CDA HCC662 - Manual - manualsarea.com

Page 2 - Important

Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a...

Page 4 - Using your hob; Power level; Residual Heat Indicators

Using your hob Power level Type of cooking 0 switched off 1/2 for melting (butter/chocolate) or keeping food warm 2/3 keeping food hot or to heat small quantities of liquid 3/4 heat larger quantities of liquid (sauces etc.) 4/5 Slow boiling, e.g spaghetti, soups, stews, potatoes 6/7 gentle frying 7/...

Page 5 - To switch the zone on

Using your hob To switch the zone on • Touch the power key. • Select the zone required by touching the zone selection key until the required zone flashes a 0 in the zone display. The order for zone selection is clockwise starting at the front right zone. The zone display will flash for approximately...

Page 6 - Efficient Use of your Hob; Zone Size

Efficient Use of your Hob Before using your hob for the first time, switch the zones on for a FEW SECONDS to burn off any grease left over from the manufacturing process The ceramic glass retains heat, so to make best use of the residual heat, switch off the zone five minutes prior to the end of coo...

Page 7 - Care and Maintenance; Mains electrical voltage:; Contact CDA Customer Care

Types of residues Clean with Cleaning advice Light Cleaning sponge and soft cloth Wipe over the zone to be cleaned with a sponge and hot water, and then wipe off with a soft dry cloth. Accumulated baked-on stains/ dirt, sugar spills or melted plastics Cleaning sponge or glass scraper and soft cloth ...

Page 8 - Mains Electricity Connection; Warning! this appliance must be earthed

7 Mains Electricity Connection Warning! this appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring an...

Page 9 - Fitting the Hob; Unpacking; Fitting position of the hob:

Fitting the Hob Unpacking the hob: • Take care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 190mm away from any adjacent vertical surfaces, e.g. a tall cupboard end panel. This may be reduced t...

Page 10 - How to Install the Hob; How to install the hob:

How to Install the Hob How to install the hob: Overall dimensions of the hob: Width: 580mm Depth: 510mmWorktop cut-out dimensions: Width: 560mm Depth: 490mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you w...

Page 12 - Passionate about style; To contact our Customer Care Department, or for Service,

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below. Dis.S506__-909 Co...

CDA HCC662 - Manual

Table of Contents:

Summary

Other CDA Models