Vermont Casting 2080 - Manuals

5 WinterWarm Small Insert 2000888 When the insert is installed in a factory-built fire-place: • The factory-built chimney must meet type HT requirements of UL 103, ULC S629M or UL 127- 1988, or be re-lined from the insert to the chimney top. General Considerations / U.S. • While not required in most ...

6 WinterWarm Small Insert 2000888 A,I B C D,J E D,J H C E FP1084 winterwarm fireplace minimum dimensions 3/01 Fireplace Minimums A. Width at Face 26 ¹⁄₂ ” (673mm) B. Width at 9” depth 26 ¹⁄₂ ” (673mm) C. Depth 1 14 ¹⁄₂ ” (370mm) D. Height at Face 21 ¹⁄₂ ” (540mm) E. Height at 15 ¹⁄₂ ” depth 21 ¹⁄₂ ”...

7 WinterWarm Small Insert 2000888 The approved construction of a floor protector calls for a minimum of 24 gauge galvanized sheet metal or equivalent such as 7/16” Durock ® or Wonderboard ® or other listed floor protector. The floor protector may be covered with a noncombustible decorative material if ...

8 WinterWarm Small Insert 2000888 3. Install the Chimney Connector Starter Pipe. (Not supplied) • Mark and drill two 5/16”, (8mm) holes 1 ⁵⁄₈ ” (41mm) from the lower edge of the pipe. Locate the holes on an axis that will be perpendicular to the fireplace opening when the pipe is installed. (Fig. 6) ...

9 WinterWarm Small Insert 2000888 Operation Your WinterWarm Insert’s Controls and What They Do All WinterWarm Small Insert controls are conveniently located on the front. (Fig. 8)Three controls regulate the performance of your Winter-Warm Small Insert:The primary air control supplies oxygen for the ...

10 WinterWarm Small Insert 2000888 The Fans Two fans deliver a steady stream of warm air into the room. Use the fall-away handle, (used to operate the damper), to control fan settings. (Fig. 11)The fan speed should be set at “low” when operating at low to medium burn rates. The fan speed may be set ...

11 WinterWarm Small Insert 2000888 How To Build and Sustain a Wood Fire A WinterWarm Small Insert leaves the factory with the combustor installed.In the United States, it is against the law to operate this wood heater in a manner inconsistent with operating instructions in this manual, or if the cat...

12 WinterWarm Small Insert 2000888 Follow these guidelines as you start and maintain the fire, and remove the ashes.1. Open the stove damper, and open the primary air control fully. 2. Lay some crumpled newspapers on the bottom grate. Place on the paper six or eight pieces of dry, finely-split kindlin...

13 WinterWarm Small Insert 2000888 In Fireplace Insert installations, over-sized chimneys can produce less effective results than those that are properly sized, and interior chimneys usually perform better than those located outside the house.Different results may be experienced even in the same ins...

14 WinterWarm Small Insert 2000888 Maintenance Keep Your WinterWarm Small Insert Look- ing New and Working Its Best Care of the Cast Iron Surface An occasional dusting with a dry rag will keep the painted cast iron of your WinterWarm Small Insert look-ing new. If the paint needs retouching, first all...

15 WinterWarm Small Insert 2000888 Adjust the Damper as Needed Examine your WinterWarm Small Insert’s damper after the first 50 hours of use and adjust it if necessary. Thereafter, check the damper at least once a year and adjust as needed.To inspect how well the damper seals, first make sure the fire ...

16 WinterWarm Small Insert 2000888 How to Replace Gaskets Your WinterWarm Small Insert uses rope-type fiber-glass gaskets to make a tight seal between some parts. With use, particularly on those parts that move, gaskets can become brittle and compressed and can begin to lose their effectiveness. Thes...

17 WinterWarm Small Insert 2000888 Care of the Catalytic Combustor Your wood heater contains a catalytic combustor which should be inspected regularly and replaced periodically to ensure proper operation. It is illegal in the United States to operate this wood heater in a manner inconsistent with op...

19 WinterWarm Small Insert 2000888 • Disconnect the flue liner or vent connector from the flue collar of the stove. • Slide the firechamber forward until you have ac-cess to the fireplace opening. • Inspect the flue. You can now inspect the smoke shelf area and the chimney. Before replacing the WinterWar...

20 WinterWarm Small Insert 2000888 Appendix: Catalytic Combustor In any chemical reaction, including the combustion process, there are certain conditions which must be met before the reaction can take place. For example, a reaction may require a certain temperature, or a certain concentration of the...

21 WinterWarm Small Insert 2000888 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. 23 9 55 56 57 54 29 11 31 8 7 25 33 27 35 36 24 13 61 10 47 30 6 12 15 14 14 28 32 26 24 4 1 34 40 19 20 ...

22 WinterWarm Small Insert 2000888 WinterWarm Small Insert Model 2080 (continued) Item Description Part Number 25. Coil & Shaft, Thermostat Assy. 5003733 26. Side Trim Panel See Chart Pg. 22 27. Thermostat Cover 1301304 28. Gate Frame II 1301357 29. Left Burnplate 1301338 30. Right Burnplate 130...

23 WinterWarm Small Insert 2000888 Warranty Limited 3 Year Warranty CFM Corporation warrants that this woodburning stove will be free of defects in material and workmanship for a period of three years from the date you receive it, except that the catalyst, thermostat assembly, handles, glass door pa...

© CFM Corporation 2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www.cfmcorp.com CFM Corporation