Polycom 4400 - Manuals - manualsarea.com

Page 3 - Introduction; Certified Product Summary

Cisco: 4400 Series WLC, WiSM and 3750G Integrated WLC with 1100 and 1200 Series APs Introduction Polycom's Voice Interoperability for Enterprise Wireless (VIEW) Certification Program is designed to ensure interoperability and high performance between SpectraLink Wireless Telephones and Wireless LAN ...

Page 4 - Known Limitations; Access Point Capacity and Positioning

Configuration Guide Known Limitations • Wi-Fi Multimedia ( WMM ) must be disabled in order for SpectraLink Wireless Telephones to work properly. • Heavy multicast, broadcast, or push-to-talk ( PTT ) traffic may impair voice quality. • The Cisco 1000 series APs are not VIEW Certified at this time. • ...

Page 5 - Network Topology

Cisco: 4400 Series WLC, WiSM and 3750G Integrated WLC with 1100 and 1200 Series APs Network Topology The following configuration was tested during VIEW Certification. It is important to note that this configuration is not necessarily applicable to all customer environments. SpectraLink 8000 Wireless...

Page 7 - Connecting to the Controller via a Browser

Cisco: 4400 Series WLC, WiSM and 3750G Integrated WLC with 1100 and 1200 Series APs Connecting to the Controller via a Browser 1. Connect to the WLC by pointing your internet browser to the URL: https<IP_Addr> (where <IP_Addr> is the IP address of the management interface of the WLC). 2....

Page 8 - Installing Software

Configuration Guide Installing Software 1. Make sure that the VIEW Certified version of software is installed on the controller. From the main menu, click Monitor . 2. In the navigation pane, click Summary. The heading labeled Software Version shows the current software version. 3. Download the appr...

Page 9 - Controller Setup

Cisco: 4400 Series WLC, WiSM and 3750G Integrated WLC with 1100 and 1200 Series APs Controller Setup The initial setup of the controller is shown below. The setup instructions outlined in this document are for the configuration shown in the diagram only. Your configuration may differ, and the approp...

Page 10 - Connecting APs

Configuration Guide Connecting APs As the APs are connected to the network, they should automatically find the controller via the LWAPP discovery algorithms. The Dynamic Host Configuration Protocol (DHCP) server will assign each AP an IP address. You can configure a DHCP server to run on a remote PC...

Page 12 - AP Configuration

Configuration Guide AP Configuration 1. Power-on and connect the APs to the network. Wait a few minutes for the APs to find the controller. 2. Verify the APs are associated to the WLC. 3. From the main menu, click Monitor. Configuration for SpectraLink Wireless Telephones running in 802.11b mode 1. ...

Page 20 - Setting Up the SSIDs; Setting up the voice SSID

Configuration Guide Setting Up the SSIDs It is required for voice and data to be on separate SSIDs to prioritize voice traffic. The voice SSID must be set to Platinum for Quality of Service (as shown in the screen shot below) and the data SSID must be set to Silver for Quality of Service . Setting u...

Page 23 - Further Assistance

Cisco: 4400 Series WLC, WiSM and 3750G Integrated WLC with 1100 and 1200 Series APs Further Assistance 1. An installation and configuration guide for the 4400 WLC can be found on Cisco’s website: http://www.cisco.com/en/US/docs/wireless/controller/5.0/configuration/guide/ccg50.html 2. To convert the...