Brio CLCTPOU720UVF3 - User Manual

Page 2 - Table of Contents

2 Table of Contents Safety Information � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 3 Intended Use � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � ...

Page 3 - Safety Information

3 Safety Information WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling, installing and operating the dispenser. WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause personal injury. When operating th...

Page 5 - Touch Panel Description; Product Dimensions

5 Touch Panel Description 1� Up arrow button – Press to set the time on the clock and increase temperature settings. 2� Clock/Temperature display – Displays the time and water temperature setting for hot and cold water and also indicates when filters must be replaced. 3� Down arrow button – Press to...

Page 6 - Package Contents; Materials Needed

6 Package Contents A B C D K L M E F G H I J Part Description Quantity Part Description Quantity A Filter connecting tube 2 H Mounting bracket 3 B Shut off valve tube (7 ft.) 1 I Filter clip 10 C Elbow joint tube 1 J Grounding bracket 1 D Filter flushing tube (4 ft.) 1 K Plumber’s tape 1 E Feed wate...

Page 7 - Installation; Determine Installation Location

7 Installation 1� Determine Installation Location A� Place the dispenser upright. B� Locate the dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet. NOTICE: Do NOT plug in the power cord until the entire installation section is completed. C� Position the back ...

Page 8 - Install the Filters and Tubing

8 3� Install the Filters and Tubing A� Click the three black mounting brackets (H) onto the top of the condenser. H B� Attach one filter housing (F) to the top of a mounting bracket (H). F H C� Connect the filter connecting tube (A) to the filter housing (F). F A

Page 10 - Connect to the Cold Water Supply

10 4� Connect to the Cold Water Supply CAUTION: DO NOT CONNECT THIS WATER LINE TO A HOT WATER SUPPLY LINE. The water supply to the unit MUST be from the COLD WATER LINE. Using HOT WATER will severely damage your filters. A� Turn off and then disconnect the current cold water supply line. B� Connect ...

Page 11 - Flush the Filters and Complete the Installation

11 5� Flush the Filters and Complete the Installation IMPORTANT: Follow this procedure every time you replace your filters. IMPORTANT: Ensure the water supply is off before you begin. A� Connect the red filter flushing tube (D) to the right filter housing (F). B� Lay the open end of the filter flush...

Page 12 - Operation; Turn the Dispenser On/Off

12 Operation IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors can accumulate in the tank and lines. Dispense and dispose at least one quart of water prior to drinking any water. Turn the Dispenser On/Off IMPORTANT: Before you activate t...

Page 13 - Dispense Cold and Room Temperature Water; Dispense Hot Water and Activate the Child Safety Lock

13 Dispense Cold and Room Temperature Water NOTE: Water will take approximately 1 hour after plugging in and turning on to become completely chilled. 1� Place a drinking glass or container under the tap and press the cold water button to dispense cold water or the ambient water button to dispense ro...

Page 14 - Troubleshooting; Cleaning and Maintenance

14 Troubleshooting Problem Solution The cold water is not cold. • It takes up to one hour after setup to dispense cold water. • Make sure the power cord is properly connected to a working outlet. • Make sure the back of the dispenser is at least 20 cm from a wall and there is free airflow on all 20 ...

Page 16 - Care and Maintenance

16 Care and Maintenance • Keep this dispenser in a dry and cool place and avoid direct sunshine. • Ensure the back of the dispenser is at least 20 cm (8 in.) away from the wall. • Never put the dispenser on paper or foam, which may store water and then cause creepage. Never put anything flammable be...

Page 17 - Warranty

17 Warranty Brio (“Vendor”) warrants to the original purchaser of the Brio Water Coolers (the “Product”), and to no other person, that if the Product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, al...

Page 18 - Contact Us