Spirit XG200 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS

TABLE OF CONTENTS 1 2 3 4 4 5 11 13 14 ATTENTION This elliptical is intended for residential use only and is warranted for this application. Any other application voids this warranty in its entirety. Product Registration Important Safety Instructions Important Electrical Instructions Important Opera...

Page 3 - PRODUCT REGISTRATION

XG200 Elliptical 1 RECORD YOUR SERIAL NUMBER Please record the Serial Number of this fitness product in the space provided below. Serial Number REGISTER YOUR PURCHASE The self-addressed product registration card must be completed in full and returned to Spirit Manufacturing, Inc . You can also go to...

Page 4 - IMPORTANT SAFETY INSTRUCTIONS

XG200 Elliptical 2 IMPORTANT SAFETY INSTRUCTIONS WARNING - Read all instructions before using this appliance. If using the optional power supply:DANGER - To reduce the risk of electric shock disconnect your Spirit elliptical from the electrical outlet prior to cleaning and/or service work. WARNING -...

Page 5 - IMPORTANT ELECTRICAL INSTRUCTIONS

XG200 Elliptical 3 WARNING! NEVER remove any cover without first disconnecting AC power. If voltage varies by ten percent (10%) or more, the performance of your elliptical may be affected. Such conditions are not covered under your warranty. If you suspect the voltage is low, contact your local powe...

Page 7 - ASSEMBLY TOOLS; XG200 ASSEMBLY INSTRUCTIONS

XG200 Elliptical 5 ASSEMBLY TOOLS 1. Using a razor knife (Box Cutter), cut the banding straps that wrap around the carton. Reach under the bottom edge of the carton and pull it away from the cardboard underneath, separating the staples that join the two together. Lift the box over the unit and unpac...

Page 8 - CONSOLE MAST

XG200 Elliptical 6 1. The computer cable is pre-installed to the console mast and main frame so be careful not to pull too hard on the console mast during assembly to avoid damaging them. 2. Connect cable ( 100 ) to ( 101 ). 3. Place the console mast onto the mating plate of the main frame; Be caref...

Page 10 - CONSOLE

XG200 Elliptical 8 1. Attach the transport wheels ( 77 ) to each bracket with the two bolts ( 44 ) and nuts ( 34 ). Partially tighten with the wrenches provided ( 110 & 111 ). Over tightening the hardware won’t allow the wheels to rotate. 2. Remove the cover on the back of the console and instal...

Page 11 - ARM ATTACHMENTS

XG200 Elliptical 9 1. Assemble the brackets at the bottom of the swing arms to the pedal arms using a shoulder bolt ( 55 ) and a nut ( 56 ) on each side. Tighten securely with the wrenches provided ( 109 & 116 ). ARM ATTACHMENTS 4 # 55 . M10 x 20mm Shoulder Bolt (2 pcs) # 56 . M10 Nut (2 pcs) HA...

Page 13 - CONSOLE OPERATION; POWER

XG200 Elliptical 11 CONSOLE OPERATION The power for the console is provided by 4 C alkaline batteries (provided) and will operate on rechargeable NiCd C batteries. There is an AC electrical power supply that will override the batteries when used. The power supply will not charge the batteries. The N...

Page 14 - OPERATION

XG200 Elliptical 12 TIME: Displays workout time two ways; either count up (accumulated time) or count down (remaining time), depending on your preference.RPM/SPEED: Displays the current pedaling speed as revolutions per minute or miles per hour.LEVEL/DISTANCE: Displays resistance Level or virtual di...

Page 15 - GENERAL MAINTENANCE; MANGEMENT MODE

XG200 Elliptical 13 GENERAL MAINTENANCE To enter the management mode press the START/STOP key until the console resets. During the reset, while the LCD segments are all lit, hold down the START/STOP and + keys until the Time window displays “EN”. The LCD segments will be tested and will automati...

Page 16 - MANUFACTURER’S LIMITED WARRANTY

XG200 Elliptical 14 MANUFACTURER’S LIMITED WARRANTY ELLIPTICAL WARRANTY - Effective September 15, 2010 Spirit Fitness Inc. warrants all its elliptical parts for a period of time listed below from the date of retail sale, as determined by sale receipt, or in the absence of a sales receipt eighteen (1...