CDA 6Q6 - Manual

5 Oven Features General Features This multifunction oven has 4 heating elements which allow you to choose between 9 cooking programmes: – Lower element 1300 W – Upper element 1000 W – Grill element 2000 W – Circular element 2200 W Note: Before using your new oven, it is necessary to condition your o...

6 Operating Principles Heating and cooking in the FULL ELECTRONIC MULTIFUNCTION oven are obtained in the following ways: a. by Normal convection The heat is produced by the upper and lower heating elements. b. by Semi-Forced Convection From The Bottom The heat produced by the lower heating element i...

7 Control Panel “Touch-control” keys The “touch-control” keys shall be operated by the fingers (just by touching the key). When using touch controls it is best to use the ball of your finger rather than the tip. Fig. 2a Fig. 2b Oven functions selection ON / OFF selection Programmer functions selecti...

8 150 125 100 75 50 Lit = minute minder in operation Flashing = countdown completed by the minute minder Lit = operation of heating elements (cooking functions) Flashing = semi-automatic or automatic cooking completed SYMBOL SYMBOL SYMBOL ON / OFF Programmer functions - Progressive selection (each t...

9 Electronic Controller Features It performs the following functions:– 24 hours clock with illuminated display. – Timer (minute minder: up to 600 minutes - 10 hours). – Programme for semi-automatic oven cooking (up to 600 minutes - 10 hours - of cooking time). – Programme for automatic oven cooking ...

10 Turning the Oven On and Off To turn the oven ON:– Touch the key “ ” and hold until “ On ” appears on the clock/programmer display. – You can now operate your oven. The time of the day appears on the clock/programmer display (followed by the programme number “ Pr01, Pr02, ...”). To turn the oven O...

11 Childlock Safety To activate the Childlock option touch the “ ” and “ ” keys simultaneously and hold until the clock/programmer display shows “ n--0 ” and then “ On ”. Then the time of the day appears again (followed by the selected programme number “ Pr01, Pr02, ... ” when the oven is ON). The t...

12 Oven Cooking Function When selection a cooking function the relative programme number and the symbol are activated . Set Oven Function Key Decreasing Set Oven Function Key Increasing Setting Setting Clock/ Programmer Display Functions Display Selecting the Cooking Functions Fig. 5

13 Cooking TemperatureAll cooking functions start to operate with a pre-set temperature which can be modified, at any time, by touching the relative “+” and “–” keys positioned below the temperature display. Childlock SymbolWhen the symbol is permanently lit the Childlock option is activated. Set Ov...

14 Using the Oven - Cooking Functions Turn on the oven as indicated in the “TURNING THE OVEN ON AND OFF” chapter. Select the oven function and temperature as indicated in the previous pages. IMPORTANT: the cooking function and temperature can be modified at any time during the normal, semi-automatic...

17 Convection Cooking With Fan The upper and lower heating elements and the fan are switched on. The heat from the top and the bottom is diffused by fan convection. The temperature can be set between 50 and 250°C.The pre-heating temperature is set at 175°C. To change the temperature, follow the inst...

18 Special “Booster” Programme This special programme allow a fast pre-heating of the cavity by a combination of the heating elements. VERY IMPORTANT NOTE: This special programme must be operated without food inside the oven cavity.Introduce the food to be cooked only at the end of the BOOSTER progr...

19 Using The Oven Manually Turn the oven ON as indicated in the “TURNING THE OVEN ON AND OFF” chapter. Operate the oven manually by selecting the oven function and temperature as indicated in the “SELECTING THE COOKING FUNCTIONS” and “SELECTING THE TEMPERATURE” chapters. The oven will start to opera...

20 Using The Oven Automatically Use automatic cooking to automatically turn the oven on, cook, and then turn the oven off. 1. Check the clock shows the correct time.2. Select the function and temperature. The oven will come on.3. Decide how long the food will take to cook, allowing time for pre-heat...

21 Cooking Advice Sterilization Sterilization of foods to be conserved, in full and hermetically sealed jars, is done in the following way:a. Set the switch to position . b. Set the thermostat knob to position 185 °C and preheat the oven. c. Fill the dripping pan with hot water. d. Set the jars onto...

