CDA 3L9 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
1
2
3
4
5
6
7
8
9
10
11
12
Table of Contents:
Page 2 – Important
Page 3 – Using your Extractor
Page 4 – Using your Remote Control
Page 5 – Care and Maintenance
Page 6 – Replacing the main halogen; Replacing the ambient lighting
Page 8 – Mounting The Extractor
Page 10 – Installation
Page 11 – Mains Electricity Connection; Electrical Information
Page 12 – Passionate about style; To contact our Customer Care Department, or for Service,
Loading the manual
3L9 Extractors
Manual for Installation, Use and Maintenance
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 - Important
Important The manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that the manufacturer reserves the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the applianc...
Page 3 - Using your Extractor
2 Using your Extractor For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking. To switch on the extractor and set the speed level • Touch key A. The appliance will switch on at the first sp...
Page 4 - Using your Remote Control
3 Using your Remote Control Synchronising your remote with the extractor 1. Whilst the appliance is off, touch the light key on the extractor for approximately five seconds until the indicator light begins to flash, as shown in figure 2. 2. Turn the top section of the remote control until the indica...
Page 5 - Care and Maintenance
4 Care and Maintenance IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. You ...
Page 6 - Replacing the main halogen; Replacing the ambient lighting
5 Replacing the main halogen down lights: 1. Lower the lamp panel (G) and unscrew the 4 lamp housing fixing screws (F) to access the bulb covers. 2. Carefully prise off the bulb covers using a small screwdriver and refit the new bulb taking care not to touch the glass of the bulb (Fingerprints will ...
Page 8 - Mounting The Extractor
7 Mounting The Extractor 4. Fit the ceiling support plate into position on the 3 screws and rotate it into position, as shown in Fig 13. Ensure that the mains supply cable is located in position and is not trapped or damaged. 5. When in position, tighten the 3 main screws and fit 2 additional screws...
Page 10 - Installation
9 Installation 11. Fit the fixing support cover panel (C) and secure with the two supplied screws (A), as shown in Fig 19. 12. Fit the extractor top panel, as shown in Fig 20, using the 8 supplied screws (G). Again, ensure that the mains supply cable is not trapped. 12. Fit the 2 decorative curved p...
Page 11 - Mains Electricity Connection; Electrical Information
10 DOUBLE POLE SWITCHED FUSE SPUR OUTLET USE A 3 AMP FUSE Mains Electricity Connection THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWITCHED FUSE SPUR OUTLET AND PROTECTED BY A 3A FUSE. We recommend that the appliance is connected b...
Page 12 - Passionate about style; To contact our Customer Care Department, or for Service,
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below.