Page 2 - Introduction; INSTRUCTIONS FOR SAFE AND PROPER USE
Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER...
Page 3 - HEATING ELEMENTS INSIDE THE OVEN.
Introduction DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE HOB GRIDS. DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. DO NOT USE CONTAINERS OR BROILERS THAT EXTEND BEYOND THE OUTER PERIMETER OF THE HOB. THE APPLIANCE IS DESIG...
Page 4 - Instructions for the installer; INSTALLATION OF THE APPLIANCE; appliance
Instructions for the installer 2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas s...
Page 5 - Electrical connection; H05V2V2-F cable having a cross section of 3 x 2.5 mm; Ventilation requirements
Instructions for the installer 2.1 Electrical connection Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment. This rating plate must never be removed. If the appliance is connected to the supply by means of a fixed con...
Page 6 - Connecting to natural and LPG gas
Instructions for the installer 2.3 Connecting to natural and LPG gas (Please see connection diagram) Make the connection to the appliance using flexible bayonet style hose in accordance to B.S. 669. The hose connection at the rear of the appliance has a ½” BSP internal thread. Please use seal C betw...
Page 7 - ADAPTATION TO DIFFERENT TYPES OF GAS; Replacement of nozzles on the hob; unscrew the burner nozzles with a 7 mm socket wrench
Instructions for the installer 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, disconnect the appliance from the mains. The cooker hob is preset for natural gas G20 (2H) at a pressure of 20 mbar. In the case of operation with other types of gas the burner ...
Page 8 - LPG; mbar
Instructions for the installer 3.2 Burner and nozzle characteristics table (Mod. 90 cm.) Burner Rated heating capacity (kW) LPG – G30/G31 28/37 mbar Nozzle diameter 1/100 mm By-pass mm 1/100 Reduced flowrate (W) Flowrate g/h G30 Flowrate g/h G31 Auxiliary 1.0 50 30 350 73 71 Semi rapid 1.75 65 33 45...
Page 10 - FINAL OPERATIONS; Regulation of the hob burner minimum level for natural gas; Secure the skirt to the top by tightening screws A.
Instructions for the installer 4. FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new ...
Page 11 - Wall fixing; Mark the wall in the position where the hole is to be drilled.
Instructions for the installer 4.4 Wall fixing • Stretch out the chain attached to the cooker horizontally so that the other end touches the wall. • Mark the wall in the position where the hole is to be drilled. • Drill the hole, insert a wall plug and attach the chain. • Move the cooker up against ...
Page 12 - DESCRIPTION OF CONTROLS; Front control panel; All the cooker controls and commands are on the front panel.; DESCRIPTION OF SYMBOLS
Instructions for the installer 5. DESCRIPTION OF CONTROLS 5.1 Front control panel All the cooker controls and commands are on the front panel. If the cooker is equipped with an electronic programmer, before using the oven make sure that the symbol ; appears on the display. See paragraph “8. ELECTRON...
Page 13 - Instructions for the user; VARIABLE GRILL KNOB; OVEN LIGHT
Instructions for the user VARIABLE GRILL KNOB This allows to vary heat intensity when cooking with the grill. The knob can be set with continuity between “0” and the stop release position, which corresponds to maximum heat. ELECTRIC OVEN CONTROL KNOB Each of the functions listed below can be used (e...
Page 14 - USE OF THE HOB; Lighting of the hob burners
Instructions for the installer 6. USE OF THE HOB 6.1 Lighting of the hob burners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocoupl...
Page 15 - Diameter of the vessels to be used on each burner; Auxiliary
Instructions for the user 6.3 Diameter of the vessels to be used on each burner BURNERS 1 Auxiliary 2 Semi rapid 3 Rapid 4 Triple crown Ø min. and max. (in cm) 12-14 16-24 18-26 18-26 17
Page 16 - USE OF THE OVEN; Warnings and general advice; . To adjust refer to; Use of the electric grill; set the thermostat knob to maximum; Operation of the grill + rotisserie; or fan grill function and set
Instructions for the installer 7. USE OF THE OVEN For the models with electronic programmer, before using the oven make sure that the display shows the symbol . 7.1 Warnings and general advice Using the oven and the grill for the first time, heat them to the maximum temperature (260°C) for as long a...
Page 17 - Using the rotisserie in cookers with maxi oven; Fit the supporting frame onto the second runner; FOOD; Flat or thin meat; WARNING
Instructions for the user 7.2.2 Using the rotisserie in cookers with maxi oven Fit the supporting frame onto the second runner up from the bottom so that the seat to take therod projects outside the oven. Place the rod asshown in the diagram (1) and push the frameinto the oven until the end of the r...
Page 18 - Using the pIzza function (only on some models); identified by the; Precautions for using the pizza plate; Storage compartment; If your cooker is equipped with knob guard, when
Instructions for the installer 7.3 Using the pIzza function (only on some models) This appliance Is equipped with a function specially developed for cooking pizza. This function is identified by the symbol on the oven functions knob. To cook a pizza, proceed as described below. With the oven cold, r...
Page 19 - ELECTRONIC PROGRAMMER (ONLY ON EQUIPPED MODELS); LIST OF FUNCTIONS; Clock adjustment; After set-up, to see the cooking time remaining, press the key
Instructions for the user 8. ELECTRONIC PROGRAMMER (ONLY ON EQUIPPED MODELS) LIST OF FUNCTIONS MINUTE-COUNTER KEY COOKING TIME KEY END-OF-COOKING KEY DECREASE TIME KEY INCREASE TIME KEY 8.1 Clock adjustment When using the oven for the first time, or after a power failure, the display flashes regular...
Page 20 - is reached by means of variation keys
Instructions for the installer 8.4 End of cooking When cooking is over, the oven will automatically switch off and, at the same time, an intermittentalarm will sound. After switching off the alarm, the display will once again show the right time togetherwith the symbol , indicating that the oven has...
Page 21 - AVAILABLE ACCESSORIES; Oven plate: useful for catching fat from foods on the grill above.; guides of the oven before using the spit.
Instructions for the user 9. AVAILABLE ACCESSORIES The oven has 4 support for positioning plates and racks at various heights. Oven grill: for cooking food on plates, small cakes, roasts or food requiring light grilling. Plate grill: for placing above plate for cooking foods that might drip. Oven pl...
Page 22 - CLEANING AND MAINTENANCE; Cleaning stainless steel and enamelled versions
Instructions for the installer 10. CLEANING AND MAINTENANCE 10.1 Cleaning stainless steel and enamelled versions To maintain stainless steel in good condition clean it regularly after each use, once it has cooled down. 10.1.1 Ordinary daily cleaning To clean and preserve the stainless steel surfaces...
Page 23 - Cleaning of oven
Instructions for the user 10.3 Cleaning of oven For best oven upkeep clean regularly after having allowed to cool. Take out all removable parts. • Clean the oven grill with hot water and non-abrasive detergent. Rinse and dry. • Do not allow residues of sugary foods (such as jam) to set inside the ov...
Page 24 - EXTRAORDINARY MAINTENANCE; Replacement of light bulb
Instructions for the installer 11. EXTRAORDINARY MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disco...