Honeywell T8095A/191108AJ- Manuals

Setting the Clock ■ Lift thermostat flip-up cover to find the 24-hourprogram dial, slotted in 10-minute increments.Adjust the clock to the current time by movingthe minute hand carefully in a clockwisedirection. Do not reverse the minute hand. ■ After setting the time correctly, the TimeIndicator Ar...

also probably want to change the leverpositions. Setting the Heating Program: ■ Decide when you want the temperature toreach the comfort level. Find the notch on thedial that is one-half hour before this time andinsert a red pin. The high temperature is in effect. The half-hour head start period giv...

Press the button to immediately begin an energy savings period or return to the normalsetting. After pressing the button, check theprogram indicator on the thermostat cover toassure the system is in the desired mode. If theprogram indicator shows blue, the lower tempera-ture is in effect; if it show...

Voltage at Clock Terminals AC Voltage at C-C Terminals Check Action 0 Vac. — System power off. — Restore power. — Short in clock power supply wiring. — Replace wiring. — Limit switch contacts stuck open. — Free or replace limit switch. — Transformer supplying power is — Replace transformer. burned o...

Thermometer Adjustment The thermometer was accurately calibrated at the factory and should only need adjustment if itwas dropped or mishandled. If the setpoint lever and the thermometer reading do not agree, use the following procedure: 1. Remove thermostat cover and open the flip-up cover. 2. Set t...

26 27 69-0639—1 Limited One-Year Warranty Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and service, for a periodof one (1) year from the date of purchase by the consumer. If, at any time during the warranty period, the ...

Setting the Clock ■ Lift thermostat flip-up cover to find the 24-hourprogram dial, slotted in 10-minute increments.Adjust the clock to the current time by movingthe minute hand carefully in a clockwisedirection. Do not reverse the minute hand. ■ After setting the time correctly, the TimeIndicator Ar...

also probably want to change the leverpositions. Setting the Heating Program: ■ Decide when you want the temperature toreach the comfort level. Find the notch on thedial that is one-half hour before this time andinsert a red pin. The high temperature is in effect. The half-hour head start period giv...

Press the button to immediately begin an energy savings period or return to the normalsetting. After pressing the button, check theprogram indicator on the thermostat cover toassure the system is in the desired mode. If theprogram indicator shows blue, the lower tempera-ture is in effect; if it show...

Voltage at Clock Terminals AC Voltage at C-C Terminals Check Action 0 Vac. — System power off. — Restore power. — Short in clock power supply wiring. — Replace wiring. — Limit switch contacts stuck open. — Free or replace limit switch. — Transformer supplying power is — Replace transformer. burned o...

Thermometer Adjustment The thermometer was accurately calibrated at the factory and should only need adjustment if itwas dropped or mishandled. If the setpoint lever and the thermometer reading do not agree, use the following procedure: 1. Remove thermostat cover and open the flip-up cover. 2. Set t...

26 27 69-0639—1 Limited One-Year Warranty Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and service, for a periodof one (1) year from the date of purchase by the consumer. If, at any time during the warranty period, the ...