Polycom Version 2.0.3B - Manuals

Page 2 - Notices

Copyright © 2007 Polycom, Inc. All rights reserved. Notices 1. Specifications subject to change without notice. Polycom, Inc. 1565 Barber Lane, Milpitas CA 95035, USA www.polycom.com Part Number: 1725-11530-210 Rev A

Page 3 - Addendum; Added or Changed Features; The SoundPoint IP 650 phones are full-duplex speakerphones.; Note; Attribute

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 1 1Addendum This addendum addresses changes to the SoundPoint IP / SoundStation IP SIP 2.0 Administrator’s Guide made by the release of the SoundPoint IP 650 phone. The SoundPoint IP 650 phone behaves...

Page 4 - Important

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum 2 Copyright © 2006 Polycom, Inc. 1.1.3 LCD Backlight Backlight intensity on the SoundPoint IP 650 phone has three modes: • Backlight On• Backlight Idle• Dim You can modify the Backlight On intensity and the Backlight Idle intensity...

Page 5 - Expanded Memory and Expanded Flash Memory; Changes can be found in the following parameters in the

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 3 1.1.4 Expanded Memory and Expanded Flash Memory Changes can be found in the following parameters in the sip.cfg configuration file: • Directory <dir/> • Provisioning <prov/> Attribute Pe...

Page 6 - ramdisk.bytesPerBlock

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum 4 Copyright © 2006 Polycom, Inc. • RAM Disk <ramdisk/> • Finder <finder/> Attribute Permitted Values Default Interpretation ramdisk.bytesPerBlock 0, 32, 33, ..., 1024 0 These three parameters use internal defaults when ...

Page 7 - MicroBrowser parameter changes in the; positive integer

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 5 1.1.5 MicroBrowser The SoundPoint IP 650 phones support an XHTML microbrowser. This can be launched by pressing the Services key. MicroBrowser parameter changes in the sip.cfg configuration file are...

Page 8 - The SoundPoint IP 650 supports the G.722 audio codec.

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum 6 Copyright © 2006 Polycom, Inc. 1.1.6 G.722 Audio Codec The SoundPoint IP 650 supports the G.722 audio codec. Changes can be found in the following parameters in the sip.cfg configuration file: • Codec Preferences <codecPref/&g...

Page 11 - USB port parameters can be found in the USB parameter in the

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 9 1.1.7 USB Diagnostics The SoundPoint IP 650 phone has a USB port, which will be supported by future releases of the SIP application. USB port parameters can be found in the USB <usb/> paramete...

Page 13 - Addendum; Added or Changed Features; Dial

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 1 2 Addendum This addendum addresses changes to the SoundPoint IP / SoundStation IP SIP 2.0 Administrator’s Guide made by the release of the SIP 2.1 application. For more information, refer to the Rel...

Page 14 - Server Fallback Enhancements on SoundPoint; key, or through the; Menu; ing; Services; Supported Platforms

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum 2 Copyright © 2006 Polycom, Inc. 2.1.4 Server Redundancy Server redundancy enhancements provides backup to other SIP server(s) by providing basic registration and redirection services. Refer to the “Technical Bulletin 5844: SIP Ser...

Page 15 - Disable Message Waiting Indicator by; • Changes can be found in the following parameters in the

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 3 2.1.6 Disable Message Waiting Indicator by Registration The SIP application has been enhanced to allow the message waiting indicator to be disabled by registration. • Changes can be found in the fol...

Page 17 - Platform

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 5 2.1.8 Configurable Feature Keys It has been determined that only some feature keys can be disabled. The exact feature keys that can be “null”-ified are platform-dependent. : tcpIpApp.sntp.daylightSa...

Page 18 - Miscellaneous Configuration File Changes; The following changes have also occurred in the

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum 6 Copyright © 2006 Polycom, Inc. 2.1.9 Miscellaneous Configuration File Changes 2.1.9.1 sip.cfg The following changes have also occurred in the sip.cfg configuration file: Attribute Permitted Values Default Interpretation voIpProt....

Page 20 - New Call

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum 8 Copyright © 2006 Polycom, Inc. voIpProt.SIP.outboundProxy.transport DNSnaptr or TCPpre-ferred or UDPOnly or TLS or TCPOnly DNSnaptr If set to Null or DNSnaptr: If voIpProt.SIP.outbound-Proxy.address is a host-name and voIpProt.SI...

Page 21 - The following changes has also occurred in the; New

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum Copyright © 2006 Polycom, Inc. 9 2.1.9.2 phone1.cfg The following changes has also occurred in the phone1.cfg configuration file: call.stickyAutoLineSeize.onHookDialing Null, 0, 1 Null If call.stickyAutoLineSeize is set to 1, this ...

Page 22 - device

Administrator’s Guide - SoundPoint ® IP / SoundStation ® IP Addendum 10 Copyright © 2006 Polycom, Inc. 2.1.9.3 device Parameter The following changes has also occurred in the device parameter: Attribute Permitted Values Default Interpretation device.prov.redunAttemptLimit 10, Null 10 Refer to the Fi...

