ResMed S8 Elite II - Manuals

3 Using the S8 Series II En gli sh Using the S8 Series II Setting Up 1 Connect the power cord to the socket at the rear of the S8 Series II device. 2 Plug the other end of the power cord into the power outlet. 3 Connect one end of the air tubing firmly onto the air outlet. 4 Connect the assembled ma...

5 Using the S8 Series II En gli sh 4 Press or until you see the setting that you require. 5 Press to apply. Using the Mask-fitting Feature You can use the S8 Series II mask-fitting feature to help you fit your mask properly. This feature delivers air pressure for a three-minute period, prior to star...

6 4 To start treatment, press . 5 Fit your mask as described in the mask user instructions. ! WARNING A mask should not be used unless the S8 Series II device is powered and operating properly. Stopping Treatment To stop treatment at any time, remove your mask and press . If your clinician has enabl...

7 Changing the Settings on your S8 II Device En gli sh The Detailed Menu Your clinician may have enabled a detailed menu on your S8 Series II device. The figure below shows the detailed menu in each mode. T o enter the detailed menu from the standby (RAMP or SETTLING) screen, press . Note: The AutoS...

8 Messages on the S8 Series II LCD Your clinician may have set your S8 Series II device to remind you about important events, such as when to replace your mask, when to insert your Data Card (if your device is Data Card enabled) and so on.The reminder message is displayed on the LCD and is visible i...

9 Cleaning and Maintenance En gli sh 3 Remove the Data Card by gripping the end of the Data Card and pulling it out. 4 Store the Data Card in its protective folder when not in use. 5 Return the card in its protective folder to your clinician using a postal envelope. Updating Settings on your S8 devi...

10 ! WARNING Beware of electric shock. Do not immerse the device or power cord in water. Always unplug the device before cleaning and make sure it is dry before reconnecting. ! CAUTION • Do not hang the air tubing in direct sunlight as it may harden over time and eventually crack. • Do not use bleac...

11 Frequently Asked Questions En gli sh ! CAUTION • Do not attempt to open the S8 Series II case. There are no user serviceable parts inside. • Inspection and repair should only be performed by an authorised agent. Under no circumstances should you attempt to service or repair the S8 Series II yours...

12 Please consult the medical services department of your carrier if you intend to use your S8 Series II on an aircraft. The S8 Series II complies with US FCC Part 15, Class B requirements. Note: Do not use your S8 Series II while the aircraft is taking off or landing. Can I use my S8 Series II if m...

14 Technical Specifications . The manufacturer reserves the right to change these specifications without notice. The following message is displayed on the LCD after you try to update settings or copy data to the Data Card: Settings Invalid Remove Card The identification details on the Data Card do n...

15 General Warnings and Cautions En gli sh Symbols which appear on the device Attention, consult accompanying documents; Follow instructions for use; Drip proof; Type CF equipment; Dangerous voltage; Class II equipment; Start/Stop; Manufacturer; Environmental information WEEE 2002/96/EC is a Europea...

16 • If oxygen is used with this device, the oxygen flow must be turned off when the device is not operating. If the oxygen has been left on, turn off the device, then wait 30 minutes before turning on the device again. Explanation: When the PAP device is not in operation and the oxygen flow is left...

17 Limited Warranty En gli sh Limited Warranty ResMed warrants that your ResMed product shall be free from defects in material and workmanship for the period specified below from the date of purchase by the initial consumer. This warranty is not transferable. Note: Some models are not available in a...