Smeg SE2641CX- Manuals

Page 2 - Instructions for proper use; INSTRUCTIONS FOR PROPER USE

Instructions for proper use 18 1. INSTRUCTIONS FOR PROPER USE ELECTRICAL CONNECTION: PLEASE REFER TO INSTALLATION INSTRUCTIONS FOR THE GAS & ELECTRICAL SAFETY REGULATIONS AND THE VENTILATION REQUIREMENTS. IN YOUR OWN INTEREST, AND THAT OF SAFETY, IT IS THE LAW THAT ALL GAS AND ELECTRICAL APPLIAN...

Page 3 - Safety instruction; SAFETY INSTRUCTIONS

Safety instruction 19 2. SAFETY INSTRUCTIONS INSTRUCTIONS FOR THE INSTALLER: THESE ARE INTENDED FOR THE QUALIFIED TECHNICIAN WHO MUST INSTALL THE APPLIANCE, SET IT FUNCTIONING AND CARRY OUT AN INSPECTION TEST. IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE METHODS REQUIRE...

Page 4 - Instructions for the user; KNOW YOUR HOB

Instructions for the user 20 3. KNOW YOUR HOB Glass surface of the appliance Single cooking zone Dual oval cooking zone Dual round cooking zone Timer controls Control panel Triple cooking zone Heating zone NOT ALL COMPONENTS DESCRIBED ARE PRESENT ON ALL MODELS 4. BEFORE FIRST USE Do not leave the pa...

Page 5 - COOKING ZONES

Instructions for the user 21 5. COOKING ZONES The appliance features 2/4/5 cooking zones of different diameter and power. Their position is clearly indicated by circles and the heat given off is defined by the markings on the glass surface. The 2/4/5 cooking zones are of the HIGH-LIGHT type and come...

Page 6 - DESCRIPTION OF CONTROL ON THE FRONT CONTROL PANEL

Instructions for the user 22 6. DESCRIPTION OF CONTROL ON THE FRONT CONTROL PANEL All the hob controls are grouped together on the front panel. The table below provides a description of the symbols used. HOB IGNITION OVAL COOKING ZONE CONTROLS ON-OFF REAR RIGHT-HAND COOKING ZONE VALUE INCREASE BUTTO...

Page 7 - USE OF THE COOKING HOB; Hobs with knobs; Single cooking zones

Instructions for the user 23 7. USE OF THE COOKING HOB 7.1 Hobs with knobs 7.1.1 Single cooking zones Each knob shows the cooking zone it is for. For example, the symbol identifies the knob that controls the rear right-hand cooking zone. To heat, turn the knob to the desired position (1 to 6). Adjus...

Page 8 - Hobs with touch-control buttons

Instructions for the user 24 7.2 Hobs with touch-control buttons When an icon is pressed the unit beeps to confirm. To operate the panel of the hobs equipped with touch-controls, lightly press the icons printed on its surface. On first connection to the electrical mains, an operating check will be c...

Page 9 - Modifying the data set

Instructions for the user 25 7.2.8 Timer (on some models only) Some models are equipped with a 1 to 99-minute cooking timer. To use the timed cooking, first set the power level by following the instructions given in paragraphs “7.2.2 Single Cooking Zones” and “7.2.3 Dual Cooking Zones”. Now, with th...

Page 10 - Cooking tips

Instructions for the user 26 7.2.14 Switching off To switch the hob off, hold down for 1 second; this deactivates all cooking zones even if they are in use or the lock-out function is active, and the hob will turn off completely. If the cooking zones have just been used, will start flashing a few se...

Page 11 - CLEANING AND MAINTENANCE; Cleaning the ceramic hob; PROBLEM

Instructions for the user 27 8. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning the ceramic hob The hob should be regularly cleaned; preferably after every use, once the residual heat warning lights have gone off. Smudges from aluminium-botto...

Page 12 - Instructions for the installer; INSTALLATION; Technical information; HOB RATING; The rating plate

Instructions for the installer 28 10. INSTALLATION 10.1 Technical information Hob type See rating plate Electrical connections 220-240V~ 50/60Hz / 380-415V 2N ∼ 50/60Hz / 380-415V 3N ∼ 50/60Hz HOB RATING Electric Maximum electrical power See rating plate DIMENSIONS OF THE HOB Width (mm) 290 595 720 ...

Page 13 - TYPE 1 TERMINAL BOARD; TYPE 2 TERMINAL BOARD

Instructions for the installer 29 For operation on 380-415 V 3N ∼ : use an - H05V2V2-F type five-core cable (5 x 1,5 mm 2 ). For operation on 380-415 V 2N ∼ : use an - H05V2V2-F type four-core cable (4 x 2,5 mm 2 ). For operation on 220-240 V 3 ∼ : use an - H05V2V2-F type four-core cable (4 x 2,5 mm...

Page 14 - POSITIONING OF THE HOB

Instructions for the installer 30 10.4 POSITIONING OF THE HOB The following operation requires building and/or carpentry work so must be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as ...