Smeg WDF16BAX1- Manuals

GB 6 For Great Britain only Warning : this appliance must be earthed. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A . approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover...

GB 7 3. INSTALLATION INSTRUCTIONS Important ! The appliance must be installed by a specialised technician according to current regulations. This washer dryer is very heavy. Take care when lifting it. 3.1 UNPACKING The inside of the machine comprises a moving assembly which is blocked for transport p...

GB 8 3.3 WATER SUPPLY CONNECTION 1. Check that inlet pressure lies between the following values: 50-900kPa . For higher pressures, install a pressure reducer. 2. Connect the cold water inlet hose ( light blue ring nut) to the cold water tap with a ¾ gas thread, taking care to screw it firmly into pl...

GB 9 4. DESCRIPTION OF CONTROLS 4.1 CONTROL PANEL All the commands and controls of the appliance are assembled together on the front panel. Description of controls A Open door button B ON-OFF and programme selection knob C Delay timer shown on display LED – (only for models with this option) D Time ...

GB 10 A Open door button Press the button to open the door . Chapter 5 – Washing instructions – explains how the door works and how to use it. B ON-OFF and washing and drying programme selection knob This knob lets you: • switch the machine on and off by moving it in either direction from the OFF po...

GB 11 I Select spin speed and drying time for delicates button Press the button repeatedly to select the required spin speed. The following spin speeds are available: • 0000: spin disabled and stop with tub full. The machine does not perform the final spin and ends the washing programme with water i...

GB 12 Economy cycle button - e Press this button for cottons programmes, the machine will perform an extended wash at 35°C (biological step) thereby offering good washing performance combined with power saving. The machine then continues the cycle at the selected temperature. N.B.: Press the economy...

GB 13 4.2 DETERGENT TRAY This is located to the left of the control panel. Pull it out to open. The tray comprises four compartments which are marked as follows “ 1” : pre-wash detergent “2” : main wash detergent “ ” or “3” : fabric softener, starch, etc. (treatment products). Compartment “4” is use...

GB 14 Wool – Only pure wool, identified by or with the label <<shrink-proof machine washable and dryable>> can be machine washed with the specific programme, other types of wool should be hand-washed or dry-cleaned. 5.2 OPENING THE DOOR The machine is fitted with a safety device that pre...

GB 15 Detergent packs indicate the quantities to use according to 4 levels of hardness and for normally dirty loads of 4-5 kg. Ask your local water board to tell you how hard your water is. Water hardness Hardness level French degree fH German degree dH Soft Up to 15° Up to 8° Moderately hard 15° - ...

GB 16 Wool programme only for garments marked “pure wool” washable, treated, shrink proof. Other types of wool should be hand washed or dry-cleaned. To select programmes according to the type of fabric, consult the “Programme chart” supplied together with this manual. Display information When the ma...

GB 17 5.10.3 DELAYED START ( ONLY FOR MODELS FEATURING THIS FUNCTION ) Press the delayed start button ( ). The relative LED located above the button lights up. The display visualises the time remaining (hours/minutes) before the selected washing programme starts: the display initially shows 0 hours ...

GB 18 5.13 END OF PROGRAMME The washing programmes are automatically completed, the display shows END and the “Time remaining” LED lights up. 1. Turn the programmes knob to OFF to switch off the machine. 2. Open the door. 3. Remove the washing from the drum. 4. Leave the door ajar in order to allow ...

GB 19 6. USING THE MACHINE FOR DRYING PURPOSES 6.1 GENERAL INFORMATION During drying cycles it is essential that the water tap is open and that the drain hose is correctly positioned. With this machine it is possible to set wash-only programmes, dry-only programmes and wash-dry programmes. For the l...

GB 20 6.3 TIMED DRYING The length of drying time corresponds to the time selected with the drying selection button. 6.4 WASH-DRY PROGRAMME It is possible to use a wash-dry programme for intensive programmes (cotton, coloureds) and for synthetics/delicates. With the wool wash programme it is not poss...

GB 21 7. CLEANING AND MAINTENANCE Important – Before cleaning or servicing the machine, remove the plug from the socket. 7.1 EXTERNAL CLEANING • Regular and constant cleaning will keep your appliance looking like new. • Clean the unit with specific products for steel and dry thoroughly with a soft c...

GB 22 3. Pull out the drain hose “A”. Attention: if the hose is hot it means the water is hot or boiling. Place a tray on the floor and remove the plug “B” to drain the water. Depending on the quantity of water, it may be necessary to empty the tray several times. When no more water comes out, push ...

GB 23 7.6 CLEANING THE WATER INLET FILTER The machine is fitted with a filter for protecting the water inlet valves. The filter is fitted the gas thread of the inlet hose connected to the tap Clean the filter if no water or insufficient quantities of water enter the washer dryer. To do this, proceed...

GB 25 11 The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle. 12 Draining water from the drum In the eve...

GB 26 9. CONTROL PANEL SYMBOLS PROGRAMS OPTIONS OTHER SYMBOLS DRYING WATER INCREASE FABRIC CONDITIONER HAND WASH NO SPIN OR STOP WHIT FULL TUB OPEN DOOR PRE-WASH DELAY TIMER START-PAUSE RINSES DELICATES START DRAIN AND SPIN - e ECONOMY CYCLE WASH SECTION QUICK WASH END COTTON AND COLOURED EXTRA RINS...