Patton IM1/I4 - Manuals - manualsarea.com

Page 2 - The Model IM1/I4 generates and uses radio frequency energy, and

1.3 SERVICE All warranty and nonwarranty repairs must be returned freight pre- paid and insured to Patton Electronics. All returns must have a ReturnMaterials Authorization number on the outside of the shipping contain-er. This number may be obtained from Patton Electronics TechnicalSupport at: (301...

Page 3 - LAN; Figure 1. Typical Model IM1/I4 application

2.3 TYPICAL APPLICATION The Model IM1/I4 QuickConnect™ is designed to plug directly into the rear of a Patton Electronics baseband modem (e.g. Model1092A or 1095). The Model IM1/I4 is designed to be used as one of apair of units. Figure 1 (below) illustrates a typical Model IM1/I4 instal-lation. 22....

Page 4 - PPP OPERATIONAL BACKGROUND; Ethernet LAN

3.0 PPP OPERATIONAL BACKGROUND PPP is a protocol used for multi-plexed transport over a point- to-point link. PPP operates on all full duplex media, and is a sym-metric peer-to-peer protocol, which can be broken into three maincomponents: 1. A standard method to encapsulate datagrams overserial link...

Page 5 - Internal Clock Setting

33..00 C CO ON NFFIIG GU UR RA ATTIIO ON N The Model IM1/14 module plugs into Patton’s fiber and copper baseband modems to provide Ethernet LAN extension. The IM1/14has no switches or jumpers and does not need to be configured.However, factors such as type of medium, throughput across the linkand cl...

Page 6 - Installing the New QuickConnectTM Module; even pressure should be sufficient to seat the mod-; CONNECTING TO THE 10BASE-T ETHERNET PORT; Figure 5. 10BaseT RJ-45 Port Pin Description

4.1.2 Installing the New QuickConnect™ Module 1) Make sure the power switch on the base unit is off. Leave the power cord plugged into a grounded outlet to keep the unitgrounded. 2) Hold the module with the faceplate toward you and align the module with the guide slots in the rear panel of the base ...

Page 7 - Once the Model IM1/14 is installed, it should operate transparent-; OPERATING INSTRUCTIONS; In order to operate, the Model IM1/I4 must be installed in the base; The Model IM1/I4 interface card has been

4.3 CONNECTION TO THE LINE INTERFACE MEDIA Instructions for connecting the line interface media (twisted pair, or fiber optic cable) are contained within the base unit user manual.Please refer to the base unit manual for connection details. 4.4 CONNECTING TO AC OR DC POWER Instructions for connectin...

Page 8 - LED STATUS MONITORS; The Model IM1/I4 features two LEDs that monitor general operat-; Figure 6. Model IM1/I4 Panel Showing RJ45 Jacks and LEDs; SYS; Quick-Connect Interface Module

5.3 LED STATUS MONITORS The Model IM1/I4 features two LEDs that monitor general operat- ing status and the 10Base-T twisted pair link integrity. Figure 6 (below)shows the LEDs located directly beneath the RJ-45 jack. FollowingFigure 6 is a description of each LEDs function. SYS [Yellow] - Pulses on ...

Page 9 - Patton Electronics Company

15 APPENDIX A PATTON MODEL IM1/I4 SPECIFICATIONS LAN Connection: RJ-45, 10Base-T, 802.3 Ethernet Protocol: PPP (RFC 1661) with Bridging Control Protocol (RFC 1638) MAC Address Table Size: 4096 entries MAC Address Aging: MAC addresses deleted after 8 min-utes inactivity On-board Memory: 1 MB RAM; 128...