Smeg D4SS-1- Manuals

Installation instructions 6 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwa...

Installation instructions 7 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SA...

Installation instructions 8 FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove t...

User instructions 9 3. Description of the controls 3.1 Front panel All the dishwasher control are grouped on the front panel. Programming and option selection are only possible with the door closed. 1 ON/OFF BUTTON 2 SELECTION PROGRAM BUTTONS (P1…P5) 3 OPTION SELECTION BUTTON 4 CONFIRM OPTIONS BUTTO...

User instructions 10 3.2 Information display The dishwasher is equipped with a practical DISPLAY which provides information on the programmed dishwasher functions. A 4-FIGURE DISPLAY B RINSE AID WARNING LIGHT C SALT WARNING LIGHT D START/PAUSE BUTTON E OPTIONS LIGHT PROGRAMS TABLE The manual contain...

User instructions 12 PROGRAMS TABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUTES (1) WATER LITRES POWER kWh (1) 1 RAPID 27’ Dishes with light dirt, washed immediately after use Wash at 38°C Rinse at 50°C 27 6,5 0,70 2 GLASS Glass, china and mi...

User instructions 13 QUICK TIME PROGRAMS (see relevant section for explanation of functioning modes) PROGRAMME NUMBER E SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUTI (1) WATER LITRES POWER kWh (1) 6 SOAK + Pans and dishes awaiting completion of the load Cold prewash 1...

User instructions 14 NOTES AND REFERENCES Only run the soak program with partial loads. The options cannot be used with the soak program. * Standard program under EN 50242. ** See information sheet provided (1) Program consumption and duration figures have been measured in accordance with the EN 502...

User instructions 15 3.3 Washing programs The dishwasher is equipped with a control panel and an INFORMATION DISPLAY from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a washing program make sure that: • The water supply tap is open...

User instructions 16 START PROGRAM At this point, in order to start the machine, it is only enough to press the START/PAUSE (6) for some seconds until the symbol START/PAUSE (D) start to flash and confirmation “beep” is heard. From this moment the cycle duration on the DISPLAY (9) starts to decrease...

User instructions 17 STOPPING A PROGRAM To cancel a program which is running: • Interrupt the program (see " INTERRUPTING A PROGRAM ") • Press the START/PAUSE button and hold it down; the display will show "P0" and the dishwasher will immediately switch to the end of the cycle and dr...

User instructions 18 PROGRAM DELAY The PROGRAM DELAY button can be pressed to delay the start of the washing program by from 1 to 12/24 hours depending on the model. This option allows the dishwasher to be operated at the time of day of the user's choice. The first time the PROGRAM DELAY button is p...

User instructions 20 Flexi Tabs Specifically for washing with combination detergents in tablets, which also contain salt and rinse aid (3in1) or other agents such as glass protector, steel rinse aids, etc. (4in1, 5in1…). When this option is selected, salt and rinse aid will not be dispensed even if ...

User instructions 21 TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT • Always try to run the dishwasher fully loaded. • Do not wash the dishes in running water. • Use the washing program that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, conn...

User instructions 22 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The dishwasher is equipped with an au...

User instructions 23 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • Refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; th...

User instructions 24 WATER HARDNESS TABLE German degrees (°dH) French Degrees (°dF) SETTING 0 - 6 0 - 11 H0 (no salt) 7 - 10 12 - 18 H1 11 - 15 19 - 27 H2 16 - 21 28 - 37 H3 22 - 28 38 - 50 H4 29 - 35 51 - 62 H5 36 - 50 63 - 90 H6 Contact your local water board for information on the hardness of you...

User instructions 25 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle. To add rinse aid: • Open the door. • Rotate the container cap anticlockwise by ¼ of a tu...

User instructions 26 ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P. Add the detergent and close the cap carefully. During the washing cycle, the dispenser will be opened automatically. • When a program with hot prewash is selected (see program table), extra det...

User instructions 27 The introduction of detergent into the rinse aid dispenser, even in liquid form, will damage the dishwasher. 4.3 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be...

User instructions 29 4.4 Using the baskets The dishwasher has a capacity of 10 place-settings, including serving dishes. LOWER BASKET Used for items with a heavier degree of soiling. All types and combinations of loads are permitted, provided that the dishes, pots and pans are arranged with all the ...

User instructions 30 BOTTOM BASKET INSERTS Some models are equipped with bottom basket inserts which improve the drying of dishes. The inserts are supplied in the accessories bag; to use them, simply fit them into place as shown. CUTLERY BASKET The cutlery should be arranged in an orderly manner ins...

User instructions 31 UPPER BASKET It is recommended to load the upper basket with small or medium-sized items such as glasses, small plates and saucers, tea or coffee cups, shallow bowls and light objects made from heat resistant plastic. If the upper basket is used in the lowermost position, it can...

User instructions 32 ADJUSTING THE UPPER BASKET The height of the upper basket can be according to requirements and the size of the dishes in the lower basket. Pull-out adjustment system: • Turn the retainer E on both runners, right and left, through 90° • Remove the basket • Lift the basket and fit...

User instructions 33 Quicklift position setting system: system with 3 position settings (1 lowest, 3 highest). The basket is snapped into the position required, lifting both sides simultaneously. To return to the lowest position from any height, lift the basket to the highest position and then relea...

User instructions 34 5. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or turn off the dual-pole dedicated switch. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door...

User instructions 35 CLEANING THE OSCILLATING BOTTOM SPRAY ARM ● Take hold of the bottom spray arm unit and pull it upward to release. ● Separate the oscillating arm A from the spray arm B. ● Turn the oscillating arm A upside down to release the toothed wheel C by pressing the teeth D and turning th...

User instructions 36 CLEANING THE FILTER UNIT • The central filter should be cleaned regularly. To remove it, pull the spray arm assembly upwards. • Turn the microfilter M anticlockwise to release and extract it, then lift the stainless steel filter F. • Push the central filter H from below to extra...

User instructions 38 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special container; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box...

User instructions 39 6. Troubleshooting The dishwasher is equipped with a self-diagnostics system that is capable of detecting and signalling a number of possible faults. TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM FAULT DESCRIPTION Er 01 The anti-flooding system (where present) has been...

User instructions 40 TECHNICAL DATA Width 497 ÷ 499 mm Depth measured flush with the outer edge of the control panel Free standing: 600 mm Semi-integrated: 570 mm Height (depending on models) Free standing: from 850 mm to 870 mm Semi-integrated: from 820 mm to 870 mm Capacity 10 Standard place setti...