Page 2 - Important; Appliance Information:; Declaration of CE Conformity
2 Important This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. The appliance guarantee will be void if the appliance is used within a non do...
Page 3 - Before Using for the First Time; Using the Oven for the First Time
3 Before Using for the First Time – Read the instructions carefully before installing and using the appliance.– After unpacking the appliance, check that it is not damaged. In case of doubt, do not use the appliance and contact your supplier or a qualified engineer. – Remove all the packing material...
Page 4 - Important Safeguards and Recommendations
4 Important Safeguards and Recommendations – Do not carry out any cleaning or maintenance without first disconnecting the appliance from the electrical supply. – During and after use of the oven, certain parts will become very hot. Do not touch hot parts.– After use always ensure that the control kn...
Page 5 - Control Panel; Controls Description
5 Control Panel Controls Description 1. Oven thermostat knob 2. Oven switch knob3. Electronic programmer Warning Lights:4. Power on indicator lamp 5. Oven thermostat indicator light Please Note: This appliance incorporates a safety cooling fan which you will hear operating whenever the oven or grill...
Page 6 - Fan Oven; General Features; Operating Principles
6 Fan Oven General Features The heating and cooking in electrical hot air ovens take place by forced convection. The two elements which make this process take place are: – Grill element 2000 W – Circular element 2200 W Note:Upon first use, it is advisable to operate the oven at the maximum temperatu...
Page 7 - How to Use the Oven; Thermostat Knob
7 Fig. 3 How to Use the Oven WARNING:The door is hot, use the handle. ATTENTION - MOST IMPORTANTPay special attention not to touch the hot heating element inside the oven cavity. Thermostat Knob (Fig. 2) This only sets the cooking temperature and does not switch the oven on. Rotate clockwise until t...
Page 9 - Cooking Advice; Sterilization
9 Cooking Advice Sterilization Sterilization of foods to be conserved, in full and hermetically sealed jars, is done in the following way:a. Set the switch to position . b. Set the thermostat knob to position 185 °C and preheat the oven. c. Fill the dripping pan with hot water. d. Set the jars onto ...
Page 10 - Electronic Programmer; AUTO
10 Electronic Programmer The electronic programmer is a device that groups together the following functions:– 24 hour clock with illuminated display– Timer (up to 23 hours and 59 minutes) – Programme for automatic oven cooking– Programme for semi-automatic oven cooking. A U T O Description of the Bu...
Page 11 - Electronic Clock; Note: If the clock is reset it deletes any previously set programs.; Normal Cooking without the Use of the Programmer
11 Electronic Clock (fig. 5) The programmer is equipped with an electronic clock with illuminated numbers which indicates hours and minutes. Upon immediate connection of the oven or after a power cut, three zeros will flash on the programmer display. To set the correct time of day it is necessary to...
Page 12 - Automatic Oven Cooking; The cooking program may be cancelled at any time by pushing
12 A U T O A U T O Automatic Oven Cooking To cook food automatically in the oven, it is necessary to:1. Set the length of the cooking time 2. Set the end of the cooking time 3. Set the temperature and the oven cooking program. These operations are done in the following way: 1. Set the length of the ...
Page 13 - Semi - Automatic Cooking; AUTO and the symbol will be on.
13 Semi - Automatic Cooking This is used to switch the oven off automatically after the desired cooking time has elapsed. There are two ways to set the semi-automatic cooking function: 1. Set the length of time you need to cook the food by pushing the button and the button to advance, or to go backw...
Page 15 - Care and Maintenance; Inside of Oven
15 Care and Maintenance It is advisable to clean when the appliance is cold and especially for cleaning the enamelled parts. Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces. Avoid using cleaning products with a chlorine or acidic base. WARNINGWhen correctly i...
Page 17 - Replacing the Oven Light; NOTE: Oven bulb replacement is not covered by your guarantee.
17 Replacing the Oven Light WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.– Let the oven cavity and the heating elements to cool down;– Switch off the electrical supply;– Unscrew the protective cover C (fig. 12);– Unscrew and repla...
Page 18 - Assembling and Dismantling of the Side Runner Frames
18 Assembling and Dismantling of the Side Runner Frames – Assemble the wire racks to the oven walls using the 2 screws (Fig. 13).– Slide the tray and rack into the runners (Fig. 14). The rack must be fitted so that the safety catch, which stops it sliding out, faces the inside of the oven. – To dism...
Page 19 - Oven Door; Cleaning the Panes of Glass
19 Oven Door Depending on the model, the oven door is hinged either on the left or the right. Note: The oven door should only be removed by an authorised service agent.Removal of the oven door by a non-authorised person will invalidate the guarantee. Cleaning the Panes of Glass The oven door is fitt...
Page 20 - Replacing the inner pane of glass; – Reassemble the seal G in the correct way (fig. 21) by hooking
20 E F F E Replacing the inner pane of glass To replace the inner pane of the door operate as follows:– Check that the four rubber pads are in place (D in Fig. 18).– Whilst one person holds the door still, a second person should insert the inner pane in the left E and right F side guides (fig. 19) a...
Page 21 - WARNING
21 ADVICE FOR THE INSTALLER Important Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS and in compliance with the local safety standards. • Failure to observe this rule will invalidate the warranty. • Always disconnect the appliance from the electrical supply ...
Page 24 - Fixing the Oven
24 Fixing the Oven Introduce the oven into the furniture opening and fix it with screws (not supplied) as figure 27. It is essential that the oven rests on a surface which will support its weight, as the screw fixing is only complementary. NoteIt is essential that when installing your oven adequate ...
Page 26 - Mains Electricity Connection
26 Mains Electricity Connection Incorrect installation may be dangerous and the manufacturer can not be held responsible.Warning! This appliance must be earthed The manufacturer declines all responsibility for any problem caused by failure to observe this rule. THIS APPLIANCE MUST BE CONNECTED TO TH...
Page 28 - Appliance Servicing
28 Appliance Servicing CDA provide a quality and effective after-sales service to cover all your servicing needs. Please attach your receipt to this page for safekeeping.Please help us to help you by having the following information available when booking a service-call:1. Model type, make and model...
Page 29 - Guarantee; Limit of Cover
29 Guarantee CDA appliances carry a five-year parts and a one-year labour guarantee. CDA will repair or replace any defect or part attributable to faulty material or workmanship. Within the first year this will be free of both labour and parts charges. After the first year and within five years, the...
Page 32 - To contact our Customer Care Department, or for Service,
Customer Car e Department • The G r oup Ltd. • Harby Road • Langar • Nottinghamshi r e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu To contact our Customer Care Department, or for Service, please contact us on the details below. Cod. 1103572 - ß2
