Vermont Casting SDV30 - Manual

Table of Contents:

• Page 2 – Stardance Direct Vent/Natural Vent Gas Heater; Table of Contents
• Page 3 – General Information; Fuels used in gas, woodburning or
• Page 4 – Stardance Direct Vent / Natural Vent Dimensions; Attention
• Page 5 – Clearance Requirements; Installation Requirements; Locating the Stove; We do not recommend the use of wallpaper; Possible stove locations.; • Always maintain required clearances
• Page 6 – Direct Vent Only; Stardance
• Page 7 – Gas Specifications; Input Input; Gas Inlet and Manifold Pressures; Stardance Direct Vent / Natural Vent; High Elevations
• Page 8 – Vertical Termination - Direct Vent ONLY; bow. No more than six elbows may be used.; Vertical vent termination window.; Unacceptable Venting; Vent Termination Clearances
• Page 9 – Location of Vent Termination
• Page 10 – General Venting Information - Termination Location; Canadian Installations
• Page 11 – Termination clearances.; Venting Requirements - Natural Vent Only; = Acceptable venting configuration; Vent termination window - Natural Vent ONLY.; Outside Corner; Termination Clearances; with no side wall; of Caps
• Page 12 – Venting Requirements and Options -; Approved Vent System Components; CFM Vent Components
• Page 13 – Install the Optional Fan; WARNING; The rheostat control switch attaches to the left side; Fan kit components.; Remove the rear skirt insert panel at the bottom of; install fan kit; Remove rear skirt insert.; attach fan; Attach the fan assembly and the snapstat.; JUV; Attach the fan rheostat.
• Page 14 – Venting System Assemlby - Direct Vent; For Canadian installations:; Install the Vent Adapter Pipe; install restrictor plate; Install the restrictor plate only if required for the vent-; Dry fit the Inner Pipe assembly to the stove for; Connect the inner starter with the next section of in-; Attach inner assembly to flue collar.; install outer adpater
• Page 15 – Discard the inner starter pipe; dura vent; Side Wall Termination Assembly; Vent Opening; CFM System; Locate vent opening.; Zero Clearance Sleeve; Assemble the wall sleeve and firestop.
• Page 16 – For DuraVent pipe only:; Determine the vertical pipe length.; measure thru wall; Measure the horizontal length.; install pipe thru wall; Install the horizontal pipe and wall plate parts.; install wall terminal; Install the vent terminal.
• Page 17 – Vent Termination Below Grade; If the; install snorkel; Snorkel kit installation.; snorkel detail; Use extension brackets to mount snorkel against; Vent Assembly
• Page 18 – vent thru ceiling; Install firestops and attic insulation shield.; vent thru roof; Roof support and flashing.; Venting System Assembly - Natural Vent; Decorative; Decorative 7” pipe may be fitted around the B-vent
• Page 19 – Install the Vent Pipe; Completed log installation.; Connect the Gas Supply Line; CAUTION
• Page 20 – Burner Information; In order to connect Natural Gas,; Air Shutter Adjustment; Model; Air Shutter Adjustment Instructions; Remove stove front.; Jefferson; Remove rear log bracket and left and right log
• Page 21 – jefferson; Air shutter adjusted.; Be sure to maintain 90° angle at left burner leg.; Complete the Assembly; attach switch assy; Attach switch assembly to rear shroud.; Attach switch wires to valve.
• Page 22 – Use only a thermostat rated for 500 millivolts.; Install the wall thermostat in the desired location and; Install the Front Plate; Install the front plate.; This completes assembly of the Stardance stove.
• Page 23 – Operation; To open the front doors, turn handle clockwise.; handle holder; When not in use, store handle in the handle holder.; Your First Fire; Pilot assembly location.; Flame & Temperature Adjustment; LO; Flame adjustment knob for Honeywell valve.; Flame Characteristics; Pilot flame; Correct pilot and burner flame patterns.
• Page 24 – FOR YOUR SAFETY READ BEFORE LIGHTING; Follow the gas supplier’s instructions.; To Turn Off Gas To Heater; Lighting and Operating Instructions; Lighting Instructions; Euro SIT; Lighting instructions
• Page 25 – Troubleshooting / Honeywell #8420 Gas Control System; SYMPTOM
• Page 26 – Comfort control valve.; Transmitter diagram.
• Page 27 – LED Count; Pilot; Valve; Comfort valve wiring diagram.
• Page 28 – Local Path
• Page 29 – Auto Path; If the setting is; above; If the settings is; below
• Page 30 – Fuel Conversion Instructions; attach gas line; Attach the gas line to the left side of the valve.; Conversion Precautions; Remove the rear log bracket and left and right log
• Page 31 – Remove mounting screws, pressure regulator tower; SIT; Pilot Orifice Conversion; gas conversion; Pilot type 2; Gas Conversion; Gas Conversion; Remove pilot orifice.
• Page 32 – Depress and turn center plunger.; injector orifice; Remove and replace injector orifices.; Table 2. Injector Orifice Size Matrix
• Page 33 – Maintenance; Annual System Inspection; ERATE THE HEATER WITH DAMAGED LOGS.; Care of Cast Iron; Remove the stove front.
• Page 34 – Release the latches to release the glass frame.; Gasket Replacement; Determine the correct length of gasket by laying it; glass gasket detail; Wrap the gasket material around the outside iedge of; Inspect the Vent System Annually; Correct flame pattern.; Stove Disassembly
• Page 35 – Wiring Diagrams; Thermostat; On/Off switch and optional thermostat circuit.; Draft hood adapter wiring.; AN; BLK; FK26 wiring diagram; Schematic Diagram; Stardance fan circuit.
• Page 39 – Optional Accessories; Fan Kits
• Page 42 – BASIC WARRANTY; IF WARRANTY SERVICE IS NEEDED...; ) Contact your supplier. Make sure you have your warranty,; LIMITED LIFETIME WARRANTY; PRODUCT COVERED BY THIS WARRANTY
• Page 43 – GARANTIE DE BASE; SI UN SERVICE SOUS GARANTIE EST REQUIS...; GARANTIE À VIE LIMITÉE; PRODUIT COUVERT PAR LA PRÉSENTE GARANTIE
• Page 44 – Efficiency Ratings; CFM Corporation