Schneider Electric 170 LNT 710 00 - Manuals

Page 3 - Figure 1 shows the layout of a typical adapter and I/O base.; Figure 1; Front View; Product Overview

1 Modicon TSX MomentumDeviceNet Communication Adapter170 LNT 710 00 This Communication Adapter can be connected to any TSX Momentum I/O baseto create a functional I/O module. It provides direct connection to the DeviceNetnetwork, enabling a programmable controller or other DeviceNet master device to...

Page 4 - Function

DeviceNet Communication Adapter 2 1.1 Product Overview 1.1.1 Function This adapter is installed on any TSX Momentum I/O base to form a complete I/Omodule that communicates on a DeviceNet network. A programmable controlleror other DeviceNet master device on the network can then read from the inputter...

Page 5 - Specifications

DeviceNet Communication Adapter 3 1.2 Specifications Table 1 General Specifications Description Specification ODVA compliance Complies with ODVA Specification Release 2.0 for group 2only slave supporting polled and strobed connections. Data rate Supports 125/250/500 Kbaud standard DeviceNet rates. N...

Page 6 - Table 3; Firmware; remaining non–faulted inputs normally.

DeviceNet Communication Adapter 4 1.2.1 Exec. V. 1.10 vs. V. 1.20 Exec. V. 1.20 changed the behavior of certain I/O bases if a field side faultoccurred. This change affects the following bases. H 170 ADM 350 10 H 170 ADM 350 11 H 170 ADM 390 10 H 170 ADM 370 10 The following table describes the diff...

Page 7 - Status Indicators

DeviceNet Communication Adapter 5 1.3 Status Indicators The adapter has three front panel indicators showing its operating status. Figure 2 Status Indicators Pwr MNS IO DeviceNet Power ON (Green) Module/Network Status (Green/Red) I/O Status (Green/Red) X 10 X 1 NA Table 4 Power ON Indicator Indicato...

Page 8 - Connecting to the Network; Network Connector

DeviceNet Communication Adapter 6 1.4 Connecting to the Network 1.4.1 Network Connector The adapter has one 5–pin male connector for connection to the network. Itspin–to–pin spacing is 5.00 mm. A suggested mating connector is: SchneiderAutomation part 170 XTS 060 00. Figure 3 Network Connector Front...

Page 9 - Setting the Network Node Address

DeviceNet Communication Adapter 7 1.5 Setting the Network Node Address DeviceNet nodes are identified by unique addresses assigned to them by the user,in the range 0 ... 63. Duplicate addresses are not allowed. The address is assigned in a pair of rotary switches on the adapter’s front panel.The add...

Page 10 - Do not install any adapter unless you have set; This example sets the address to 31.

DeviceNet Communication Adapter 8 Figure 5 Setting the Network Node Address Node Upper Lower Address Switch Switch 0 ... 9 0 0 ... 9 10 ... 19 1 0 ... 9 20 ... 29 2 0 ... 9 30 ... 39 3 0 ... 9 40 ... 49 4 0 ... 9 50 ... 59 5 0 ... 9 60 ... 63 6 0 ... 3 Do not install any adapter unless you have set ...

Page 11 - Table 7

DeviceNet Communication Adapter 9 1.6 Electronic Data Sheet (EDS) Disk An Electronic Data Sheet (EDS) disk is included with this guidebook. It suppliesthe parameters for setup of each type of I/O base. Each file’s format on the diskcomplies with the ODVA specification for DeviceNet I/O module EDS pa...