22 Grilling and “Au Gratin” Grilling may be done by selecting the function because the hot air completely envelops the food that is to be cooked.Set the temperature between 50 and 200°C maximum and after having preheated the oven, simply place the food on the grid. Close the door and let the oven op...

24 Care and Maintenance It is advisable to clean when the appliance is cold and especially for cleaning the enamelled parts. Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces. Avoid using cleaning products with a chlorine or acidic base. WARNINGWhen correctly i...

25 Stainless Steel, Aluminium, Painted Parts and Silk-screen Printed Surfaces Clean using an appropriate product. Always dry thoroughly.Stainless steel surfaces: can be cleaned with an appropriate stainless steel cleaner. IMPORTANT : these parts must be cleaned very carefully to avoid scratching and...

26 Replacing the Halogen Oven Light WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. – Let the oven cavity and the heating elements to cool down;– Switch off the electrical supply; Top Right Lamp: – Remove the protective cover C (fig...

27 Assembling and Dismantling of the Side Runner Frames – Assemble the wire racks to the oven walls using the 2 screws (Fig. 9).– Slide the tray and rack into the runners (Fig. 10). The rack must be fitted so that the safety catch, which stops it sliding out, faces the inside of the oven. – To disma...

28 Telescopic Sliding Shelf Supports The telescopic sliding shelf supports make it safer and easier to insert and remove the oven shelves and trays. They stop when they are pulled out to the maximum position. Important ! When fitting the sliding shelf supports, make sure that you fit: – The slides t...

29 1 2 1 To remove the telescopic sliding shelf supports:– Remove the side racks by unscrewing the fixing screws (Fig. 12).– Lay down the telescopic sliding shelf support and side racks, with the telescopic sliding shelf support underneath. – Find the safety locks. These are the tabs that clip over ...

30 Drop-down Grill Element – To lower the grill element: use a flat-head screwdriver or a small coin to loosen the element fixing screw. – When you have finished cleaning the oven ceiling, raise the grill element and screw the element fixing screw back onto the stud. – Make sure that the fixing scre...

31 Oven Door Removing the Oven Door The oven door can easily be removed as follows:– Open the door to the full extent (fig. 16a).– Open the lever A completely on the left and right hinges (fig. 16b). – Hold the door as shown in fig. 16.– Gently close the door (fig. 16c) until left and right hinge le...

34 Replacing the Middle and Inner Panes of Glass 1. Make sure the door is locked open (see fig. 19). 2. Replace the middle pane: – Check that the four rubber pads are in place ( M in fig. 25). – Check that you are holding the pane the correct way. You should be able to read the wording on it as it f...

36 ADVICE FOR THE INSTALLER Important Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS and in compliance with the local safety standards. • Failure to observe this rule will invalidate the warranty. • Always disconnect the appliance from the electrical supply ...

39 Fixing the Oven Introduce the oven into the furniture opening and fix it with screws (not supplied) as figure 38. It is essential that the oven rests on a surface which will support its weight, as the screw fixing is only complementary. Note It is essential that when installing your oven adequate...

41 Mains Electricity Connection Incorrect installation may be dangerous and the manufacturer can not be held responsible.Warning! This appliance must be earthed The manufacturer declines all responsibility for any problem caused by failure to observe this rule. THIS APPLIANCE MUST BE CONNECTED TO TH...

42 Connection of the Power Supply Cable Unhook the terminal board cover by inserting a screwdriver into the two hooks “ A ” (fig. 41). Open the cable gland by unscrewing screw “ F ” (fig. 42), unscrew the terminal screws and remove the cable.The new supply cable, of suitable type and section, is con...

43 Appliance Servicing CDA provide a quality and effective after-sales service to cover all your servicing needs. Please attach your receipt to this page for safekeeping.Please help us to help you by having the following information available when booking a service-call:1. Model type, make and model...

Customer Car e Department • The G r oup Ltd. • Harby Road • Langar • Nottinghamshi r e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu To contact our Customer Care Department, or for Service, please contact us on the details below. Cod. 1103536 - ß2