Winegard RP-RM46 - Manuals

2 CLAMP HUB TURRET BASE OUTER BEARING SCREWS (CLAMP) CRANK ASSEMBLY ELEVATE SHAFT GEAR SCREWS (TURRET) WORM SHAFT SPRING DIRECTIONAL HANDLE O-RING SPACER TURRET ASSEMBLY ROOF PLASTIC PLUG BACKUP FRAME ASSEMBLY SHAFT PIN (Referred to in #11.) FIGURE 1 EXTENSION, DIRECTIONAL HANDLE FLAT WASHER THREADE...

3 Instructions for Cutting Directional Handle Length 1. Place nut on threaded rod. 2. Measure and cut threaded rod with hack saw. Use the chart, Figure 2, to deter-mine the length. 3. Remove the nut over cut end of threaded rod. This cleans the threads after cutting. 4. Thread cut end of rod into hu...

4 Refer to drawing to identify parts. STEP 1. Release spring at base of feed arm. (This allows you to remove elevating shaft andspring without the dish popping up.) Next,lower antenna to travel position. STEP 2. Loosen set screw on elevating crank handle. Remove crank, #1 , directional handle, #2 an...