Vermont Casting 2490 - Manuals

5 Resolute Acclaim Woodburning Stove 2000893 Unused openings in an existing masonry chimney must be sealed with masonry to the thickness of the chimney wall, and the chimney liner should be repaired. Open-ings sealed with pie plates or wallpaper are a hazard and should be sealed with mortar or refra...

6 Resolute Acclaim Woodburning Stove 2000893 Single-wall Chimney Connectors • Beginning at the flue collar of the stove, assemble the chimney connector. Insert the first crimped end into the stove’s flue collar, and keep each crimped end pointing toward the stove. Using the holes in the flue collar as g...

7 Resolute Acclaim Woodburning Stove 2000893 A special piece called the “thimble sleeve,” slightly smaller in diameter than standard connector and most thimbles, will facilitate the removal of the chimney connector system for inspection and cleaning. Thimble sleeves should be available from your loc...

8 Resolute Acclaim Woodburning Stove 2000893 Accessories are available for use as wall pass-throughs. If using one of these, make sure it has been tested and listed for use as a wall pass-through. U.S.: In the United States, the National Fire Protec- tion Association (NFPA) has established guideline...

9 Resolute Acclaim Woodburning Stove 2000893 Floor Protection A tremendous amount of heat radiates from the bottom plate of your Resolute Acclaim. The floor area directly under and around the stove will require protection from radiant heat as well as from stray sparks or embers that may escape the fir...

10 Resolute Acclaim Woodburning Stove 2000893 Keep the Stove a Safe Distance From Surrounding Materials Both a stove and its chimney connector radiate heat in all directions when operating. A safe installation re-quires that adequate clearance be maintained between the stove and nearby combustible m...

11 Resolute Acclaim Woodburning Stove 2000893 5. Secure the extension plate and flue collar with the fasteners removed in the first step. Run the bolts in only finger-tight. Adjust the fit of the extension plate and/or flue collar if necessary. Tighten all four (4) fasteners, but do not overtighten them....

12 Resolute Acclaim Woodburning Stove 2000893 (A) 15” (B) 24” (C) 15” (D) 8” (E) 13” (F) 8” (380 mm) (610 mm) (380 mm) (203 mm) (330 mm) (203 mm) (G) 15” (H) 24” (I) 15” (J) 8” (K) 13” (L) 8” (380 mm) (610 mm) (380 mm) (203 mm) (330 mm) (203 mm) (M) 15” (N) 10” N/A (O) 8” (P) 7” N/A (38mm) (254 mm) ...

13 Resolute Acclaim Woodburning Stove 2000893 Stove Installed Parallel to Wall Stove Installed Parallel to Wall Stove in Corner Stove in Corner Unprotected Surfaces Protected Surfaces D E F F C C A B J K L L I I G H P Q M N N/A N/A T U V V S S Q R ST600 RESOLUTE Acclaim clearance diagram 1/25/01 Top...

14 Resolute Acclaim Woodburning Stove 2000893 Minimum Wall Shield Requirements for Common Installations H H H H D F A B E D ST6003Resolute Acclaimwall shield01/01 C G A = 26” (660 mm) B = 23” (584 mm) C = 44” (1118 mm) D = 36” (914 mm) E = 11” (279 mm) F = 43” (1092 mm) G = 47” (1194 mm) H = 1” (25 ...

15 Resolute Acclaim Woodburning Stove 2000893 Distance from the Center of the Flue Collar to the Wall in Top-Exit Installations The information on this page is helpful in planning stove placement for top-exiting installations, particularly those in-stallations with chimneys that pass through the cei...

16 Resolute Acclaim Woodburning Stove 2000893 Because of their restricted air flow and heat retention characteristics, specific construction requirements and special clearances apply to installations into alcoves. No stove or chimney connector heat shields are used in alcove installa-tions. Bottom hea...

