York B1HP024 THRU 048 - Manuals

Page 2 - Unitary Products Group

036-21528-001-A-0303 2 Unitary Products Group CONDENSATE PAN A non-corrosive, long-lasting, water-tight pan is posi- tioned below the evaporator coil to collect and drain all condensate; less collection of stagnate condensate will build-up. The condensate pan conforms to ASHRAE 62-89 standards (Vent...

Page 3 - 36-21528-001-A-0303; FIELD-INSTALLED ACCESSORIES

036-21528-001-A-0303 Unitary Products Group 3 PROTECTED COMPRESSOR The compressor is internally protected against high pressure and temperature. This is accomplished by the simultaneous operation of high pressure relief valve and a temperature sensor which protects the compres- sor, if undesirable o...

Page 5 - FIGURE 1 - UNIT CUT AWAY; TABLE 2: PHYSICAL DATA; MODELS

036-21528-001-A-0303 Unitary Products Group 5 SEER =Seasonal Energy Efficiency Ratio - the total cooling output in BTU's during a normal annual usage period for cooling divided by the total electric power input in watt-hours during the same period. COP = Coefficient of Performance - the total heatin...

Page 14 - TABLE 14: ADDITIONAL STATIC RESISTANCE

036-21528-001-A-0303 14 Unitary Products Group NOTE: Above data includes allowances for a dry indoor coil and no filters. For additional pressure drops, refer to the ìAdditional Static Pressure Resistanceî table. TABLE 13: SIDE & BOTTOM SUPPLY AIR BLOWER PERFORMANCE (208/230/460 VOLT 1 ) MODEL N...

Page 15 - FIGURE 2 - FIELD WIRING DIAGRAM

036-21528-001-A-0303 Unitary Products Group 15 FIGURE 2 - FIELD WIRING DIAGRAM R G W R C Y Y W2 C W1 O O G THERMOSTAT UNIT TERMINAL STRIP * ** ** = Minimum wire size of 18 AWG wire should be used for all field installed 24 volt wire. * = Only required on units with supplemental electric heat. PROGRA...

Page 17 - MO

036-21528-001-A-0303 Unitary Products Group 17 * KW listed is for 240 volts, use Table 15 for 208 or 230 volts. ** KW listed is for 480 volts, use Table 15 for 460 volts. TABLE 16: ELECTRICAL DATA (13 SEER HEAT PUMP / ELECTRIC HEAT) MO DE L BHP POWER SUPPLY COMPRESSOR COND FAN MOTOR FLA SUPPLY AIR B...

Page 18 - FIGURE 4 - UNIT CLEARANCES; CLEARANCES; UNIT CLEARANCES

036-21528-001-A-0303 18 Unitary Products Group TABLE 17: APPLICATION DATA MODEL BHP 024 030 036 042 048 MINIMUM AIR FLOW (CFM) COOLING 800 1000 1050 1300 1500 HEATING 800 1000 1050 1400 1400 MAXIMUM AIR FLOW (CFM) COOLING 900 1125 1200 1400 1600 HEATING 900 1125 1200 1500 1600 MINIMUM OPERATING TEMP...

Page 19 - FIGURE 5 - UNIT DIMENSIONS

036-21528-001-A-0303 Unitary Products Group 19 FIGURE 5 - UNIT DIMENSIONS

Page 20 - FIGURE 6 - TYPICAL APPLICATIONS

036-21528-001-A-0303 20 Unitary Products Group FIGURE 6 - TYPICAL APPLICATIONS

Page 21 - FIGURE 7 - ROOF CURB DIMENSIONS

036-21528-001-A-0303 Unitary Products Group 21 FIGURE 7 - ROOF CURB DIMENSIONS

Page 25 - MECHANICAL SPECIFICATIONS; GENERAL DESCRIPTION

036-21528-001-A-0303 Unitary Products Group 25 MECHANICAL SPECIFICATIONS GENERAL DESCRIPTION Units shall be factory-assembled, single packaged, Heat Pumps, designed for outdoor mounted installa- tion. Units shall have minimum SEER ratings of 13.0. They shall have built in, equal size, field converti...

Page 26 - ELECTRIC HEATING SECTION

036-21528-001-A-0303 26 Unitary Products Group B. Shall have internal isolation and sound muffling to minimize vibration and noise, and be externally iso-lated on a dedicated, independent mounting. 2. Coils: A. Evaporator and condenser coils shall have alumi- num plate fins mechanically bonded to se...