Smeg KSE912X- Manuals

Page 2 - EN; RECOMMENDATIONS AND SUGGESTIONS; INSTALLATION

EN 27 27 RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accord- ingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulti...

Page 3 - CHARACTERISTICS; Dimensions

EN 28 28 CHARACTERISTICS Dimensions 650 min. 490 60 108 259 150 min. 740 max. 1055 740 260 300 90 132 433 Components Ref. Q.ty Product Components 1 1 Hood Body, complete with: Controls, Light, Blower, Filters 2 1 Telescopic Chimney comprising: 2.1 1 Upper Section 2.2 1 Lower Section 9 1 Reducer Flan...

Page 4 - Wall drilling and bracket fixing; centre of the area in which the hood will be installed.

EN 29 29 INSTALLATION Wall drilling and bracket fixing Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Draw a horizontal line at 650 mm above the hob. Place bracket 7.2.1 on the w...

Page 5 - Mounting the hood body; Connections; DUCTED VERSION AIR EXHAUST SYSTEM

EN 30 30 Mounting the hood body • Before attaching the hood body, tighten the two screws Vr lo- cated on the hood body mounting points. • Hook the hood body onto the screws 12a. • Fully tighten support screws 12a. • Adjust screws Vr to level the hood body. 12a Vr Connections DUCTED VERSION AIR EXHAU...

Page 6 - ELECTRICAL CONNECTION; • Connect the hood to the mains through a two-pole switch hav-; Chimney assembly; • Secure the sides to the brackets using the 4 screws 12c (2,9 x; • Fix the lower part laterally to the hood body using the 2 screws

EN 31 31 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch hav- ing a contact gap of at least 3 mm. • Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the f...

Page 7 - USE; Control board

EN 32 32 USE Control board Key Function Display A Switches the motor on and off at the latest selected speed Indicates the selected speed B Decreases the suction speed. - C Increases the suction speed. - D By pressing this key it is possible to start the intensive speed from any previously selected ...

Page 8 - MAINTENANCE; Metal grease filters; • Wash the filters. Pay attention not to bend them. Make sure

EN 33 33 MAINTENANCE Metal grease filters Filters can be washed in the dish machine. They need to be washed when FF-sign appears on the display or in any case every 2 months, or even more frequently in case of particularly inten-sive use of the hood. Alarm reset • Press the G-key for at least 2 seco...

Page 9 - stallation or later.; SUBSTITUTION OF THE CHARCOAL FILTER; Lighting; LIGHT REPLACEMENT; out of from the Hood.

EN 34 34 Charcoal filter (recycling version ) This filter cannot be washed or regenerated. It has to be replaced when the EF appears on the display or at least once every 4 months. Activation of the alarm signal • In the recycling version hoods the filter saturation alarm has to be activated during ...