US Stove Company 6037 - Manuals

US Stove Company 6037 – Manual in PDF format online.

Manuals:

Manual

Manual US Stove Company 6037

Summary

Page 2 - SPECIFICATIONS; American Harvest Multifuel Pellet; You've purchased one of America's Finest Multifuel Burning; Heat Output

2 USSC SPECIFICATIONS United States Stove Company ( manufacturer of the American Harvest Multifuel Pellet Stove ) reserves the right to alter products, specifications and price without notice. Safety Tested & Listed to ASTM- E 1509, ULC-C 1482, (UM) 84-HUD, by OMNI Test Laboratories,Inc., Beaver...

Page 3 - SAFETY STEPS; permits or inspection guidelines before installing the product.; BURNING SOLID FUELS

USSC 3 Ashes will have to be Removed from the stove periodically. See cleaning procedure. You can minimize cleaning required and maximize efficiency by maintaining the correct draft settings. See “Setting the Draft” further in the manual. The draft setting on your stove may have to be changed from t...

Page 4 - FLOOR PROTECTION; INSTALLATION REQUIREMENTS; SHELLED CORN; CAUTION: DO NOT PLACE SUCH FUELS WITHIN THE SPACE HEATER’S INSTALLA-

4 USSC FLOOR PROTECTION The American Harvest Multifuel Stove may be installed on a combustible floor, with proper floor protection, or on a masonry hearth. The hearth or noncombustible floor protector must extend a minimum of (6) inches (152mm)in front and (6) inches (152mm) from each side of the as...

Page 5 - CLEARANCES TO COMBUSTIBLES; SIDE WALL; BACK WALL

USSC 5 CLEARANCES TO COMBUSTIBLES The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. The amount of room needed on the left side of the unit to access th...

Page 6 - DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM; GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN

6 USSC NOTE: These are guidelines only. Proper venting is accomplished by design and common sense. In most installations 3” inch diameter venting is adequate. If it does not vent properly you will have to change it to 4”. DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM GUIDELINES FOR EXHAUST V...

Page 7 - DESIGN GUIDELINES FOR OUTSIDE COMBUSTION AIR CONNECTION; 0 DEGREE BEND TERMINATION; Wind Hood

USSC 7 For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated it is required to install outside combustion air. Connection to outside the house is REQUIRED fo...

Page 8 - MOBILE HOME INSTALLATION REQUIREMENTS; REQUIREMENTS ARE MANDATORY FOR INSTALLATION IN A MOBILE HOME:; WARNING; DO NOT INSTALL IN SLEEPING ROOM; CAUTION; ROOF MUST BE MAINTAINED.; Check with your local building official as other codes may apply.; INSTALLATION CONFIGURATIONS

8 USSC Note: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA -B365 The American Harvest Corn/Pellet Stove Model 6037 may be installed as follows: 1) A freestanding unit MOBILE HOME INSTALLATION REQUIREMENTS IN ADDITION TO T...

Page 9 - FREESTANDING STOVE INSTALLATION REQUIREMENTS; Horizontal Exhaust Termination:; ’ Minimum

USSC 9 Locate proper position for the type “PL” wall thimble (F).Use a saber saw or keyhole saw to cut a 7 1/4-inch diameter hole through the wall (E) for a 3-inch pipe. For a 4-inch pipe, cut an 8 1/4-inch hole. Install the wall thimble (F)in the hole. The size of hole opening will vary with brand ...

Page 11 - REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS; CLEANING THE GLASS; GLASS MAINTENANCE, REMOVAL AND REPLACEMENT; GLASS CLIPS

USSC 11 Your American Harvest Corn/Pellet Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (4) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and ...

Page 12 - STOVE CONTROLS

12 USSC STOVE CONTROLS Adjustable Door Handle lifts up and turns left to open. Ash Dump Shutoff Pull out to empty ashes out of the firebox area. Make sure to push all the way in when done. Front View Left/Front View Circuit Board Control Panel Manual Draft Adjustment Slide in or out to adjust the am...

Page 13 - LIGHTING INSTRUCTIONS; Damper Control Function

USSC 13 LIGHTING INSTRUCTIONS CAUTION: DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS. • • •• • • • • • • • • Before lighting your American Harvest for the first time, make sure that all items are out ...

Page 14 - SETTING THE DRAFT; Daily Maintenance; Soot and Flyash - Formation and Need for Removal; DISPOSAL OF ASHES; Disposal of Ashes

14 USSC SETTING THE DRAFT A proper draft setting is crucial to the successful burning of solid fuels. Draft refers to the amount of air flowing through the burn chamber of your stove. Too much or too little draft will cause your stove to burn improperly and may result in the fire burning out or exce...

Page 15 - Weekly Maintenance

USSC 15 The 6037 has (2) front cleanout slides that must be in the closed position when burning the unit. • • •• • Set the stove on high fire. Open the draft to 100% and allow the stove to burn for 15 minutes. Resume desired heat and draft setting.Shut down the stove as directed in the operating ins...

Page 16 - FUEL ADDITIVE; These automatic safety features must not be bypassed; AUTOMATIC SAFETY FEATURES

16 USSC FUEL ADDITIVE Chicken Scratch for my Corn Burner?Yes - Crazy as it may sound, ground Oyster Shells, (calcium carbonate) same as fed to chickens, is the ideal additive to promote clean burning, especially when the Corn Fuel is extra high in starch. And it’s available at your local Feed and Se...

Page 17 - CIRCUIT BOARD FUNCTIONS; START-UP SEQUENCE OF EVENTS; as a preset temperature is achieved.

USSC 17 COMPONENT OPERATION START OPERATION END CIRCUIT BOARD FUNCTIONS START-UP SEQUENCE OF EVENTS Once the control panel is turned to one of the five heat settings, a timer begins that will start, stop andcontinue operation of the American Harvest as a preset temperature is achieved. Exhaust Blowe...

Page 18 - SHUTDOWN SEQUENCE OF EVENTS; Once the; has reached the normal operating temperature and switched to; AMERICAN HARVEST; “LOW LIMIT SAFTEY” sensor tells the; When performing any internal electrical maintenance; HOT; parts. Do not operate the unit with panel open.

18 USSC Exhaust Blower Agitator Auger Room Fan Automatic Shutdown COMPONENT SHUTDOWN OPERATION END CIRCUIT BOARD FUNCTIONS continued... SHUTDOWN SEQUENCE OF EVENTS Once the AMERICAN HARVEST has reached the normal operating temperature and switched to the “OFF” position, the unit will continue to ope...

Page 19 - TROUBLE SHOOTING; Unplug stove before performing any maintenance; PROBLEM; Too rich air/fuel mixture

USSC 19 TROUBLE SHOOTING Unplug stove before performing any maintenance PROBLEM CAUSE: Too rich air/fuel mixture ? Fire burns with a lazy, orange flameand/or fuel builds up in the firepot.Glass may become dirty. ? Fire goes out or stove shuts down.Fuel may stop feeding. ? Fire goes out or stove shut...

Page 20 - WIRING DIAGRAM

Page 23 - Notes

Page 24 - THE PART DESCRIPTION; HOW TO ORDER REPAIR PARTS; United States Stove Company

24 USSC THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPEND-ABLE SERVICE FROM YOUR AMERICAN HARVEST, AND EN-ABLE YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFER-ENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBERWHICH IS ON THE NAMEPLATE ATTACHED TO THE HEATER...