US Stove Company 6039 - Manuals

US Stove Company 6039 – Manual in PDF format online.

Manuals:

Manual

Manual US Stove Company 6039

Summary

Page 2 - Heat Output, Maximum; SPECIFICATIONS; American Harvest Multifuel Pellet; You've purchased one of America's Finest Multifuel Burning

2 USSC Heat Input, Maixmum 52,200 BTU/HR Heat Output, Maximum , , , , , 48,280 BTU/HR Heating Capacity 1,200 Sq. Ft 0 Fuel Storage Capacity 60 Lbs. Width 29 in./737mm Height 31 in./787mm Depth 28 in./711mm SPECIFICATIONS United States Stove Company ( manufacturer of the American Harvest Multifuel Pe...

Page 3 - Assembly; Initial burn off may cause slight smoke and

USSC 3 6039&6039T ASSEMBLY Assembly 1. Unpack unit and make sure all components are included; (4) Legs, (2) Ash Pan Guide Rails and all hardware for installation.2. Inside the unit are two(2) Ash Dump Covers located to the left and right of the burnpot. Remove these for leg and guiderail assembl...

Page 4 - SAFETY STEPS; permits or inspection guidelines before installing the product.; DISCONNECT THE POWER CORD BEFORE SERVICING THIS STOVE!; BURNING SOLID FUELS

4 USSC Ashes will have to be Removed from the stove periodically. See cleaning procedure. Your American Harvest stove, due to the nature of solid fuels, will require brief periodic attention. Please do not expect to light your stove and walk away from it. A few moments of adjustment and cleaning fro...

Page 5 - FLOOR PROTECTION; INSTALLATION REQUIREMENTS; SHELLED CORN; WOOD PELLETS; CAUTION: DO NOT PLACE SUCH FUELS WITHIN THE SPACE HEATER’S INSTALLA-

USSC 5 FLOOR PROTECTION The American Harvest Multifuel Stove may be installed on a combustible floor, with proper floor protection, or on a masonry hearth. The hearth or noncombustible floor protector must extend a minimum of (6) inches (152mm)in front and (6) inches (152mm) from each side of the as...

Page 6 - CLEARANCES TO COMBUSTIBLES; SIDE WALL; BACK WALL

6 USSC CLEARANCES TO COMBUSTIBLES The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. The amount of room needed on the left side of the unit to access th...

Page 7 - GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN; DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM

USSC 7 GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN • • • •• • • • A UL listed 3” or 4” type “PL” pellet vent exhaust system must be used for installation and attached to the pipe connector provided on the back of the stove. Use a 3” to 4” adapter for 4” pipe. A cap must be used at the termination ...

Page 8 - DESIGN GUIDELINES FOR OUTSIDE COMBUSTION AIR CONNECTION; 0 DEGREE BEND TERMINATION; Wind Hood

8 USSC For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated it is required to install outside combustion air. Connection to outside the house is REQUIRED fo...

Page 9 - FREESTANDING STOVE INSTALLATION REQUIREMENTS; MOBILE HOME INSTALLATION REQUIREMENTS; REQUIREMENTS ARE MANDATORY FOR INSTALLATION IN A MOBILE HOME:; WARNING; DO NOT INSTALL IN SLEEPING ROOM; CAUTION; ROOF MUST BE MAINTAINED.; Check with your local building official as other codes may apply.; INSTALLATION CONFIGURATIONS

USSC 9 Locate proper position for the type “PL” wall thimble (F).Use a saber saw or keyhole saw to cut a 7 1/4-inch diameter hole through the wall (E) for a 3-inch pipe. For a 4-inch pipe, cut an 8 1/4-inch hole. Install the wall thimble (F)in the hole. The size of hole opening will vary with brand ...

Page 10 - ’ Minimum

10 USSC Note: Always check dimensions on unit before cutting hole in wall 3’ Minimum Vertical Pipe Dimensional tolerance ±0.25” 12 1/8 11 3/4 10 1/16 EXHAUST OULET 3" DIA. COMBUSTION AIR INTAKE 1 7/8" DIA. 10 1/16 11 5/8 12 EXHAUST OUTLET 3' DIA COMBUSTION AIR INTAKE 1 7/8" DIA 6039 - PE...

Page 12 - REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS; CLEANING THE GLASS; GLASS MAINTENANCE, REMOVAL AND REPLACEMENT; GLASS CLIPS

12 USSC Your American Harvest Corn/Pellet Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (2) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and ...

Page 13 - LIGHTING INSTRUCTIONS; Air/Fuel Control Adjustment

USSC 13 LIGHTING INSTRUCTIONS CAUTION: DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS. • • •• • •• • • Before lighting your American Harvest for the first time, make sure that all items are out of the ...

Page 14 - MAINTENANCE INSTRUCTIONS; Daily Maintenance; Soot and Flyash - Formation and Need for Removal; DISPOSAL OF ASHES; Disposal of Ashes

14 USSC SPECIAL CLEANING/OPERATIONAL INSTRUCTIONS:After cleaning or when operating the stove, you need to make sure that “both” clean-outs are in their proper position. If left out or placed incor- rectly, the combustion air is effected greatly and the stove will not burn properly. MAINTENANCE INSTR...

Page 15 - FUEL ADDITIVE; These automatic safety features must not be bypassed; AUTOMATIC SAFETY FEATURES; Weekly Maintenance

USSC 15 FUEL ADDITIVE Chicken Scratch for my Corn Burner?Yes - Crazy as it may sound, ground Oyster Shells, (calcium carbonate) same as fed to chickens, is the ideal additive to promote clean burning, especially when the Corn Fuel is extra high in starch. And it’s available at your local Feed and Se...

Page 16 - CIRCUIT BOARD FUNCTIONS; START-UP SEQUENCE OF EVENTS; as a preset temperature is achieved.

16 USSC COMPONENT OPERATION START OPERATION END CIRCUIT BOARD FUNCTIONS START-UP SEQUENCE OF EVENTS Once the control panel is turned to on, a timer begins that will start, stop and continue operation of the American Harvest as a preset temperature is achieved. Exhaust Blower Agitator Auger Room Fan ...

Page 17 - SHUTDOWN SEQUENCE OF EVENTS; Once the; has reached the normal operating temperature and switched to; AMERICAN HARVEST; “LOW LIMIT SAFTEY” sensor tells the; HOT parts. Do not operate the unit with panel open.

USSC 17 Exhaust Blower Agitator Auger Room Fan Automatic Shutdown COMPONENT SHUTDOWN OPERATION END CIRCUIT BOARD FUNCTIONS continued... SHUTDOWN SEQUENCE OF EVENTS Once the AMERICAN HARVEST has reached the normal operating temperature and switched to the “OFF” position, the unit will continue to ope...

Page 18 - TROUBLE SHOOTING; Unplug stove before performing any maintenance; PROBLEM

18 USSC TROUBLE SHOOTING Unplug stove before performing any maintenance PROBLEM CAUSE: Too rich air/fuel mixture ? Fire burns with a lazy, orange flameand/or fuel builds up in the firepot.Glass may become dirty. ? Fire goes out or stove shuts down.Fuel may stop feeding. ? Fire goes out or stove shut...

Page 19 - WIRING DIAGRAM

Page 23 - Notes

Page 24 - THE PART DESCRIPTION; HOW TO ORDER REPAIR PARTS; United States Stove Company

24 USSC THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPEND-ABLE SERVICE FROM YOUR AMERICAN HARVEST, AND EN-ABLE YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFER-ENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBERWHICH IS ON THE NAMEPLATE ATTACHED TO THE HEATER...