Makita 9566CV - Manuals - manualsarea.com

Page 2 - SPECIFICATIONS; GENERAL SAFETY RULES; Read and understand all instructions.; Failure to follow all; SAVE THESE INSTRUCTIONS

2 SPECIFICATIONS • Manufacturer reserves the right to change specifications without notice. • Specifications may differ from country to country. GENERAL SAFETY RULES USA002-2 (For All Tools) WARNING: Read and understand all instructions. Failure to follow all instructions listed below, may result in...

Page 4 - SPECIFIC SAFETY RULES

4 USE PROPER EXTENSION CORD: Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current yourproduct will draw. An undersized cord will cause a drop in line voltage resulting in loss ofpower and overheating. Table 1 shows the...

Page 7 - ASSEMBLY

7 Speed adjusting dial The rotating speed can be changed by turning the speedadjusting dial to a given number setting from 1 to 5.Higher speed is obtained when the dial is turned in the direc-tion of number 5. And lower speed is obtained when it isturned in the direction of number 1.Refer to the tab...

Page 8 - Installing or removing wheel guard

8 Installing or removing wheel guard CAUTION: • When using a depressed center grinding wheel/Multi-disc, flex wheel, wire wheel brush or cut-off wheel, thewheel guard must be fitted on the tool so that the closedside of the guard always points toward the operator. Loosen the lever on the wheel guard...

Page 9 - OPERATION

9 Installing or removing abrasive disc (optional accessory) NOTE: • Use sander accessories specified in this manual. Thesemust be purchased separately. Mount the rubber pad onto the spindle. Fit the disc on therubber pad and screw the lock nut onto the spindle. Totighten the lock nut, press the shaf...

Page 10 - Grinding and sanding operation

10 CAUTION: • After operation, always switch off the tool and wait untilthe wheel has come to a complete stop before puttingthe tool down. Grinding and sanding operation ALWAYS hold the tool firmly with one hand on housing andthe other on the side handle. Turn the tool on and then applythe wheel or ...

Page 14 - MAIL THIS PORTION; Your answers to the following questions are appreciated.; Please return this portion by facsimile or mail.

14 1. This product was purchased from: Home Center Hardware/Lumber Store Tool Distributor Industrial Supply Construction Supply Other ( ) 3. How did you learn about this product: Magazine From Dealer Newspaper Store Display Catalog Radio Exhibition From Friend Previous Usage Other ( ) 2. Use of the ...

Page 15 - FACTORY SERVICE CENTERS; RETAIN THIS PORTION FOR YOUR RECORDS

15 FACTORY SERVICE CENTERS 1-800-4-MAKITA RETAIN THIS PORTION FOR YOUR RECORDS ALABAMA 2365 Pelham ParkwayPelham, AL 35124 (205) 620-1791 ARIZONA 3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850 ARKANSAS Shackleford Shopping Center 240 South Shackleford Rd., Ste. C Little Rock, AR 72211...

Page 16 - WARNING; MAKITA LIMITED ONE YEAR WARRANTY; Warranty Policy; Makita Corporation

WARNING Some dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Californiato cause cancer, birth defects or other reproductive harm. Some examplesof these chemicals are:• lead from lead-based paints, • crystalline sili...