CDA SV500 - Manual

4 The Control Panel and Display Fig.3 A Clock display B Door lock indicator C Eco cooking indicator D Minute minder indicator E End time indicator F Cooking time indicator G Time setting keys H Timer selection key I Temperature display B A I F G C D E H

5 Fitting Out Your Appliance 1. Side racks (E on fig. 4) The side racks allow five different cooking heights for the drip tray and shelf.When cooking using the grill functions and rotisserie, use the drip tray or shelf at height 5 to collect the juices from the food. 2. Drip tray (figure 4) The enam...

6 General Settings and Use Clock To set the clock when the time and the clock indicator are flashing (for example, when the oven is first switched on) touch or until the correct time shows on the display, then touch to confirm the selection. The oven will beep to confirm the selection and the clock ...

10 Pyrolysis Programmes This oven can clean itself by a process known as pyrolysis, heating the cavity to a temperature of 500˚C. This will burn off the residue from spattering and spillages caused by cooking. Pyrolytic programmes should be used when the oven smokes during preheating or cooking or i...

Cleaning and Maintenance IMPORTANT:Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.You should always allow the oven to cool fully after use before undertaking any cleaning or maintenance. You should only use non-abrasive cleaners. Any abrasive cle...

Changing the Oven Lamp Before any maintenance is started involving electrical parts, the oven must be disconnected from the power supply. If the oven has been in use, let the oven cavity and the heating elements cool down before attempting any maintenance. Never replace the bulb with bare hands as c...

Care and Maintenance Cleaning the interior of the door Open the door completely and insert two of the red stoppers supplied with the oven, as shown in figure 10. Then insert the other two red stoppers in the A slots, as shown in figure 11. Lever the stoppers to lift the frame and the glass from the ...

Troubleshooting If the oven is not functioning correctly, check the advice below prior to calling CDA Customer Care. The oven display will show error codes if there is a fault with the appliance. These are detailed below. Before calling CDA Customer Care, take note of the error code as this will hel...

Installation Important If the oven is being installed into a built under oven housing unit ensure that the front rail at the top of the unit is not installed as it could restrict ventilation. Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclose...

Mains Electricity Connection Warning! This appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring and ...

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below.