CDA RV 1060 - Manual

5 Clock and Timer with “Touch-Control” Keys (Multifunction Main Oven only) Keys:+ and – Touched simultaneously (for more than 2 seconds): • setting the clock; • setting the timer volume (by touching once, along with the “MODE” key); • to cancel automatic cooking at any time. MODE Function selection ...

7 Automatic Cooking Use automatic cooking to automatically turn the oven on, cook, and then turn the oven off.1. Check the clock shows the correct time.2. Select the function and temperature (function and temperature knobs). The oven will come on.3. Decide how long the food will take to cook, allowi...

8 How to Use the Vitroceramic Hob The ceramic surface of the hob allows a fast transmission of heat in the vertical direction, from the heating elements underneath the ceramic glass to the pans sat on it. The heat does not spread in the horizontal direction, so that the glass stays “cool” at only a ...

9 Double and Oval Radiant Zones The heating element is formed of a coil of resistant material which reaches the working temperature quickly.Operation of the cooking zone is controlled by a continuous energy regulator from “1” to “12” (maximum temperature) (fig. 6).To turn on both zones of the double...

10 After a short period of use, experience will teach you which setting is the right one for your needs. Cooking Hints = Warming = Cooking = Roasting - Frying Position Type of cooking 0 0 Switched OFF 12 12 For melting operations(of butter or chocolate). 2 234 To keep foods warm or heat small quanti...

11 Residual Heat Indicators The hob also features 5 warning lights which are connected to the corresponding plates. When the temperature of a cooking plate is above 60°C, the relevant warning light will also light up to warn of heat on the surface of the hob.This light also stay on after the cooking...

12 Safety Hints: – Before you switch the hob on, make sure you know which knob controls the required cooking plate. We advise you to set the pan over the cooking plate before switching it on. Remove the pan after you have switched the cooking plate off. – Do not use pots and pans with rough bases (p...

13 How to Use the Multifunction Main Oven General Features As its name indicates, this is an oven that presents particular features from an operational point of view.In fact, it is possible to insert 7 different programmes to satisfy every cooking need.The 7 positions, thermostatically controlled, a...

17 Cooking Advice Sterilization Sterilization of foods to be conserved, in full and hermetically sealed jars, is done in the following way:a. Set the switch to position . b. Set the thermostat knob to position 185 °C and preheat the oven. c. Fill the dripping pan with hot water. d. Set the jars onto...

19 How to Use the Conventional Oven General Features As its name indicates, this is an oven that presents particular features from an operational point of view. The conventional oven is provided with 3 heating elements which are:– Bottom element 800 W – Top element 700 W – Grill element 1450 W Note:...

21 Use of the Grill Switch the grill on, setting the two knobs:– Function selector to or position. – Thermostat selector to position 225°C for 15 minutes then to 175°C.Leave to warm up for approximately 5 minutes with the door closed. Place the food inside positioning the rack as near as possible to...

23 Do’s and do not’s – Do always grill with the oven door closed.– Do read the user instructions carefully before using the cooker for first time.– Do allow the oven to heat for one and a half hours, before using for the first time, in order to expel any smell from the new oven insulation, without t...

24 Care and Maintenance Important:As a safety measure, before you start cleaning the cooker be sure to disconnect it from the mains supply.– Do not use cleaning products with a chlorine or acidic base. – Do not use a steam cleaner because the moisture can get into the appliance thus make it unsafe. ...

25 Drawer The drawer (fig. 21) comes out like a normal drawer.Attention: Do not store flammable material in the ovens, or the drawer. Fig. 21 Replacing the Halogen Oven Lights WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.– Let the...

27 Oven Doors Removing the Oven Doors Please operate as follows:– Open the door completely.– The swivel retainers of the rh and lh hinges (fig. 24a) are hooked onto the metal bar above them (fig. 24b). – Lift the oven door slightly. The noch on the bottom of the hinge will disengage (fig. 24c). – No...

28 Over Doors - Cleaning The Panes Of Glass The oven doors have two panes. To clean these, you need to remove the inner pane. Removing the Inner Pane – Open the door to the full extent (fig. 24a).– Attach the swivel retainers of the rh and lh hinges onto the metal bar above them (fig. 24b). – Gently...

30 +8 mm +8 0 mm +35 mm V A B Assembling the Backguard Before installing the cooker, assemble the backguard V (fig. 27). Please note that : – The backguard V can be found packed at the rear of the cooker. – Before assembling remove any protective film/adhesive tape. – The backguard must be fixed to ...

32 Stability Bracket We recommend a stability bracket is fitted to the cooker. The type shown in fig. 33 can be purchased from most plumbers merchants and do it yourself (D.I.Y.) shops. Brackets Existing slot in rear of cooker Dotted line showing the position of cooker when fixed Fig. 32 Fig. 33 Wal...

33 Electrical Installation IMPORTANT: The cooker must be installed in accordance with the manufacturer’s instructions. Incorrect installation, for which the manufacturer accepts no responsi bility, may cause injury to persons, animals or equipment. For Your Safety Please Read the Following Informati...

34 Connecting the power cord must be entrusted to skilled personnel in accordance with the instructions supplied by the manufacturer and in compliance with established safety standards. Connecting the Mains Cable To connect the feeder cable to the cooker it is necessary to:– Remove the two screws th...

35 Appliance Servicing CDA provide a quality and effective after-sales service to cover all your servicing needs. Please attach your receipt to this page for safekeeping.Please help us to help you by having the following information available when booking a service-call:1. Model type, make and model...

Customer Car e Department • The G r oup Ltd. • Harby Road • Langar • Nottinghamshi r e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu To contact our Customer Care Department, or for Service, please contact us on the details below. Cod. 1103534 - ß2