Rangemaster R9049 - Manuals

Page 2 - Contents; Cleaning Your Oven

Contents 1. Before You Start... 1 2. Oven Overview 2 3. Cooking Tips 7 4. Cooking Table 8 5. Cleaning Your Oven 9 6. Troubleshooting 11 7. Installation 12 8. Circuit Diagram 15 9. Technical Data 16 10. Warranty/After Sales Service 17

Page 3 - Installation and Maintenance; Make sure that the oven is wired in and switched on.; Before First Use; This appliance is heavy, so take care when moving it.; Cleaning; Clean only the parts listed in this guide.

1 Thank you for buying a Rangemaster oven. It should give you many years trouble-free cooking if installed and operated correctly. It is important that you read this section before you start, particularly if you have not used an electric oven before.  This appliance is designed for domestic cooking...

Page 4 - Key

2 The oven (Fig.2-1) has two multi-function oven cavities with four retractable push-in controls. The left-hand knobs control the top oven and right-hand knobs control the main (bottom) oven function and temperature operation. There is also a touch sensitive timer. 2. Oven Overview ArtNo.325-0014 - ...

Page 5 - Functions; The oven interior light comes on.

3 ArtNo.325-0036 - BI oven R6049 top functions 0 �� AB Oven lightBase heat Key C D Conventional cookingGrill ArtNo.325-0017 - BI oven R609 functions 0 �� ABC D E Oven lightConventional cookingFan assisted cookingBase heatGrill Key F GH I Full grillFan an...

Page 6 - Fanned oven with base heat; Full grill; Grilling must always take place with the oven; Preheat the oven for 5-10 minutes before use.; Grilling must always take place with the oven

4 ArtNo.303-0001 Setting the clock 1 ArtNo.303-0002 Setting the clock 2 Fig.2-4 ArtNo.303-0003 Setting the minute timer Fig.2-5 Fig.2-6 Fanned oven with base heat This function operates the fan, circulating air heated by the element at the base of the oven. The combination of fan and base heat makes...

Page 7 - The Clock; Setting the Time of Day; When the oven is first connected the display will flash ‘; Setting the Minute Counter; Setting the Cooking Time

5 The Clock Setting the Time of Day When the oven is ﬁrst connected the display will ﬂash ‘ Auto ’ and ‘ 0:00 ’ (Fig.2-4). To set the clock, press the central button for about 3 seconds until [ ArtNo.030-0010 TC timer symbols ] appears (Fig.2-5). Use the ‘+’ and ‘–‘ keys to set the correct time of d...

Page 8 - Adjusting the Beep Volume; Press the central timer key to set the volume.; Oven Accessories; Removing the Shelf; The shelf guard should be at the back pointing upwards.

6 The oven will beep when it stops cooking. To stop the beeper when it sounds, press any of the clock buttons. Adjusting the Beep Volume To adjust the beep volume, press the ‘+’ and ‘–‘ keys simultaneously, then press and hold the central timer button until ‘ton 1’ ﬂashes in the display (Fig.2-9). P...

Page 9 - Tips on Cooking with the Timer; DO NOT place warm food in the oven to be timed.; General Oven Tips; ‘Cleaning Your Cooker’

7 Tips on Cooking with the Timer If you want to cook more than one dish, choose dishes that require approximately the same cooking time. However, dishes can be ‘slowed down’ slightly by using small containers and covering them with aluminium foil, or ‘speeded up’ slightly by cooking smaller quantiti...

Page 11 - Removing the Oven Door; Grill

9 �� Essential Information Allow the oven to cool and isolate the electricity supply before carrying out any thorough cleaning. Never use paint solvents, washing soda, caustic cleaners, biological powders, bleach, chlorin...

Page 12 - Oven; Removing the Oven Shelf Supports

10 Oven  DO NOT use steel wool, oven cleaning pads, or any other materials that will scratch the surface. Removing the Oven Shelf Supports The oven shelf supports can be easily removed for cleaning. First remove the all of the oven shelves and the grill pan. Squeeze the two lower wires of the oven ...

Page 14 - Dear Installer; The oven is supplied with the following parts:

12 INSTALLATION Check the appliance is electrically safe when you have ﬁnished. Dear Installer Before you start your installation, please complete the details BELOW. If your customer has a problem relating to your installation they will be able to contact you easily. You must be aware of the followi...

Page 15 - Positioning the Oven; Provision for Ventilation

13 INSTALLATION Check the appliance is electrically safe when you have ﬁ nished. Positioning the Oven The oven can be installed at high level in a tall kitchen unit and is designed to ﬁ t into a standard 600mm wide oven housing (Fig.7-1). The oven is 594mm across the trims and an unrestricted openin...

Page 16 - Electrical Connection; WARNING: THIS APPLIANCE MUST BE EARTHED; Current Operated Earth Leakage Breakers; Levelling

14 INSTALLATION Check the appliance is electrically safe when you have ﬁnished. Electrical Connection This appliance must be installed by a qualiﬁed electrician to comply with the relevant Institute of Electrical Engineers (I.E.E.) regulations and also the local electricity supply company requiremen...

Page 18 - Small

16 9. Technical Data INSTALLER: Please leave these instructions with the user.DATA BADGE LOCATION: Back of the oven.COUNTRY OF DESTINATION: GB/IE Dimensions Overall height 888 mm Overall width 594 mm Overall depth 540 mm Connections Electric 220 – 240V 50Hz Ratings Oven Top oven Main oven Energy eﬃc...