Brio CLBL720SC - Manuals

6 INSTALLATION 1. Determine Installation Location A. Place the dispenser upright. B. Locate the dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet. NOTICE: Do NOT plug in the power cord until the entire installation section is completed. C. Position the back ...

7 E. Slide the water bottle into the dispenser cabinet and close the door. F. with water before attempting to use the dispenser. G. Remove air from the tanks by placing a cup under each water tap and drain at least 4 cups (1 liter) of water before initial use. NOTE: Water will not pump from the bott...

9 TROUBLESHOOTING PROBLEM SOLUTION The cold water is not cold. • It takes up to one hour after setup to dispense cold water. • Make sure the power cord is properly connected to a working outlet. • Make sure the back of the dispenser is at least 20 cm from a wall • Make sure green power switch on bac...

10 CLEANING AND MAINTENANCE Use the Self-Cleaning Ozone Feature It is highly recommended that you use the self-cleaning feature on a weekly basis to sanitize tanks and water lines. To activate the self-cleaning cycle, press in the self-cleaning switch (8), hold for 5 seconds, and release. The Ozone ...

11 WARRANTY Brio (“Vendor”) warrants to the original purchaser of the Brio Water Coolers (the “Product”), and to no other person, that if the Product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, al...