Vanguard SBVBN(C) - Manuals

Page 2 - CAST IRON STOVE AND BURNER SYSTEM; WARNING: Any change to; WARNINGS; DANGER: Carbon monoxide; Carbon Monoxide Poisoning:

2 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) SAFETYINFORMATION 1. This appliance is only for use with thetype of gas indicated on the rating plate.This appliance is not convertible for usewith other gases unless a certified kitis use...

Page 3 - OWNER’S MANUAL; American National Standards Institute, Inc.; LOCAL CODES; OPERATION

3 106828 OWNER’S MANUAL For more information, visit www.desatech.com P IL O T LO HI OFF ON PRODUCTIDENTIFICATION Install and use stove and burner system withcare. Follow all local codes. In the absenceto local codes, use the current National FuelGas Code ANS Z223.1, also known asNFPA 54* (USA) or th...

Page 4 - Figure 3 - Clearances for Standard Installation; CAUTION: This stove with; Figure 4 - Clearance for Corner Installation

4 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) LOCATION AND SPACEREQUIREMENTS Determine the safest and most efficient loca-tion for your Vanguard B-vent cast ironstove. Make sure that rafters and wall studsare not in the way of the ven...

Page 5 - STOVE BODY ASSEMBLY; Remove plastic bag from stove body.; Figure 7 - Laying Down Stove On Side; Continued; Figure 9 - Locating Threaded Holes for Legs and Door Attachment

5 106828 OWNER’S MANUAL For more information, visit www.desatech.com PalletWoodBolted toBottom ofStoveBody STOVE BODY ASSEMBLY 1. Lift off corrugated box enclosing stovebody crating. 2. Remove all screws fastening the woodframe enclosure. Spread wood frame openand lift away from plastic-bagged stove...

Page 6 - Figure 11 - Attaching Stove Door

6 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) CAST IRON STOVEAND B-VENTBURNER SYSTEMASSEMBLY Continued Figure 11 - Attaching Stove Door StepBolt DoorHinge ThreadedHole StoveDoor BoltShoulder Adjusting Nut Bolt Stop Catch Bolt Door Cla...

Page 7 - Figure 16 - Removing Rear Cover and Bottom Cover from Stove Body

7 106828 OWNER’S MANUAL For more information, visit www.desatech.com CAST IRON STOVEAND B-VENTBURNER SYSTEMASSEMBLY Continued INSTALLING B-VENTBURNER SYSTEM INTOSTOVE BODY 1. Carefully lift burner system and placeinto stove body from the rear of stove. 2. Place the left and right grate tops into the...

Page 8 - INSTALLING REAR COVER; WARNING: Never touch the; Figure 18 - Blower Wiring Layout; Green Ground Wire

8 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) INSTALLING REAR COVER 1. Place rear cover behind stove body.Rear cover will rest on the bottom ledgeof the stove body. 2. Pl ace wi re harness fro m ON/ OF Fswitch under the cast of stove ...

Page 9 - Figure 20 - Control Valve Terminals; INSTALLATION PRECAUTIONS; WARNING: This gas stove with; Round Top

9 106828 OWNER’S MANUAL For more information, visit www.desatech.com CAST IRON STOVEAND DIRECT-VENTBURNER SYSTEMASSEMBLY Continued Figure 20 - Control Valve Terminals To ControlSwitch INSTALLATION PRECAUTIONS Consult local building codes before begin-ning the installation. Only a qualified ser-vice ...

Page 10 - CHECKING VENT CAPACITY; Figure 25 - Test for Proper Venting; When installing in a chase, you should; WARNING: Installation should; Figure 24 - Venting Through a Side Wall

10 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) CHECKING VENT CAPACITY Complete all gas piping, electrical, and ventconnections. After adjusting the burner sys-tem and lighting the main burners, allow acouple of minutes for warm-up. Ho...

Page 12 - CHECK GAS TYPE; • Using a draft meter to determine if; FLUE GAS SPILLAGE

12 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) CAST IRON STOVEAND B-VENTBURNER SYSTEMINSTALLATION INSTALLING GAS PIPING TOSTOVE LOCATION WARNING: A qualified in- staller or service person mustconnect burner system to gassupply. Follow...

Page 13 - Installation Items Needed; Figure 29 - Gas Connection; Cap Pipe Nipple Tee Joint

13 106828 OWNER’S MANUAL For more information, visit www.desatech.com CAUTION: Use only new, black iron or steel pipe. Inter-nally-tinned copper tubing maybe used in certain areas. Checkyour local codes. Use pipe of 1/2"diameter or greater to allowproper gas volume to burner sys-tem. If pipe is ...

Page 14 - Figure 31 - Equipment Shutoff Valve; WARNING: Never use an open; Open lower door panel.; Figure 30 - Flexible Gas Line

14 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) Test Pressures Equal To or Less Than1/2 PSIG (3.5 kPa) 1. Close equipment shutoff valve (seeFigure 31). 2. Pressurize supply piping system by ei-ther opening propane/LP supply tankvalve f...

Page 15 - Figure 32 - Checking Gas Joints for Propane/LP Gas Burner System; Gas Valve; Figure 33 - Checking Gas Joints for Natural Gas Burner System; Figure 34 - Control Valve Terminals; WARNING: Installation must

15 106828 OWNER’S MANUAL For more information, visit www.desatech.com Figure 32 - Checking Gas Joints for Propane/LP Gas Burner System Propane/LP SupplyTank EquipmentShutoffValve Gas Valve EquipmentShutoffValve Gas Valve Gas Meter Figure 33 - Checking Gas Joints for Natural Gas Burner System Continu...