17 Resolute Acclaim Woodburning Stove 2000893 Stove Controls Two Controls Operate the Stove The primary air control lever , located beneath the ashlip, regulates how much heat the stove produces by controlling the amount of air received by the fire. The more air supplied, the hotter the fire. (Fig. 27...

18 Resolute Acclaim Woodburning Stove 2000893 Removable Andirons For Greater Front-Loading Convenience The andirons slip into pockets cast into the front of the bottom grate and can be removed when loading through the front door. (Most Acclaim owners, however, prefer the convenience of “smokeless” t...

19 Resolute Acclaim Woodburning Stove 2000893 Use the following air control settings as a starting point to determine the best settings for your needs. Primary Air Settings Air Setting Air Control Position CLOSED Fully Left LOW Approximately 1” (25mm) to the right of CLOSED. HIGH Approximately 3”(80...

20 Resolute Acclaim Woodburning Stove 2000893 minutes at this maximum air setting to guarantee the new load of fuel has fully ignited. Once the fuel is burn-ing steadily, you may adjust the primary air supply to provide the desired heat output. You’ll soon find this stove is HOT WHILE IN OPERA- TION!...

21 Resolute Acclaim Woodburning Stove 2000893 Rules for Open Fire Viewing WARNING: FOR SAFETY AND GREATEST EFFI-CIENCY, OPERATE YOUR STOVE ONLY WITH ALL DOORS/GRIDDLES FULLY CLOSED. THE TEST STANDARD FOR YOUR STOVE WHEN IT IS OPER-ATED IN THIS MODE IS UL 1482.YOUR STOVE MAY BE USED AS A FIREPLACE WI...

23 Resolute Acclaim Woodburning Stove 2000893 Creosote Creosote is a by-product of slow wood-burning. It’s an organic tar that can condense in the flue if it’s dense in the smoke, and slow-moving, and cools off to less than 290°F. Condensed creosote is volatile, and can generate chimney fires if it ge...

24 Resolute Acclaim Woodburning Stove 2000893 Maintenance Keep Your Stove Looking New and Working Its Best Care of the Cast Iron Surface An occasional dusting with a dry rag will keep the painted cast iron of your Resolute Acclaim looking new. A damp cloth may be used as well, but only when the stov...

25 Resolute Acclaim Woodburning Stove 2000893 Repair Air Leaks to Prevent Overheating and Excessive Fuel Consumption Adjust the Door Latch The door gasket will compress after use. To restore a tight seal, adjust the tension on the latch: • Remove the Allen head button screw that attaches the door la...

26 Resolute Acclaim Woodburning Stove 2000893 Replace Broken Glass Immediately Do not operate the Resolute Acclaim if the glass is damaged. Use the following procedure for glass re-placement. NOTE: Replace glass with CFM Corpora- tion replacement glass only, available from your local dealer. • Open ...

27 Resolute Acclaim Woodburning Stove 2000893 Gaskets on Resolute Acclaim Stationary Parts 5/16” Between the flue collar and flue collar extension and the stove’s top and back: 5/16” The seal between the upper fireback corners and the lower fireback: 5/16” The seal between the underside of the top plate...

28 Resolute Acclaim Woodburning Stove 2000893 When ignited, this creosote makes an extremely hot fire within the flue system which can damage the chimney and overheat adjacent combustible material.To reduce the amount of creosote that may form, re-member to provide adequate air for combustion and to s...

29 Resolute Acclaim Woodburning Stove 2000893 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. 1 2 3 6 7 8 4 5 9 11 10 12 14 13 15 16 17 18 25 24 19 20 21 22 23 26 27 53 54 55 52 51 32 35 3...

31 Resolute Acclaim Woodburning Stove 2000893 Warranty Limited 3 Year Warranty CFM Corporation warrants that this woodburning stove will be free of defects in material and workmanship for a period of three years from the date you receive it, except that the catalyst, thermostat assembly, handles, gl...

© CFM Corporation 2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www.cfmcorp.com CFM Corporation