Honeywell THP2400A1080 - Manuals

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 6 Dimensions Fig. 2. Dimensions of T10 & T10+ thermostat in in. (mm). Fig. 3. Dimensions of C7189R2002 & C7189R3002 sensors in in. (mm). Fig. 4. Dimensions of THM04R3000 EIM in in. (mm). Fig. 5. Dimensions of C7089R3013 wirele...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 8 SYSTEM INSTALLATION When Installing This Product... 1. Read these instructions carefully. Failure to follow the instructions can damage the product or cause a hazardous condition. 2. Check the ratings given in the instructions to ma...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 9 33-00462—04 8. Snap the Cover Plate onto the Junction Box Adapter. See Step 8 in Fig. 11. NOTE: Cover plate included with T10 or T10+ can vary by model. Fig. 11. Wiring UWP NOTE: If T10+ & EIM are used, UWP only wires to R and C of a 24 VAC...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 10 Table 8. Terminals on THM04R3000 Equipment Interface Module (EIM) Used With T10+ Models Only. Setting Slider Tabs Set R Slider Tab, see Fig. 13. • Use built-in jumper (R Slider Tab) to differentiate between one or two transformer s...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 11 33-00462—04 WIRING Wiring at T10 or T10+ Without EIM NOTES: 1. Use 18- to 22- gauge thermostat wire. Shielded cable is not required. 2. Set the R Slider Tab on the UWP to the up posi-tion (1 wire) for 1 transformer systems or the down position...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 15 33-00462—04 Fig. 28. 3H/2C heat pump with electric aux heat. Fig. 29. Dual fuel 2H/1C heat pump. Whole house humidifier, dehumidifier, or ventilator wiring Using U Slider Tab Fig. 30. Wired to humidifier, dehumidifier, or ventilator with built...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 17 33-00462—04 EIM Wiring Diagrams Fig. 35. Typical wiring of a conventional system with up to 3 stage heat and 2 stage cool with one transformer. RC U3U3 U2 U2 U1 S2S2 S1 S1 S4S4 S3 S3 THM04R3000 U1 Y2G L W 1 W 2 AUX1 W 3 AUX2 Y1 RH RCR C SENSOR...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 19 33-00462—04 Fig. 37. Typical wiring of a heat pump system with boiler back up. Fig. 38. Typical wiring of a heat pump system with a zone valve for back up heat. R C AUX1AUX2 24 VAC TO THERMOSTAT THM04R3000 Y2 G L W1 W2 W3 Y1 RH RCR C 24 VAC PO...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 25 33-00462—04 12. Follow the onscreen display instructions to complete system setup for heating and cooling type, humidi-fier, dehumidifier, ventilator settings, etc. Fig. 51. To Replace the Equipment Interface Module (EIM) When you replace an E...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 26 7. Adhere the included command strip to the wall-plate. Then adhere the sensor to the wall. Level sen-sor for appearance. (See the sensor instructions for proper placement.) Fig. 56. Placement Tips • DO place about 5 feet above the...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 27 33-00462—04 Mount Outdoor Sensor 1. Mount the sensor on a vertical exterior wall, at least 6 inches below any overhang. Choose a location pro-tected from direct sunlight. Fig. 60. 2. Place sensor securely in bracket, facing away. Fig. 61. Sele...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 29 33-00462—04 Fig. 67. Mounting Discharge/Return Air Sensor. Installing Wired Indoor Sensor C7189U1005 (10K) Wired Indoor Sensor ISU setting 5000. Use the following steps to mount the sensor: 1. Remove the cover from the remote sensor. See Fig. ...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 30 Do not mount the sensor:• In direct sunlight.• Where hot or cold air blows on the sensor. Discharge line from an outdoor compressor unit, vent or fan causes inaccurate temperature readings. • Where snow, ice or debris can cover it....

