Patton 9130 - Manuals - manualsarea.com

Page 2 - OnSite Expansion Modules Quick Start Guide; on page 2; Unpacking and Installation; OnSite Series Administrator’s Reference; Figure 1; Installing the HD-E1 module; Read the safety information in the OnSite Series; User Manual; and; Administrator’s Reference Guide; thoroughly before installing and operat-; WARNING

2 OnSite Expansion Modules Quick Start Guide 1.0 Introduction This guide provides instructions for adding expansion modules to your Patton OnSite base system. Refer to the following sections for installation instructions for your specific module: • 2.0 “Model 9100 E1 Module” on page 2 • 3.0 “Model 9...

Page 3 - Cable Management; Note; Figure 2; Cable dressing for the HD-E1 module; CAUTION

OnSite Expansion Modules Quick Start Guide 3 2.2 Cable Management The HD-E1 module uses a future bus connector on the front panel and requires the use of cables with compatible plugs for access to the E1 signals. These cables are ordered separately from the module and need to be specified according ...

Page 4 - Unpacking and Installation; Figure 3; slots of a modular OS-10 Series platform.; Installing the DS3/E3 module

4 OnSite Expansion Modules Quick Start Guide 2.3 Getting Started After the module is securely installed to the chassis (using the mounted screws on the front panel), turn the power back on to the S1000 system. The STAT LED of the HD-E1 module turns on to a solid amber light for about ten seconds aft...

Page 5 - Unpacking and Installation

OnSite Expansion Modules Quick Start Guide 5 3.2 Getting Started The 3-port DS3/E3 module supports insertion into or removal from any available expansion slot on the modular OS1052 and OS1063 chassis while the system is powered on and carrying traffic. The following procedure applies to module inser...

Page 6 - Module Type; Optical

6 OnSite Expansion Modules Quick Start Guide 4.2 Getting Started The HD-ENET module supports insertion into or removal from any available expansion slot on the OS1052 and OS1063 chassis while the system is powered on and carrying traffic. The following procedure applies to module insertion into a sy...

Page 7 - Unpacking and Installation; OnSite Series Administrator’s Ref-; Installing the 2-port STM-1 optical interface module

OnSite Expansion Modules Quick Start Guide 7 5.1 Unpacking and Installation To install the 2-port STM-1 module, follow the procedures in Chapter 10 of the OnSite Series Administrator’s Ref- erence Guide . Figure 1 shows the alignment and insertion of the module into one of the available expansion sl...

Page 8 - Additional Information; For detailed instructions, refer to the; A.0 Customer and Technical Support; —answered within 1 business day; Copyright statement

8 OnSite Expansion Modules Quick Start Guide 6.0 Additional Information For detailed instructions, refer to the OnSite Series User Manual and the OnSite Series Administrator’s Reference Guide available online at www.patton.com/manuals/OS10xx.pdf and www.patton.com/manuals/ OS10xx-arg.pdf . A.0 Custo...