Page 16 - Installing Remote Receiver; Open bottom door on stove body.; Figure 37 - Installing Battery in Receiver; Receiver; Figure 38 - Installing Remote Receiver; WARNING: Do not connect; The wire; Figure 35 - Back View of Thermostat Base; Terminal “W”; Set the temperature adjustment to the

16 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) INSTALLING OPTIONALWIRELESS HAND-HELDREMOTE CONTROLACCESSORIES - GHRC ANDGHRCTA SERIES Installing Remote Receiver 1. Open bottom door on stove body. 2. Disconnect wires from THTP and THon...

Page 17 - CAUTION: Do not operate this

17 106828 OWNER’S MANUAL For more information, visit www.desatech.com REMOVING/REPLACINGGLASS DOOR CAUTION: Do not operate this burner system with a brokenglass door panel or without theglass door panel securely inplace. For replacement part in-f o r m a t i o n s e e R e p l a c e m e n t Parts, pa...

Page 18 - WARNING: Failure to position

18 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) CAST IRON STOVEAND B-VENTBURNER SYSTEMINSTALLATION Continued It is very important to install these logsexactly as instructed in Figures 43 through47 . Do not modify logs. Only use logssup...

Page 19 - Figure 48 - Control Valve; Piezo Ignitor

19 106828 OWNER’S MANUAL For more information, visit www.desatech.com TO TURN OFF GAS TO APPLIANCE 1. Set ON/OFF switch located on rearcover to “OFF”. 2a. Open lower panel. 2b. If Using Optional Hand-Held Remote: Set selector switch in the OFF posi-tion to prevent draining battery. 3. Turn off all e...

Page 20 - OPTIONAL REMOTE; Thermostat Control Operation; Lighting; GHRC Series Operation:; Flame Adjustment Knob; Shows Temperature Setting

20 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) 1. After lighting, let pilot flame burn forabout one minute. Turn control knobon the control valve to ON position.Turn flame adjustment knob any-where between HI and LO. Slide theselector...

Page 21 - • turn burner system off (see To Turn Off; Figure 51 - Pilot Assembly; Thermopile

21 106828 OWNER’S MANUAL For more information, visit www.desatech.com INSPECTINGBURNERS Check pilot flame pattern and burner flamepatterns often. PILOT ASSEMBLY The pilot assembly is factory preset for theproper flame height. Alterations may haveoccurred during shipping and handling. Calla qualified...

Page 22 - WARNING: Turn off burner; GLASS DOOR; CAUTION: Wear gloves and; LOGS; ment Parts on page 26.; VENTING SYSTEM

22 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) CLEANING ANDMAINTENANCE WARNING: Turn off burner s y s t e m a n d l e t c o o l b e f o r ecleaning. CAUTION: You must keep con- trol areas, burners, and circulat-ing air passageways of ...

Page 23 - TROUBLESHOOTING; POSSIBLE CAUSE; nance, page 22) or replace pilot assembly; OBSERVED PROBLEM

23 106828 OWNER’S MANUAL For more information, visit www.desatech.com TROUBLESHOOTING Note: All troubleshooting items are listed in order of operation. WARNING: Turn off burner system and let cool before ser-vicing. Only a qualified serviceperson should service and repairheater. CAUTION: Never use a...

Page 24 - tenance, page 22) or replace burner orifice

24 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) OBSERVED PROBLEM Burner does not light after pilot is lit Delayed ignition burner Burner backfiring during combustion Slight smoke or odor during initial operation Heater produces a whist...

Page 26 - SERVICE HINTS; When Gas Pressure is Too Low:; WIRING DIAGRAM; CAUTION: Label all wires prior; PARTS UNDER WARRANTY

26 ® CAST IRON STOVE AND BURNER SYSTEM 106828 For more information, visit www.desatech.com SBVBN(C) AND SBVBP(C) SERVICE HINTS When Gas Pressure is Too Low: • pilot will not stay lit• burners will have delayed ignition• burner system will not produce specified heat • propane/LP gas supply might be l...

Page 27 - SPECIFICATIONS

27 106828 OWNER’S MANUAL For more information, visit www.desatech.com SPECIFICATIONS SBVBN(C) SBVBP(C) 21,000-30,000 Btu/h 20,000-28,000 Btu/h Gas Type Natural Propane/LP Ignition Piezo Piezo Manifold Pressure 3.5" w.c. 10.0" w.c. Minimum Inlet Supply Pressure 4.5" w.c. 11.0" w.c. Th...

Page 29 - PART NUMBER; PARTS LIST

29 106828 OWNER’S MANUAL For more information, visit www.desatech.com KEYNO. PART NUMBER DESCRIPTION QTY. 1 106796-01BR Firebox Assembly 1 2 105795-01 Glass Door Assy 1 3 106836-02CK Rear Cover 1 4 M11084-46 Screw, Hex 11 5 107013-01 Center Cast Grate 1 6 099998-01 On/Off Switch 1 7 103284-07 Wire H...

Page 31 - KEY; Bottom Door (Porcelain Enamel Teal Green); PARTS AVAILABLE — NOT SHOWN; Touch-up Paint Bottle with Brush (Porcelain Enamel Teal Green)

31 106828 OWNER’S MANUAL For more information, visit www.desatech.com PARTS LIST AMITY™SCIVFC(*) SERIESPSCIVFC(*) SERIES (* Indicates Color Suffix Designation) This list contains replaceable parts used in your stove. When ordering parts, follow the instructionslisted under Replacement Parts on page ...

Page 32 - For information about this warranty write:; INTERNATIONAL; KEEP THIS WARRANTY; WARRANTY INFORMATION; Model; NOT A UPC

LIMITED WARRANTY B-VENT BURNER SYSTEM AND AMITY ™ STOVE CHASSIS DESA International warrants this product to be free from defects in materials and components for four (4) years from the date of firstpurchase, provided that the product has been properly installed, operated and maintained in accordance...