Oregon Scientific S402022H0/S402022K0 - Manuals

Page 2 - Table of Contents; Work

Table of Contents Page(s) Important Safety Information................................................................................................................. 1-6 Intended Use ......................................................................................................................

Page 3 - PERSONAL PROTECTIVE EQUIPMENT

WARNING: Read and thoroughly understand all instructions in this manual and on safety decals before assembling or operating this log splitter. Failure to do so may cause serious injury or death. Do not allow anyone to operate this log splitter who has not read this manual. As with all power equipmen...

Page 5 - GENERAL SAFETY; keep clothing and hair away from moving parts..; PREPARATION OF THE LOG; operation. Do not split logs greater than 26 inches in length.; WORK AREA; operate this log splitter on firm ground/earth.

GENERAL SAFETY ALWAYS keep the operator’s manual nearby for reference. Reread the manual periodically. ALWAYS establish a safety zone restricting bystanders to a 10 foot radius around the log splitter when log splitter is in operation. ALWAYS ensure that all operators are properly trained or have re...

Page 8 - TOWING SAFETY

IMPORTANT NOTE – (spark arrester): As a precautionary measure against possible flying sparks, always take a Class B fire extinguisher with you when operating this log splitter in dry areas. This log splitter is equipped with an internal combustion engine and should not be used on or near any unimpro...

Page 9 - DESCRIPTION; Tire and Wheel

ASSEMBLY INSTRUCTIONS NOTE: This log splitter was partially assembled at the factory. Refer to the drawing and parts list should it become necessary to disassemble the unit for repair or replacement of parts. STEP 1: Remove all the components from the shipping container.Inspect each piece for shippi...

Page 11 - Area of; DESCRPTION; fitting on the valve. See illustrations below.

STEP 7: Loosely attach the latch assembly (1) to the bottom side of the beam as shown in the diagram using the two 1/2” x 1-1/4” GR 5 hex cap bolts (4), the two 1/2” lock washers (3) and the two 1/2” hex nuts (2). Lower the beam onto the tongue. Center the latch assembly on the tongue and tighten ha...

Page 12 - REPLACEMENT PARTS

Page 10 ITEM NO. PART NO. DESCRIPTION QTY. 1 S400312B0 Tire and Wheel 2 2 O/L 3/4” Light Flat Washer 2 3 S17012000 3/4” Slotted Nut 2 4 O/L 1/8” x 1-1/2” Cotter Pin 2 5 S40033200 Hub Cap 2 O/L- Obtain locally. Common fasteners available through hard- ware and farm stores. WHEEL ASSEMBLY BREAKDOWN IT...

Page 13 - ENGINE/PUMP ASSEMBLY BREAKDOWN; BEAM ASSEMBLY BREAKDOWN

Page 11 ENGINE/PUMP ASSEMBLY BREAKDOWN BEAM ASSEMBLY BREAKDOWN ITEM NO. PART NO. DESCRIPTION QTY. 1 O/L 1/2” Hex Nut 1 2 O/L 1/2” Lock Washer 1 3 O/L 1/2” x 3-1/4” GR5 Bolt 1 4 S390118BC 4” x 24” Cylinder 1 5 S39032000 3/4” NPT x 3/4” Tube 1 6 S39034300 1/2” NPT Nipple 1 7 S39034600 1/2” Steel Tubin...

Page 14 - TONGUE ASSEMBLY BREAKDOWN; hardware and farm stores.

Page 12 TONGUE ASSEMBLY BREAKDOWN ITEM NO. PART NO. DESCRIPTION QTY. 1 O/L M10 x 1.5 x 120mm GR5 Bolt 2 2 O/L M10 x 1.5 Nylock Nut 2 3 O/L M10 Flat Washer 6 4 S40032300 Chain w/Hook 2 5 S40034600 Hitch Ball Assembly 1 6 S40127400 Ground Stand 1 7 S401215A0 Tongue 1 8 S9114-1 Retaining Ring 1 9 S9132...

Page 15 - THE; OPERATING INSTRUCTIONS; AND THE OPERATOR ZONE.

CAUTION: DO NOT START OR RUN THE ENGINE BEFORE ADDING OIL IN THE HYDRAULIC RESERVOIR AND OIL IN THE ENGINE. OPERATING INSTRUCTIONS WARNING: Read and thoroughly understand all instructions and safety information before operating this log splitter. Failure to do so may cause serious injury or death. D...

Page 16 - ENGINE OIL RECOMMENDATIONS (Kohler SH265)

To Stop the Engine 1) Move the throttle lever to the SLOW position. 2) Move the throttle lever to the STOP position. 3) Turn the fuel valve to the OFF position. STARTING INSTRUCTIONS (Kohler SH265)) Refer also to the Kohler Engine Operating and Maintenance Instructions manual for your log splitter. ...

Page 17 - FLOODING THE ENGINE.; OPERATION; recommended personal protective equipment described on page 1.; TOWING

CAUTION: NOTE: The engine maximum governed speed is preset at the factory at 3600 RPM no load speed. When splitting wood the throttle should be set at the maximum speed to develop the horsepower required for the pump. TURN FUEL SHUT OFF VALVE TO THE “OFF” POSITION PRIOR TO TOWING.FAILURE TO DO SO MA...

Page 18 - Log Splitter Accessories; Log Catcher

Log Splitter Accessories Make your log splitter more productive with these optional accessories! S40200600 Log Catcher Bolts onto side of the log splitter beam in minutes. Saves time. Saves your back. Holds the split log off to the side until you are ready to quarter it. No more bending over to pick...

Page 19 - NOTES; IMPORTANT NOTICE; nearest service center.

NOTES Model No. ____________________ Serial No. _____________________________ Date of Purchase _______________ Place of Purchase _______________________ _______________________ _______________________ _______________________ IMPORTANT NOTICE We, the manufacturer, reserve the right to change the prod...

Page 20 - SPECIFICATIONS; AA

SPECIFICATIONS AA Oregon Products 15000 W. 44th Ave. Golden, CO 80403 Toll Free USA 800-525-8322 www.oregonproducts.com Engine Honda GC190 or Kohler SH265 Pump Two-Stage, 11 gpm Cylinder 4 in. Diameter x 24 in. Stroke Valve Auto-Return Maximum Splitting Force 22 Tons* Maximum Log Length 26 in. Cycle...