Brio CLPOU520UVRO4 User Manual

Page 2 - Table of Contents

2 Table of Contents Safety Information � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 3 Intended Use � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � ...

Page 3 - Safety Information

3 Safety Information WARNING: To reduce risk of injury and property damage, you must read this entire manual before assembling, installing, and operating the dispenser. WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause personal injury. When operating ...

Page 5 - Indicator Panel Description; Product Dimensions

5 Indicator Panel Description 1� Power/Self cleaning indicator – When illuminated, indicates that the dispenser is on. When blinking, indicates that the self-cleaning feature is operating. 2� Hot water indicator light – When illuminated, indicates that the dispenser is heating water. 3� Cold water i...

Page 6 - Package Contents; Materials Needed; Determine the Installation Location

6 Package Contents A B C D E F G H I J K Part Description Quantity Part Description Quantity A Filter flushing tube 1 G Post carbon filter 1 B Shut-off valve tube (7 ft) 1 H Feed water adapter (with extra nut) 1 C Filter housing (for filter flushing) 1 I Plumber’s tape 1 D Sediment filter 1 J Drain ...

Page 7 - Connect to the Cold Water Supply

7 2� Connect to the Cold Water Supply CAUTION: DO NOT CONNECT THIS WATER LINE TO A HOT WATER SUPPLY LINE. The water supply to the unit MUST be from the COLD WATER LINE. Using HOT WATER will severely damage your filters. A� Turn off and then disconnect the current cold water supply line. B� Connect t...

Page 8 - Make the Reverse Osmosis (RO) Waste Connections

8 3� Make the Reverse Osmosis (RO) Waste Connections A� The RO filter assembly requires a drain line connection to be installed, which removes rejected water to the sewer. The drain saddle connects the drain line from the dispenser to your drain pipe. The drain saddle is designed to fit around a sta...

Page 9 - Flush the Filters

9 4� Flush the Filters IMPORTANT: Follow this procedure for every filter during installation and every time you replace your filters. IMPORTANT: Ensure the water supply is off before you begin. A� Connect a filter (D) to the filter housing (C) by twisting the filter (D) clockwise. C D B� Connect the...

Page 10 - Install the Filters and Complete the Installation

10 5� Install the Filters and Complete the Installation A� After flushing, twist each filter clockwise into the filter housings located inside the dispenser cabinet. The sediment filter (D) goes on the left, followed by the carbon block filter (E), the RO filter (F), and the post carbon filter (G). ...

Page 11 - Operation; Turn the Dispenser On/Off; Dispense Cold Water; Dispense Room Temperature Water; Dispense Hot Water and Activate Child Safety Lock

11 Operation IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors can accumulate in the tank and lines. Dispense and dispose of at least 1 quart of water prior to drinking any water. Turn the Dispenser On/Off IMPORTANT: Before you activate ...

Page 12 - Troubleshooting Guide

12 Troubleshooting Guide Refer to the table below for possible problems and their solutions. Problem Solution The cold water is not cold. • It takes approximately 1 hour after setup to dispense cold water. • Make sure the power cord is properly connected to a working outlet. • Make sure the back of ...

Page 13 - Cleaning and Maintenance; Filter Replacement Schedule

13 Cleaning and Maintenance This dispenser runs on a continuous UV cleaning cycle. It works for 40 minutes (UV indicator light is on), turns off for 140 minutes, and then cycles back on again as long as the dispenser is plugged in and turned on. CAUTION: Before manual cleaning, always turn off hot- ...

Page 15 - Care and Maintenance; Warranty

15 Temperature 33–100 °F Temperature 33–100 °F Care and Maintenance • Keep this dispenser in a dry and cool place and avoid direct sunshine. • Ensure the back of the dispenser is at least 20 cm (8 in.) away from the wall. • Never put the dispenser on paper or foam, which may store water and then cau...

Page 17 - Contact Us