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 31 33-00462—04 Recommended Floor Temperatures Settings Recommended maximum floor temperature is 90 °F (32 °C) for most floor covering types except wood. Suggested maximum floor temperature for wood floor is 85 °F (29.5 °C). Freeze protection temp...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 41 33-00462—04 WIFI SETUP During the initial installation, after the Installer setup the thermostat will prompt you to set up WiFi and guide you through the steps. if you are setting up WiFi after the initial installation has already been done, f...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 42 No IP Address The thermostat was unable to obtain an IP address from the router. Verify the router is correctly set up to automatically assign IP addresses. This connection can take several minutes. If there is still no connection,...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 43 33-00462—04 Fig. 82. • Touch Time to edit the time for that schedule period. • Touch Priority to select which sensors will be used for that period. • Touch Temperature to set the heat and cool setpoints for that period. • Touch Fan to select f...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 44 If you manually change the temperature when location-based temperature control is active, the new temperature will remain in effect until you cross the geofence. To adjust the geofence boundary, follow the steps below. 1. Open the ...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 45 33-00462—04 Schedule • Create new schedule – (Set a time-based schedule)• Disable schedule• Reset to default Schedule NOTE: To enable geofencing, use the Resideo app. Weather Shown if connected to Wi Fi/App, & ISU 1060 = Internet, displays...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 46 Installer Options To access the Installer options menu: 1. Touch the Menu icon (3 horizontal lines at bottom of display) 2. Scroll down and touch Thermostat Information . 3. Write down the date code from that screen. Then touch the...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 47 33-00462—04 Whole-Home Range With a 200-foot range, 20 sensors with temperature, humidity, and occupancy detection can connect to your thermostat from throughout your home. Know Your Home Is Safe Get customizable alerts on your mobile device w...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 48 Setting the Time/Date When the thermostat is linked to the home WiFi router and registered to an account using the Resideo app, the date and time will update automatically. If not using WiFi you can set the time/date as follows: 1....

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 49 33-00462—04 Using Priority Priority creates an average temperature in your home based on specific rooms. This allows you to prioritize comfort where you want it. Fig. 92. Selecting Sensors The temperature reading displayed on the home screen i...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 50 NOTE: Air Filter, Humidifier Pad, Dehumidifier Filter, and Ventilator Filter are displayed under Preferences even if they have not been set up. Humidifier Pad is not displayed if a steam humidifier has been installed. To access or ...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 51 33-00462—04 3. Select the system mode(s) to allow humidification (ISU 8060). Options are Heat and off. NOTE: Heat includes Heat, Emergency Heat and Auto. If the sys-tem is in Auto mode, the thermostat will allow humidification if the last call...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 52 Dehumidification Fan Speed Priority (T10+ Only. See ISU 9005) If the house has circulation issues to certain parts of the house when running in low speed, this feature will allow the thermostat to use the high speed fan more often ...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 53 33-00462—04 NOTE: If humidification and dehumidification are setup to operate in the same system mode (Off) the thermostat will automatically enforce a 15% deadband between the humidification and dehu-midification settings. The thermostat will...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 54 Control Ventilation Level 1. Touch MENU , and select Ventilation. You can check or change the ventilation mode.Mode:• Auto: Ventilation runs as programmed by the installer. • Off: Ventilation remains off unless turned on using the ...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 55 33-00462—04 Auto Changeover Operation Auto changeover is available if the thermostat is configured for at least 1 heat stage and 1 cool stage and ISU 3000 is set to “Auto”. When configured this way, you can select “Auto” as one of the options ...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 57 33-00462—04 Upstage Timer The upstage timer setting is only available when: The thermostat is configured for a heat pump with an aux heat stage (electric of fossil fuel). The droop setting is set to a setting other than “Comfort” (2 °F to 15 °...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 58 Fig. 96. Heat Pump and Backup Heat Operation. HEAT PUMP AND BACKUP HEAT OPERATION Heat pump with outdoor temperature lockouts Outdoor temperature lockouts are optional. See Installer Setup options (ISU 3120). HEAT PUMP ONLY BACKUP ...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 60 Battery Replacement Indoor Sensor BATTERY LEVEL INDICATORS • Good: Status light flashes green for 5 seconds.• Low: Status light flashes red for 5 seconds. Use fresh batteries.Battery level indicators (during use) • Good: Status lig...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 33-00462—04 62 Software and security questions Q: How can I be sure my thermostat is running the most up-to-date firmware?A: When your thermostat is connected to WiFi, it will automatically receive over-the-air firmware updates from the Resideo a...

T10 & T10+ PRO SMART THERMOSTAT WITH REDLINK® 3.0 © 2022 Resideo Technologies, Inc. All rights reserved.The Honeywell Home trademark is used under license from Honeywell International, Inc. This product is manufactured by Resideo Technologies, Inc. and its affiliates. www.resideo.com Resideo Tec...