Vermont Casting SNV30 - Manual

Table of Contents:

• Page 2 – Stardance Natural Vent Gas Heater; Table of Contents
• Page 3 – Completion of sale, nor for purpose of resale,; General Information
• Page 4 – Stardance fully assembled; Stardance dimensions.; Stardance Natural Vent Gas Heater Dimensions
• Page 6 – Venting Requirements and Options; Input
• Page 7 – Passing Through a; It is essential to seal between the ceil-; Ceiling pass thru; A ceiling pass-through, with decorative pipe around the; Venting Requirements; Venting Runs; NOTE: When venting staight vertical, without an; (Measured from top of the unit before any elbow
• Page 8 – Remove the snapstat and grommet from the bracket; WARNING; Install the Optional Fan; Installation; Unpack the Stove; Attach the fan assembly to the fan bracket.; CAUTION
• Page 9 – JUV; Venting System Assembly; attach
• Page 10 – Install decorative pipe over the B-vent pipe.; Paint Option for Enamelled Stoves; Gas connection should be made in ac-
• Page 11 – Burner Information; In order to connect Natural Gas,; Install ON/OFF Switch; attach switch assy; Attach switch assembly to rear shroud.; THIS APPLIANCE SHOULD BE CON-; attach switch; Attach switch wires to valve.; Install the Log Set; Thermostat
• Page 12 – Install the Front Plate; This completes assembly of the Stardance stove.; Completed log installation.; Stardance; Install the front plate.
• Page 13 – To open the front doors, turn handle clockwise.; Operation; Your First Fire; handle holder; When not in use, store handle in the handle holder.; Pilot Assembly location.; Flame & Temperature Adjustment; Flame adjustment knob for Honeywell valve.; Correct pilot and burner flame pattern.
• Page 14 – FOR YOUR SAFETY READ BEFORE LIGHTING; WHAT TO DO IF YOU SMELL GAS; To Turn Off Gas To Heater; Lighting and Operating Instructions; Lighting Instructions; Euro SIT
• Page 15 – Troubleshooting / Honeywell #8420 Gas Control System; SYMPTOM
• Page 16 – Conversion Precautions; Fuel Conversion Instructions; Remove rear log bracket and left and right log; Attach the gas line to the left side of the valve.
• Page 17 – Remove mounting screws, pressure regulator tower; SIT; Pilot Orifice Conversion; Install the conversion orifice.; Gas Conversion; Remove pilot orifice.; Be sure burner leg remains at a 90° angle to; LP air shutter settings.
• Page 18 – Remove and replace injector orifices.; injector orifice; Conversion to LP; Table 2. Injector Orifice Size Matrix
• Page 19 – Maintenance; ERATE THE HEATER WITH DAMAGED LOGS.; painted surfaces; Remove the Stove Front.
• Page 20 – Gasket Replacement; Determine the correct length of gasket by laying it; Inspect the Vent System Annually; glass gasket detail; Wrap the gasket material around the outside edge of; Stove Disassembly; Correct flame pattern.; Release the latches to release the glass frame.
• Page 21 – Safety Limit Switch wiring.; rdv connections diag.; Schematic Diagram; Wiring Diagrams; On/off switch and optional thermostat circuit.; wiring
• Page 22 – Stardance Natural Vent Gas Heater (SNV30); SDV30 Log Set Assembly
• Page 24 – Refer to Enamel Parts Chart Page 24
• Page 25 – Optional Accessories Available; Fan Kits; To open doors, insert handle and turn. Store handle; Screen install; Hold screen at an angle to attach bottom hangers.
• Page 26 – Screen in place; Warming Shelf; Decorative Rings; Model; Outside Air Adapter
• Page 30 – IF WARRANTY SERVICE IS NEEDED...; ) Contact your supplier. Make sure you have your warranty,; LIMITED LIFETIME WARRANTY; PRODUCT COVERED BY THIS WARRANTY
• Page 31 – SI UN SERVICE SOUS GARANTIE EST REQUIS...
• Page 32 – Efficiency Ratings; CFM Corporation