York YCAL0041 - Manuals

YORK INTERNATIONAL 5 FORM 150.64-EG1 MILLENNIUM CONTROL CENTER All controls are contained in a NEMA 3R/12 (and equivalent to IP55*) cabinet with hinged outer door and includes: Liquid Crystal Display with Light Emitting Diode back- lighting for outdoor viewing: Two display lines Twenty characters pe...

YORK INTERNATIONAL 7 FORM 150.64-EG1 Options and Accessories POWER OPTIONS: COMPRESSOR POWER CONNECTIONS – Single- point (YCAL0041-0065) terminal block connection(s) are provided as standard. The following power connections are available as options. (See electrical data for specific voltage and optio...

YORK INTERNATIONAL 8 chilling below 30°F (-1°C) leaving brine temperature for YCAL0041 - 0065 models. Option includes resized thermal expansion valve. ( Factory-Mounted ) CHICAGO CODE RELIEF VALVES – Unit will be pro- vided with relief valves to meet Chicago code require- ments. ( Factory-Mounted ) ...

YORK INTERNATIONAL 11 FORM 150.64-EG1 GUIDE TO SELECTION Capacity ratings for YORK YCAL Packaged Air-Cooled Liquid Chillers, shown on pages 16 through 39 cover the majority of design applications for these units. For unusual applications or uses beyond the scope of this catalog, please consult your ...

YORK INTERNATIONAL 13 FORM 150.64-EG1 NOTES: 1. For leaving brine temperature below 40°F (4.4°C), contact your nearest YORK Office for application requirements.2. For leaving water temperature higher than 55°F (12.8°C), contact the nearest YORK Office for application guidelines.3. The evaporator is pr...

YORK INTERNATIONAL 14 Water Pressure Drop Note: Water Pressure Drop Curves may extend past the minimum and maximum water flow ranges. See page 13 for minimum and maximum flow points. ENGLISH 1 10 100 10 100 1000 FLOW , GPM P re s s D ro p , F t H 2 O A B C D

YORK INTERNATIONAL 30 Physical Data YCAL Model No. Dimension General Unit Data Nominal Compressor Capacity Condenser Condenser Fans, Low Sound Condenser Fans, Ultra Quiet Evaporator Length Width Height Nomi- nal Tons, R-22 Num- ber of Refrig- erant Circuits Refrigerant Charge, Operating, R-22 (lbs) ...

YORK INTERNATIONAL 32 Sound Data 60Hz Line Frequency Low Noise Fan R-22 63 125 250 500 1000 2000 4000 8000 dBA YCAL0041 92 91 92 90 86 81 77 74 92 YCAL0045 92 91 92 90 86 81 77 74 92 YCAL0051 91 92 92 91 87 82 78 75 92 YCAL0055 93 95 95 93 90 85 81 77 95 YCAL0061 93 95 95 93 90 86 82 77 95 YCAL0065 ...

YORK INTERNATIONAL 58 Isolator Selections FOR UNITS WITH ALL POINT LOADS LESS THATN 1404 LBS (637 KG) Weight Range (lbs) Weight Range (kg) Model Number Color 239 to 384 lbs 108 to 174 kg CIP-B- Red 384 to 639 lbs 174 to 290 kg CIP-B- White 639 to 851 lbs 290 to 386 kg CIP-B- Blue 851 to 1064 lbs 386...

YORK INTERNATIONAL 60 Isolator Details (cont'd) ENGLISH SIZE H T D E L HCL W HCW MBD 2-C2 8 1/2 3/8 5/8 1 3/8 14 12 1/4 5 1/4 3 1/ 2 5/8" SI SIZE H T D E L HCL W HCW MBD 2-C2 215.9 9.5 15.9 34.9 355.6 311.2 133.4 88.9 5/8" SLRS *Weight Range (lbs) Weight Range (kg) Model Number Color Up to 3...

YORK INTERNATIONAL 61 FORM 150.64-EG1 INTENTIONALLY LEFT BLANK

YORK INTERNATIONAL 62 Electrical Data 1. Minimum Circuit Ampacity (MCA) is based on 125% of the rated load amps for the largest motor plus 100% of the rated load amps for all other loads included in the circuit, per N.E.C. Article 430-24. If the optional Factory Mounted Control Transformer is provid...

YORK INTERNATIONAL 63 FORM 150.64-EG1 LEGEND ACR-LINE ACROSS THE LINE START C.B. CIRCUIT BREAKER D.E. DUAL ELEMENT FUSE DISC SW DISCONNECT SWITCH FACT MOUNT CB FACTORY MOUNTED CIRCUIT BREAKER FLA FULL LOAD AMPS HZ HERTZ MAX MAXIMUM MCA MINIMUM CIRCUIT AMPACITY MIN MINIMUM MIN NF MINIMUM NON FUSED RL...

YORK INTERNATIONAL 68 Power Wiring FIG. 1 – STANDARD POWER SUPPLY WIRING – (YCAL 0014 - 0080)

YORK INTERNATIONAL 71 FORM 150.64-EG1 CTB1 21 13 20 13 14 13 FLOW SW REMOTE START/STOP PWM INPUT LOAD LIMIT INPUT * * Factory wired with optional transformer. Control Wiring LD03611

YORK INTERNATIONAL 72 Application Data UNIT LOCATION The YCAL chillers are designed for outdoor installation. When selecting a site for installation, be guided by the following conditions: 1. For outdoor locations of the unit, select a place having an adequate supply of fresh air for the con- denser...

YORK INTERNATIONAL 74 Guide Specifications PART 1 – GENERAL 1.01 SCOPE A. The requirements of the General Conditions, Sup- plementary Conditions, Division 1, and Drawings apply to all Work herein. B. Provide Microprocessor controlled, multiple-scroll compressor, air-cooled, liquid chillers of the sch...