KOBE CH9148SQB - Manuals

3 COMPONENTS OF PACKAGE ( M u s t k e e p a ll m a t e r ia l f o r re t u r n s o r r e f u n d s ) RANGE HOOD BOX ORIGINAL KIT – Model No. RA1020DC (Sold Separately)  KOBE Range Hood - 1  Warranty Registration Card - 1  Instructions Manual - 1  Baffle Filter - 2 (for 30”, 36”, 42” hood) - 3 (f...

4 INSTALLATION PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING Calculation before Installation Calculate the length of the installation, before installing the hood. (All calculation is measure in inches.) - FOR UNDER THE CABINET - TABLE 1 A = Height of Floor to Ceiling B = Height of Floor to Count...

5 S A F E T Y W A R N I N G HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING. NOTE: BE CAREFUL WHEN USING ELECTRICAL SCREWDRIVER, DAMAGE TO THE HOOD MAY OCCUR. Installation Contents Under the Cabinet .............

6 UNDER THE CABINET INSTALLATION Preparation before Installation NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.  Decide the location of the venting pipe from the hood to the outside. Refer to Figure 1.  A straight, short venting run will allow the hood to perfor...

7 Ductwork Installation 5. Use aluminum or steel pipe to connect the 6” round plastic exhaust on the hood to the ductwork above. Use duct tape to make all joints secure and air tight. Refer to Figure 4. 6. To convert ductwork to 7” round, attached 7” round adapter (provided) to the 6” round plastic ...

8 STAND ALONE INSTALLATION ***This installation only applied with the purchase of a duct cover (Model No. RA1020DC). Preparation before Installation NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.  Decide the location of the venting pipe from the hood to the outsi...

9 mounting screws (not provided) on the wall, leaving 1/8” away from the wall. 2. Align hood-mounting bracket to the screws on the wall and hook hood into place as shown in Figure 11. Tighten screws to secure hood to the wall. 3. For safety purposes, extra knockout holes on the back of the hood are ...

14 MEASUREMENTS & DIAGRAMS  All measurements in ( ) are millimeters.  All inch measurements are converted from millimeters. Inch measurements are estimated. - FOR UNDER THE CABINET - - FOR STAND ALONE (WITH OPTIONAL DUCT COVER) - ***Hood-Mounting Bracket ***Duct Cover-Mounting Bracket MODEL NO...

22 DISCLAIMER 1. CAREFULLY INSPECT ALL ITEMS FOR DAMAGES BEFORE ACCEPTING DELIVERY. NOTE ANY DAMAGES ON THE FREIGHT BILL OR EXPRESS RECEIPT. REQUEST NAME AND SIGNATURE OF THE CARRIER’S AGENT AND KEEP COPY TO SUPPORT YOUR CLAIM. Upon acceptance of items, owner assumes responsibility for its safe arri...

24 traveling expenses and any costs of transporting the range hood or parts thereof to and from the dealer or Service Agent 4) The purchaser must produce proof of purchase together with this warranty certificate when making the claim. 5) Damages caused during shipment are not covered under our warra...

25 PRODUCT REGISTRATION Register Your Product! Any covered failure occurring within two years of original purchase arising from defective workmanship or material in manufacture will be repaired or at our option the unit will be replaced free of charge by an authorized KOBE Range Hoods Agent or KOBE ...