Page 23 - Introduction; Send; Configuration File Changes

<December, 2006> 3725-17471-001/A Technical Bulletin 11572 Changes to Local Digit Maps on SoundPoint ® IP Phones This technical bulletin provides detailed information on how to modify the configuration files to automate the setup phase of number-only calls. This information applies to SoundPoi...

Page 24 - Dial Plan in Application Configuration File

Technical BulletinSoundPoint ® IP, SIP 2.1 2 Dial Plan in Application Configuration File The <dialplan/> attribute is described below and also includes: • Digit Map <digitmap/> on page 3 . This configuration attribute is defined as follows: Local Web Server (if enabled) Specify impossibl...

Page 26 - Dial Plan in Per-Phone Configuration File

Technical BulletinSoundPoint ® IP, SIP 2.1 4 The following guidelines should be noted: • You must use only *, #, or 0-9 between second and third R • If a digit map does not comply, it is not included in the digit plan as a valid one. That is, no matching is done against it. • There is no limitation ...

Page 29 - Trademark Information

Technical BulletinSoundPoint ® IP, SIP 2.1 7 Trademark Information Polycom ® , SoundPoint ® , and the Polycom logo design are registered trademarks of Polycom, Inc. in the U.S. and various countries. All other trademarks are the property of their respective companies. dialplan.x.digitmap.timeOut str...

Page 30 - Billing Code Entr y; To enter a billing code when placing a call:

<December, 2006> 3725-17483-001/A Technical Bulletin 9268 Billing Code Entry on SoundPoint ® IP Phones with Sylantro This technical bulletin provides detailed information on how the SIP application has been modified for billing code entry when managed by a Sylantro call server. This informatio...

Page 33 - Network Configuration Changes; To access the Syslog menu:; Down; Syslog Menu

Technical BulletinSoundPoint ® IP, SIP 2.1 2 Network Configuration Changes The Network Configuration menu on the SoundPoint IP phone running SIP 2.1 has been modified to include: • Syslog Menu To access the Syslog menu: 1. From the idle display on a SoundPoint IP phone, press the Menu key. 2. Using ...

Page 34 - Flash Parameter Configuration

Technical BulletinSoundPoint ® IP, SIP 2.1 3 Flash Parameter Configuration The global device parameter has been modified to include the following: Trademark Information Polycom®, SoundPoint®, and the Polycom logo design are registered trademarks of Polycom, Inc. in the U.S. and various countries. Al...

Page 35 - • Fallback

<January, 2007> 3725-17472-001/A Technical Bulletin 5844 SIP Server Fallback Enhancements on SoundPoint ® IP Phones This technical bulletin provides detailed information on how the SIP application has been enhanced to support SIP server fallback. This information applies to SoundPoint IP phone...

Page 36 - Terminology; SIP Registrations

Technical BulletinSoundPoint ® IP, SIP 2.1 2 Terminology Before you read this document, it is important to understand certain terminology and become familiar with the server/registration configuration as described in the references listed in the References on page 8 . The behavior described in this ...

Page 37 - SIP 2.1 Ser ver Fallback Implementation; Example Deployment

Technical BulletinSoundPoint ® IP, SIP 2.1 3 SIP 2.1 Ser ver Fallback Implementation In the SIP 2.1 release, the redundancy behavior of Polycom SoundPoint IP and SoundStation IP phones has been changed and improved by adding the ability for a single SIP Registration (Line) to be registered to more t...

Page 38 - Phone Configuration; Phone Operation for Registration

Technical BulletinSoundPoint ® IP, SIP 2.1 4 Phone Configuration The phones at the customer site are configured as follows: • Server 1 (the primary server) will be configured with the address of the service provider call server. The IP address of the server(s) to be used will be provided by the DNS ...

Page 39 - Behavior When the Primar y Ser ver Connection Fails; For Incoming Calls (Incoming Call Fallback)

Technical BulletinSoundPoint ® IP, SIP 2.1 5 Behavior When the Primar y Ser ver Connection Fails For Outgoing Calls (INVITE Fallback) When the user initiates a call, the phone will go through the following steps to connect the call: 1. Try to make the call using the working server. 2. If the working...

Page 40 - Changes From Previous Phone Behavior (Releases Before SIP 2.1); Recommended Practices for Ser ver Fallback Deployments

Technical BulletinSoundPoint ® IP, SIP 2.1 6 Changes From Previous Phone Behavior (Releases Before SIP 2.1) Recommended Practices for Ser ver Fallback Deployments The best method for ensuring optimum server redundancy is to deploy two identical call servers and use either DNS methods or “IP Address ...

Page 41 - Protocol in Application Configuration File

Technical BulletinSoundPoint ® IP, SIP 2.1 7 2. Do not use OutBoundProxy configurations on the phone if the OutBoundProxy could be unreachable when the fallback occurs. SoundPoint IP phones can only be configured with one OutBoundProxy per registration and all traffic for that registration will be r...

Page 42 - Registration in Per-Phone Configuration File

Technical BulletinSoundPoint ® IP, SIP 2.1 8 Registration in Per-Phone Configuration File Per-registration configuration is supported. The <registration/> attribute now includes: References 1. SIP 2.0 Administrator’s Guide for the SoundPoint IP and SoundStation IP Phones, August 2006. Go to ht...