Page 2 - General warnings; IE
Dear Customer, Thank you for choosing our product. This appliance is easy to use; read this handbook carefully before installing and using it, however. You will find the correct indications for the best installation, use and maintenance of the product. • Very important: keep this instruction booklet...
Page 3 - the
General warnings 002 LINGUE 28-09-2005 19:29 Pagina 23 IE GB • If a gas appliance is used for a long time it may require extra ventila-tion (opening a window or increase of the forced exhaust). • Be careful not to place saucepans with unstable or deformed bottomson the burner to avoid accidents by o...
Page 4 - Description of the main parts of the appliance; Instructions for use; = knob for burner ignition and adjustment
Description of the main parts of the appliance Instructions for use 1 = grid2 = cover3 = spreader 4 = ON spark plug5 = safety valve (for models equipped with a safety valve) 6 = knob for burner ignition and adjustment 002 LINGUE 28-09-2005 19:29 Pagina 24 IE GB 6 1 5 2 3 4 22
Page 5 - Operation of gas burners
Instructions for use The hob control area houses the devices and knobs for operation of the gas burners. 002 LINGUE 28-09-2005 19:29 Pagina 25 In order to ignite a burner, it is necessary to depress the knob while rotating it anti- clockwise, till the index is aligned with the position corresponding...
Page 6 - Burners; Advice on the use of gas burners; Triple ring
Instructions for use Container table (use flat-bottomed saucepans) Auxiliary (Ø = 55) Medium quick (Ø = 75) Quick (Ø = 100) Burners (heights cover) mm Ø min. Saucepan (mm) Ø max. Saucepan (mm) 002 LINGUE 28-09-2005 19:29 Pagina 26 90 160 150 260 130 180 Advice on the use of gas burners For lower gas...
Page 7 - Maintenance and cleaning; YES
Maintenance and cleaning Do not use jet of steam for cleaning. Instructions for use 002 LINGUE 28-09-2005 19:29 Pagina 28 Before any operation disconnect the appliance electrically. Wash the enamelled parts with lukewarm water and detergent. Do not use abrasive products. Wash the burner spreader fre...
Page 8 - Instructions for installation
Below we give the instructions for qualified installers so that the installation, setting and maintenance operations are performed correctly and according to the regulations in force. Positioning This appliance isn’t connected to any scavenging devices of combustion products. The appliance can only ...
Page 9 - Important
To perform these operations the qualified installer will follow the indications given in the "Adaptation to the various types of gas" section. For safety operation make sure that the supply pressure respects the values given in the "Table of burner and injector characteristics”. If the a...
Page 10 - ELECTRICAL CONNECTION
Instructions for installation ELECTRICAL CONNECTION The appliances are provided with a three-pole feeding cable and work with alternate current and single-phase voltage indicated on the “rating plate of the product “report at the end of the instruction manual and on the product. The grounding conduc...
Page 11 - Adaptation to different types of gas
Adaptation to different types of gas To adapt the appliance to a gas different from that for which it was set up (see label on both the packaging and the bottom of the appliance) proceed as follows: • remove the grids • remove the covers and the spreaders • with a 7 mm socket spanner unscrew and rem...
Page 12 - Setting the minima; light the burner; THE BURNERS REQUIRE NO REGULATION OF THE PRIMARY AIR.; Regulation of minimum for LPG
Instructions for installation 002 LINGUE 28-09-2005 19:29 Pagina 33 IE GB Setting the minima The flame on the small output is regulated in the factory. When the injec-tors have been replaced or there are special mains pressure conditions, itmay be necessary to regulate the minimum again. The operati...
Page 13 - Burner and nozzle characteristic table; Quick; Burner
Burner and nozzle characteristic table Instructions for installation Quick (Ø = 100) Medium quick (Ø = 75) Auxiliary (Ø = 55) Rated supply pressure(mbar) (1 mbar ≅ 10,197mm H 2 O) (*) = With dry gas and with greater calorific power (Hs ) at 15°C and 1013 , 2 5 mbar Burner (heights cover ) (mm) Therm...
Page 14 - Instructions for building in the units; distance as shown in figure.
Instructions for building in the units The appliance is of class 3. It can be installed with just one side part (to right or left of the hob) higher than the cooking hob and placed at a minimum distance as shown in figure. It can be built into all units whose walls withstand a temperature 65°C highe...
Page 15 - • Position the special sealed gasket (provided) on the; Warnings
Instructions for installation 002 LINGUE 28-09-2005 19:29 Pagina 36 mm IE GB • Position the special sealed gasket (provided) on the edge of the hob making sure that the ends meet withoutone lying on top of the other. • Put the hob in the unit opening making sure that it is centred. • Fasten the hob ...