appliance.
User instructions 1. Description of the controls 1.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switch-on,programming, switch-off etc. procedures are only possible when the dooris open. 1 ON/OFF BUTTON Pressing this button energises the appliance. 2 SELECTED PROGRAM INDI...
Page 28 - Press this button to activate the option for use of 3/1 products.; HALF LOAD BUTTON; Press this button to activate the half load wash option.; HALF LOAD LIGHT; Press this button to delay the start of the program by up to 9 hours.; 3 INFORMATION DISPLAY
User instructions 8 "3/1" OPTION BUTTON (on some models only) Press this button to activate the option for use of 3/1 products. 9 "3/1" OPTION LIGHT (on some models only) Illuminates to indicate that the function is activated. 10 HALF LOAD BUTTON (on some models only) Press this butt...
Page 29 - SETTING THE WASHING PROGRAM AND SWITCHING ON
User instructions SETTING THE WASHING PROGRAM AND SWITCHING ON To select the most suitable program for the dishes to be washed refer tothe table below, which indicates the most appropriate program accordingto dish type and degree of soiling. After using the table to identify the most appropriate was...
Page 30 - Only; run the soak program with half loads.; level 2
User instructions Only run the soak program with half loads. To execute programs 6,7,8,9,10 users must first press the extra programs button (6) . (*) Reference program as per EN 50242 standard.(**) When the " AUTO 40-50 " or " AUTO 60-70 " program is selected, the dishwasher recogni...
Page 31 - Before starting a washing program make sure that:; CANCELLING THE CURRENT PROGRAM; button for a few seconds; indicator lights; for programs; CHANGING THE PROGRAM
User instructions 1.2 Washing programs Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser . • The baskets have been correctly loaded. • The spray arms are able to rotate freely and without obstruction. •...
Page 32 - When washing in the
User instructions SELECTING HALF LOAD WASH (on some models only) This function is ideal for small loads and saves water and electricity. It iscontrolled by the HALF LOAD (10) button, with two alternatives: 1) press the button once to select washing in the top basket (the relative light comes on); 2)...
Page 33 - DELAYING THE PROGRAM (on some models only); TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT
User instructions "3/1" OPTION BUTTON (on some models only)(available in all programs except the soak program) By pressing the button (8) you activate the " 3/1 " option, confirmed when the relative light comes on. This option has been studied for the use ofdishwashing powder or tabl...
Page 34 - ADJUSTING THE WATER SOFTENING SYSTEM; WATER HARDNESS
User instructions ADJUSTING THE WATER SOFTENING SYSTEM N.B.: for the setting below to be possible, a washing program other than the soak program must be set. Press the PROGRAM DELAY button (12) and keep it pressed until the preset value appears followed by a full stop (normally 3. ). Release the but...
Page 35 - minute; END OF CYCLE
User instructions If the door has to be opened while washing is in progress, the programwill be interrupted. The relative light will keep flashing and a beeper willsignal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the door...
Page 37 - FAULT; Light off
User instructions FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only)The appliance is not able to "measure" the amount ofwater loaded accurately. Interrupt the program andswitch off the dishwasher. Switch the dishwasherback on, program it again and start th...
