Smeg DF6FABR- Manuals

User instructions 18 SETTING THE WASHING PROGRAM AND SWITCHING ON To select the most suitable program for the dishes to be washed refer tothe table below, which indicates the most appropriate program accordingto dish type and degree of soiling. After using the table to identify the most appropriate ...

User instructions 19 DURATION CONSUMPTION PROGRAMME, NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS MINUTES (2) WATER LITRES (1) POWERKWh (2) 5 SUPER Very dirty pans and dishes, even with dried-on dirt Prewash at 45°CWash at 70°C2 cold rinsesRinse at 70°CDry 110’ 20 1,70 6 SOAK Pans ...

User instructions 20 TABLE FOR CERTIFICATION BODIES Reference standard EN 50242 Reference program BIO Load 14 place-settings Type of detergent B Amount of detergent 35 g Rinse aid setting 5 /6 1.2 Washing programs Before starting a washing program make sure that: • The water supply tap is open. • Th...

User instructions 21 SELECTING HALF LOAD WASH This function is ideal for small loads and saves water and electricity. It iscontrolled by the HALF LOAD (10) button, with two alternatives: 1) press the button once to select washing in the top basket (the relative light comes on); 2) press the button a...

User instructions 22 "3/1" OPTION BUTTON(available in all programs except the soak program) By pressing the button (8) you activate the " 3/1 " option, confirmed when the relative light comes on. This option has been studied for the use ofdishwashing powder or tablets with integrated...

User instructions 23 ADJUSTING THE WATER SOFTENING SYSTEM N.B.: for the setting below to be possible, a washing program other than the soak program must be set. Press the PROGRAM DELAY button (12) and keep it pressed until the preset value appears followed by a full stop (normally 3. ). Release the ...

24 If the door has to be opened while washing is in progress, the programwill be interrupted. The relative light will keep flashing and a beeper willsignal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the door is closed the ...

26 FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only)The appliance is not able to "measure" the amount ofwater loaded accurately. Interrupt the program andswitch off the dishwasher. Switch the dishwasherback on, program it again and start the washingcycle....

INSTRUCTION MANUAL W W A A R R N N I I N N G G S S A A N N D D R R E E C C O O M M M M E E N N D D A A T T I I O O N N S S , , G G U U I I D D E E F F O O R R T T H H E E U U S S E E O O F F B B A A S S K K E E T T S S A A N N D D F F O O R R C C L L E E A A N N I I N N G G D D I I S S H H W W A A S...

Contents 1. Safety and operating instructions __________________________ 28 2. Installation and hook-up _________________________________ 31 3. Operating instructions ___________________________________ 35 4. Cleaning and maintenance _______________________________ 4 6 Thank you for choosing one of ...

Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUSTALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFOREUSING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONSCONTAINED IN THIS MANUAL.INSTALLATION MUST BE PERFORMED BY A QUALIFIE...

Safety instructions THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( WEEE ). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FORTHE ENVIRONMENT AND HUMAN HEALTH, WHICH COULD...

Safety instructions DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDETHE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAMAND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACEDIN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THETOP BASKET. TAKE...

Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers.Position the appliance in the desired place of installation. The back orsides of the dishwasher may be placed up against walls or otherfurniture units. If the dishwasher is installed near a heat source, fit...

Installation instructions 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supplycheck that the water is clear and free of impurities, to prevent damage tothe appliance. The dishwasher...

Installation instructions 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCHTHE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ONTHE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKETOUTLET MUST BE OF THE SAME TY...

Installation instructions WHEN CLEANING AND MAINTAINING THE APPLIANCE: BEFORE CARRYING OUT ANY WORK, ALWAYS UNPLUG THE APPLIANCEFROM THE ELECTRICAL SUPPLY OR SWITCH OFF THE ALL-POLEDISCONNECTION DEVICE. FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of thi...

User instructions 3. Operating instructions Once the dishwasher has been correctly installed, prepare for use asfollows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 3.1 Using the water softening system The amount of scale contained in thewater...

User instructions • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program . In this way, the excess saline solution will be immediately removed by...

User instructions ADDING THE RINSE AID The rinse aid helps the dishes dry faster andprevents the formation of scale deposits andstaining; it is automatically added to the waterduring the final rinse cycle, from the containersituated on the inner side of the door. To add rinse aid: • Open the door. •...

User instructions ADDING THE DETERGENT To open the detergent dispenser cap, lightly pressthe button P . Add the detergent and close the cap carefully. During the washing cycle, the dispenser willbe opened automatically. • When a program with hot prewash is selected (see program table),extra detergen...

User instructions • "3/1" Products If you wish to use detergents which already contain salt and rinseaid, check whether your dishwasher is fitted with the " 3/1 option button " on the " Controls description " page and then refer to the section which explains how to use this f...

User instructions WARNING! • Make sure that the dishes are securely in place so that they cannottip over or obstruct the rotation of the spray arms during thewashing cycle. • Do not place very small objects in the baskets as these could falland obstruct the spray arms or the wash pump. • Containers ...

User instructions 3.4 Using the baskets The dishwasher has a capacity of 14 place-settings , including serving dishes. EN 50242 STANDARD LOADS FOR CERTIFICATION BODIES LOWER BASKET UPPER BASKET EN 50242 cycle test conditions:Lower basket: the grid " A " ("lower basket" section) must ...

User instructions In the front there are one or two supports (depending on the models) for small plates (B) . To use them, they have to be turned towards the front of the dishwasher. LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes,positioning them vertica...

User instructions CUTLERY BASKET Cutlery must be placed with the tips facing downward . Long items of cutlery (ladles, wooden spoons, kitchen knives, etc.), which might interfere with the upper spray arm must be placed in the upper basket , ensuring that knife tips do not project from the basket. Th...

User instructions UPPER BASKET It is recommended to load the upper basket with small- or medium-sizeditems such as glasses, small plates, tea or coffee cups, shallow bowlsand light objects made from heat resistant plastic. If the upper basket isused in the lowermost position, it can also be loaded w...

User instructions ADJUSTING THE UPPER BASKET T he upper basket can be adjusted in two positions , according to the user’s needs and according to the height of the dishes in the lower basket. Proceed as follows. • pull out the basket to its limit position and pull the right side upwards. At this poin...

46 4. Cleaning and maintenance Before carrying out any work, always disconnect the appliancefrom the electrical power supply. 4.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regularlyusing a soft clot...

47 CLEANING THE FILTER UNIT • It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn themanticlockwise and lift upwards; • push the centre filter D from the underside to remove it from the micro-filter: • separate the two...

49 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special container; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost itseffectiveness (for example, through incorrect storage, with the boxleft open). If the ...