Page 2 - Table of Contents
2 Table of Contents Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Intended Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 3 - Safety Information
3 Safety Information WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling, installing and operating the dispenser. WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause personal injury. When operating th...
Page 5 - Touch Panel Description; Product Dimensions
5 Touch Panel Description 1 . Up arrow button – Press to set the time on the clock and increase temperature settings. 2 . Clock/Temperature display – Shows the time and water temperature setting when setting the temperature of the hot or cold water. Also indicates when a water bottle needs to be rep...
Page 6 - Installation; Determine Installation Location; Install the Drip Tray and Grid
6 Installation 1 . Determine Installation Location A . Place the dispenser upright. B . Locate the dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet. NOTICE: Do NOT plug in the power cord until the entire installation section is completed. C . Position the b...
Page 7 - Operation; Turn the Dispenser On/Off
7 E . Slide the water bottle into the dispenser cabinet and close the door. F . Wait 5 minutes for the water tanks to fill with water before attempting to use the dispenser. G . Remove air from the tanks by placing a cup under each water tap and drain at least 4 cups (1 liter) of water before initia...
Page 8 - Change the Water Bottle
8 Set the Cold Temperature Setting 1 . Press and hold the down arrow button for 3 seconds until the cold water button starts to blink and the current cold water temperature appears on the display. 2 . Use the up and down arrow buttons to scroll to your desired cold water temperature. The range is 39...
Page 9 - Troubleshooting
9 Troubleshooting Problem Solution The cold water is not cold. • It takes up to one hour after setup to dispense cold water. • Make sure the power cord is properly connected to a working outlet. • Make sure the back of the dispenser is at least 20 cm from a wall and there is free airflow on all 20 c...
Page 10 - Cleaning and Maintenance; Use the Self-Cleaning Ozone Feature
10 Cleaning and Maintenance Use the Self-Cleaning Ozone Feature It is highly recommended that you use the self-cleaning feature on a weekly basis to sanitize tanks and water lines. To activate the self-cleaning cycle, press in the self-cleaning switch (8), hold for 5 seconds, and release. The Ozone ...
Page 11 - Warranty
11 Warranty Brio (“Vendor”) warrants to the original purchaser of the Brio Water Coolers (the “Product”), and to no other person, that if the Product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, al...
Page 12 - Contact Us