Spirit Monitor2 - Manuals

Page 5 MONITOR SENDS These controls route the input channel signal to any one or more Monitor busses and the associated Monitor Outputs, allowing a number of unique monitor mixes to be created. The sends are arranged as a group of mono sends (1-8) and two stereo pairs (9/10 & 11/12). Each group ...

Page 6 9 10 8 7 6 1 2 3 4 5 11 OUTPUT SECTION MONITOR OUTPUTS These outputs provide summing of the corresponding input channel monitor sends, and drive XLR-type output sockets from impedance balanced outputs. A break-point is included before each output socket for the connection of an external graph...

Page 7 MASTER SECTION WEDGE SOURCE The Engineer’s Wedge outputs are normally fed from a mix of the MNTR feeds from outputs 1-12. The pre-fade wedge signal feeds the headphones and meters and the post-fade signal feeds the XLR outputs. Pressing the WEDGE SOURCE switch selects monitor outputs 11-12 as...

Page 8 Setting Up & Troubleshooting Initial Set Up Once you have connected up your system (see the sections on connection and wiring earlier in this manual for guidance) you are ready to set initial positions for the controls on your mixer. The front panel drawing on page 17 shows typical initia...

Page 9 BAND INSTRUMENTS/VOCALS Live Monitor with Effects APPLICATIONS

BAND INSTRUMENTS/VOCALS Page 10 Live Monitor with In-Ear Monitoring

Page 14 3 3 3 3 3 1 1 1 1 1 2 2 2 2 2 +48V +48V +48V +48V MIC INPUT SPLIT SPLIT OUTPUT(Internal Link)Link - GroundedNo Link - Ground Lift TIP: SEND RING: RETURN HOUSE MICS FX RET 1 LEFT HOUSE FX RET 1 FX RET 2 HOUSE SENS FX RET 2 LEFT FX RET 1 RIGHT FX RET 2 RIGHT LEFT RIGHT T/B MIC T/B SENS PHASE I...

Balanced Unbalanced Insert Leads ’Y’ Leads (Unbalanced) Lamp Connections ’Y’ Leads (Balanced) Headphone Splitter Page 15 Connecting Leads

Control Position Sheet You may freely copy this page to mark control positions to assist in resetting the desk between performances.

Page 17 INPUTS MONITOR 2 CONSOLE Typical Starting Out Control Positions

Page 18 Specifications Noise Measured RMS, 22Hz to 22kHz Bandwidth. Inputs at unity gain and terminated 150 W Output Noise 24 inputs routed, sends down, master @ unity < -80dBu EIN Mic EIN @ max. gain (150 W terminated) -129dBu THD+N Mic sens. -10dBu, Faders @ unity, send at max., +20dBu at all o...