Polycom KIRK ISDN - Manuals

Page 2 - Documents; KIRK ISDN Interface Card Installation Guide; Software; Administration Software for ISDN IWU

1. Introduction As alternative to the analogue interface to the PBX from the KIRK telecom solutions, the interface can now be digital according to the ISDN standard. Note: For more information about the PBX setup, please contact your local PBX installer. The 2 Mbps KIRK ISDN Interface Card performs ...

Page 3 - Setting up the KIRK ISDN Interface Card; Master whit Layer2 CRC check turned on; Changing Impedance of the KIRK ISDN Interface Card; If your PBX/Network is using a different impedance than 120; Impedance JP1

14129600-HD, Ed.008/ Page 3 2. Setting up the KIRK ISDN Interface Card The KIRK ISDN Interface Card must be installed in Slot 0 (closest to AC main plug). Please refer to the KIRK ISDN Interface Card Installation Guide for more information about the installation of the KIRK ISDN Interface Card. The ...

Page 4 - Preparing the KIRK Wireless Server 1500 for Use; The Administration Program window appears.; Options

Preparing the KIRK Wireless Server 1500 for Use When preparing the KIRK Wireless Server 1500 for use it is necessary to use the Administration Program. In the Administration Program you change the flash software, register users, allow subscription of handsets and type the required pin code. 1 Open t...

Page 7 - Configuring the ISDN IWU.; Setting up the connection

14129600-HD, Ed.008/ Page 7 Configuring the ISDN IWU. To change setting or upgrade the protocol software you use the administration software for the ISDN IWU. If not already installed, download the software from www.kirktelecom.com. 2.2 Setting up the connection 1 Connect the PC to the KIRK ISDN Int...

Page 8 - Uploading new flash software to the ISDN IWU card.

14129600-HD, Ed.008/ Page 8 2 Click File>setup connection . Click Disconnect and Select the correct comport. Click Connect and Close . Note the “Receive – success” message on the status bar. 2.3 Uploading new flash software to the ISDN IWU card. 3 Click Advanced and select Load Flash . An Flashlo...

Page 9 - Changing parameters and using feature.; Call forward and Call forward reply timer.

14129600-HD, Ed.008/ Page 9 2.4 Changing parameters and using feature. When opening the administration software the program will with the Function Commands tab selected. Here it is possible to enable or disable a list of features. 1. Call forward and Call forward reply timer. It is possible to activ...

Page 10 - FORWARD NUMBER; and type the wanted call forward

2. how to activate call forward. 1. Press the menu button on the handset and select EXT. SERVICE 2. Select CALL DIVERS. and select the wanted type of call forward. 3. Select FORWARD NUMBER and type the wanted call forward destination number. 3. How to deactivate call forward. 1. Press the menu butto...

Page 11 - Debugging and how to Make a Trace; Protocol debug; tab go to the; Debug; menu and select; Start Log

14129600-HD, Ed.008/ Page 11 10. EEprom Key Param. This setting defines if it should be possible to transfer key information during connect. Normally this should be possible to be able to use phone banking and other dial-inn services. Under normal operations it does not cause any problems enabling b...

Page 12 - tab before shutting down the administration software.

14129600-HD, Ed.008/ Page 12 the function that causes problems and try to do this in a situation where there is no other traffic on the system. Send the mail to KIRK. Remember to disable the trace information in the Protocol debug tab before shutting down the administration software.