CDA SVA 100 PP - Manual

5 Control Panel Controls Description 1. Oven thermostat knob 2. Oven switch knob3. Clock and timer with “Touch-Control” keys Warning Lights:4. Power on indicator lamp 5. Oven thermostat indicator light Please Note: This appliance incorporates a safety cooling fan which you will hear operating whenev...

6 Fan Oven General Features The heating and cooking in electrical hot air ovens take place by forced convection. The two elements which make this process take place are: – Grill element 2000 W – Circular element 2200 W Note:Upon first use, it is advisable to operate the oven at the maximum temperatu...

7 How to Use the Oven WARNING:The door is hot, use the handle. ATTENTION - MOST IMPORTANTPay special attention not to touch the hot heating element inside the oven cavity. Thermostat Knob (Fig. 3) This only sets the cooking temperature and does not switch the oven on. Rotate clockwise until the requ...

9 Cooking Advice Sterilization Sterilization of foods to be conserved, in full and hermetically sealed jars, is done in the following way:a. Set the switch to position . b. Set the thermostat knob to position 185 °C and preheat the oven. c. Fill the dripping pan with hot water. d. Set the jars onto ...

10 Clock and Timer with “Touch-Control” Keys K eys and Touched simultaneously (for more than 2 seconds): – setting the clock; – setting the timer volume (by touching once, along with the “ ” key); – to cancel automatic cooking at any time. Function selection (touched for more than 2 seconds): – sett...

11 “Touch-Control” Keys The “touch-control” keys shall be operated by the fingers (just by touching the key). When using touch controls it is best to use the ball of your finger rather than the tip.The keys are automatically deactivated:– 8 seconds after the last selection; the deactivation is indic...

12 Automatic Cooking Use automatic cooking to automatically turn the oven on, cook, and then turn the oven off.1. Check the clock shows the correct time.2. Select the function and temperature (function and temperature knobs). The oven will come on.3. Decide how long the food will take to cook, allow...

14 Care and Maintenance It is advisable to clean when the appliance is cold and especially for cleaning the enamelled parts. Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces. Avoid using cleaning products with a chlorine or acidic base. WARNINGWhen correctly i...

15 Stainless Steel, Aluminium, Painted Parts and Silk-screen Printed Surfaces Clean using an appropriate product. Always dry thoroughly.Stainless steel surfaces: can be cleaned with an appropriate stainless steel cleaner.IMPORTANT: these parts must be cleaned very carefully to avoid scratching and a...

16 Replacing the Halogen Oven Light WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.– Let the oven cavity and the heating elements to cool down;– Switch off the electrical supply; – Remove the protective cover C (fig. 5);– Replace th...

17 Assembling and Dismantling of the Side Runner Frames – Assemble the wire racks to the oven walls using the 2 screws (Fig. 6).– Slide the tray and rack into the runners (Fig. 7). The rack must be fitted so that the safety catch, which stops it sliding out, faces the inside of the oven. – To disman...

18 Oven Door Removing the Oven Door The oven door can easily be removed as follows:– Open the door to the full extent (fig. 8a).– Open the lever A completely on the left and right hinges (fig. 8b). – Hold the door as shown in fig. 8.– Gently close the door (fig. 8c) until left and right hinge levers...

19 Oven Door - Removable Inner Pane of Glass Cleaning the Panes of Glass The oven door is fitted with no. 2 panes: - no. 1 outside;- no. 1 inner;To clean the panes on both sides it is necessary to remove the inner pane as follows. Do not use harsh abrasive cleaners or sharp metal scrapers to clean t...

20 Replacing the Inner Pane of Glass 1. Make sure the door is locked open (see fig. 11). 2. Replace the inner pane: – Check that the four rubber pads are in place (D in Fig. 14).– Check that you are holding the pane the correct way. You should be able to read the wording on it as it faces you. – Ins...

21 ADVICE FOR THE INSTALLER Important Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS and in compliance with the local safety standards. • Failure to observe this rule will invalidate the warranty. • Always disconnect the appliance from the electrical supply ...

24 Fixing the Oven Introduce the oven into the furniture opening and fix it with screws (not supplied) as figure 24. It is essential that the oven rests on a surface which will support its weight, as the screw fixing is only complementary. NoteIt is essential that when installing your oven adequate ...

26 Mains Electricity Connection Incorrect installation may be dangerous and the manufacturer can not be held responsible.Warning! This appliance must be earthed The manufacturer declines all responsibility for any problem caused by failure to observe this rule. THIS APPLIANCE MUST BE CONNECTED TO TH...

28 Appliance Servicing CDA provide a quality and effective after-sales service to cover all your servicing needs. Please attach your receipt to this page for safekeeping.Please help us to help you by having the following information available when booking a service-call:1. Model type, make and model...

29 Guarantee CDA appliances carry a five-year parts and a one-year labour guarantee. CDA will repair or replace any defect or part attributable to faulty material or workmanship. Within the first year this will be free of both labour and parts charges. After the first year and within five years, the...

Customer Car e Department • The G r oup Ltd. • Harby Road • Langar • Nottinghamshi r e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu To contact our Customer Care Department, or for Service, please contact us on the details below. Cod. 1103756 - ß1